| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <cb517ab5-d65e-489d-960e-501d40a06fde@protonmail.com>
Date: Sun, 18 Jun 2023 18:05:21 +0000
From: Julian <juliannfairfax@...tonmail.com>
To: Ondřej Jirman <megi@....cz>,
linux-rockchip@...ts.infradead.org
Cc: Andrzej Hajda <andrzej.hajda@...el.com>,
Neil Armstrong <neil.armstrong@...aro.org>,
Robert Foss <rfoss@...nel.org>,
Laurent Pinchart <Laurent.pinchart@...asonboard.com>,
Jonas Karlman <jonas@...boo.se>,
Jernej Skrabec <jernej.skrabec@...il.com>,
David Airlie <airlied@...il.com>,
Daniel Vetter <daniel@...ll.ch>,
"open list:DRM DRIVERS" <dri-devel@...ts.freedesktop.org>,
open list <linux-kernel@...r.kernel.org>
Subject: Re: [PATCH] drm: bridge: dw-mipi-dsi: Fix enable/disable of DSI controller
Tested-by: Julian Fairfax
On 17.06.23 17:06, Ondřej Jirman wrote:
> From: Ondrej Jirman <megi@....cz>
>
> Before this patch, booting to Linux VT and doing a simple:
>
> echo 2 > /sys/class/graphics/fb0/blank
> echo 0 > /sys/class/graphics/fb0/blank
>
> would result in failures to re-enable the panel. Mode set callback is
> called only once during boot in this scenario, while calls to
> enable/disable callbacks are balanced afterwards. The driver doesn't
> work unless userspace calls modeset before enabling the CRTC/connector.
>
> This patch moves enabling of the DSI host from mode_set into pre_enable
> callback, and removes some old hacks where this bridge driver is
> directly calling into other bridge driver's callbacks.
>
> pre_enable_prev_first flag is set on the panel's bridge so that panel
> drivers will get their prepare function called between DSI host's
> pre_enable and enable callbacks, so that they get a chance to
> perform panel setup while DSI host is already enabled in command
> mode. Otherwise panel's prepare would be called before DSI host
> is enabled, and any DSI communication used in prepare callback
> would fail.
>
> With all these changes, the enable/disable sequence is now well
> balanced, and host's and panel's callbacks are called in proper order
> documented in the drm_panel API documentation without needing the old
> hacks. (Mainly that panel->prepare is called when DSI host is ready to
> allow the panel driver to send DSI commands and vice versa during
> disable.)
>
> Tested on Pinephone Pro. Trace of the callbacks follows.
>
> Before:
>
> [ 1.253882] dw-mipi-dsi-rockchip ff960000.dsi: mode_set
> [ 1.290732] panel-himax-hx8394 ff960000.dsi.0: prepare
> [ 1.475576] dw-mipi-dsi-rockchip ff960000.dsi: enable
> [ 1.475593] panel-himax-hx8394 ff960000.dsi.0: enable
>
> echo 2 > /sys/class/graphics/fb0/blank
>
> [ 13.722799] panel-himax-hx8394 ff960000.dsi.0: disable
> [ 13.774502] dw-mipi-dsi-rockchip ff960000.dsi: post_disable
> [ 13.774526] panel-himax-hx8394 ff960000.dsi.0: unprepare
>
> echo 0 > /sys/class/graphics/fb0/blank
>
> [ 17.735796] panel-himax-hx8394 ff960000.dsi.0: prepare
> [ 17.923522] dw-mipi-dsi-rockchip ff960000.dsi: enable
> [ 17.923540] panel-himax-hx8394 ff960000.dsi.0: enable
> [ 17.944330] dw-mipi-dsi-rockchip ff960000.dsi: failed to write command FIFO
> [ 17.944335] panel-himax-hx8394 ff960000.dsi.0: sending command 0xb9 failed: -110
> [ 17.944340] panel-himax-hx8394 ff960000.dsi.0: Panel init sequence failed: -110
>
> echo 2 > /sys/class/graphics/fb0/blank
>
> [ 431.148583] panel-himax-hx8394 ff960000.dsi.0: disable
> [ 431.169259] dw-mipi-dsi-rockchip ff960000.dsi: failed to write command FIFO
> [ 431.169268] panel-himax-hx8394 ff960000.dsi.0: Failed to enter sleep mode: -110
> [ 431.169282] dw-mipi-dsi-rockchip ff960000.dsi: post_disable
> [ 431.169316] panel-himax-hx8394 ff960000.dsi.0: unprepare
> [ 431.169357] pclk_mipi_dsi0 already disabled
>
> echo 0 > /sys/class/graphics/fb0/blank
>
> [ 432.796851] panel-himax-hx8394 ff960000.dsi.0: prepare
> [ 432.981537] dw-mipi-dsi-rockchip ff960000.dsi: enable
> [ 432.981568] panel-himax-hx8394 ff960000.dsi.0: enable
> [ 433.002290] dw-mipi-dsi-rockchip ff960000.dsi: failed to write command FIFO
> [ 433.002299] panel-himax-hx8394 ff960000.dsi.0: sending command 0xb9 failed: -110
> [ 433.002312] panel-himax-hx8394 ff960000.dsi.0: Panel init sequence failed: -110
>
> -----------------------------------------------------------------------
>
> After:
>
> [ 1.248372] dw-mipi-dsi-rockchip ff960000.dsi: mode_set
> [ 1.248704] dw-mipi-dsi-rockchip ff960000.dsi: pre_enable
> [ 1.285377] panel-himax-hx8394 ff960000.dsi.0: prepare
> [ 1.468392] dw-mipi-dsi-rockchip ff960000.dsi: enable
> [ 1.468421] panel-himax-hx8394 ff960000.dsi.0: enable
>
> echo 2 > /sys/class/graphics/fb0/blank
>
> [ 16.210357] panel-himax-hx8394 ff960000.dsi.0: disable
> [ 16.261315] dw-mipi-dsi-rockchip ff960000.dsi: post_disable
> [ 16.261339] panel-himax-hx8394 ff960000.dsi.0: unprepare
>
> echo 0 > /sys/class/graphics/fb0/blank
>
> [ 19.161453] dw-mipi-dsi-rockchip ff960000.dsi: pre_enable
> [ 19.197869] panel-himax-hx8394 ff960000.dsi.0: prepare
> [ 19.382141] dw-mipi-dsi-rockchip ff960000.dsi: enable
> [ 19.382158] panel-himax-hx8394 ff960000.dsi.0: enable
>
> Signed-off-by: Ondrej Jirman <megi@....cz>
> ---
> drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c | 28 +++++++++++--------
> 1 file changed, 16 insertions(+), 12 deletions(-)
>
> diff --git a/drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c b/drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c
> index b2efecf7d160..352c6829259a 100644
> --- a/drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c
> +++ b/drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c
> @@ -265,6 +265,7 @@ struct dw_mipi_dsi {
> struct dw_mipi_dsi *master; /* dual-dsi master ptr */
> struct dw_mipi_dsi *slave; /* dual-dsi slave ptr */
>
> + struct drm_display_mode mode;
> const struct dw_mipi_dsi_plat_data *plat_data;
> };
>
> @@ -332,6 +333,7 @@ static int dw_mipi_dsi_host_attach(struct mipi_dsi_host *host,
> if (IS_ERR(bridge))
> return PTR_ERR(bridge);
>
> + bridge->pre_enable_prev_first = true;
> dsi->panel_bridge = bridge;
>
> drm_bridge_add(&dsi->bridge);
> @@ -859,15 +861,6 @@ static void dw_mipi_dsi_bridge_post_atomic_disable(struct drm_bridge *bridge,
> */
> dw_mipi_dsi_set_mode(dsi, 0);
>
> - /*
> - * TODO Only way found to call panel-bridge post_disable &
> - * panel unprepare before the dsi "final" disable...
> - * This needs to be fixed in the drm_bridge framework and the API
> - * needs to be updated to manage our own call chains...
> - */
> - if (dsi->panel_bridge->funcs->post_disable)
> - dsi->panel_bridge->funcs->post_disable(dsi->panel_bridge);
> -
> if (phy_ops->power_off)
> phy_ops->power_off(dsi->plat_data->priv_data);
>
> @@ -942,15 +935,25 @@ static void dw_mipi_dsi_mode_set(struct dw_mipi_dsi *dsi,
> phy_ops->power_on(dsi->plat_data->priv_data);
> }
>
> +static void dw_mipi_dsi_bridge_atomic_pre_enable(struct drm_bridge *bridge,
> + struct drm_bridge_state *old_bridge_state)
> +{
> + struct dw_mipi_dsi *dsi = bridge_to_dsi(bridge);
> +
> + /* Power up the dsi ctl into a command mode */
> + dw_mipi_dsi_mode_set(dsi, &dsi->mode);
> + if (dsi->slave)
> + dw_mipi_dsi_mode_set(dsi->slave, &dsi->mode);
> +}
> +
> static void dw_mipi_dsi_bridge_mode_set(struct drm_bridge *bridge,
> const struct drm_display_mode *mode,
> const struct drm_display_mode *adjusted_mode)
> {
> struct dw_mipi_dsi *dsi = bridge_to_dsi(bridge);
>
> - dw_mipi_dsi_mode_set(dsi, adjusted_mode);
> - if (dsi->slave)
> - dw_mipi_dsi_mode_set(dsi->slave, adjusted_mode);
> + /* Store the display mode for later use in pre_enable callback */
> + memcpy(&dsi->mode, adjusted_mode, sizeof(dsi->mode));
> }
>
> static void dw_mipi_dsi_bridge_atomic_enable(struct drm_bridge *bridge,
> @@ -1004,6 +1007,7 @@ static const struct drm_bridge_funcs dw_mipi_dsi_bridge_funcs = {
> .atomic_duplicate_state = drm_atomic_helper_bridge_duplicate_state,
> .atomic_destroy_state = drm_atomic_helper_bridge_destroy_state,
> .atomic_reset = drm_atomic_helper_bridge_reset,
> + .atomic_pre_enable = dw_mipi_dsi_bridge_atomic_pre_enable,
> .atomic_enable = dw_mipi_dsi_bridge_atomic_enable,
> .atomic_post_disable = dw_mipi_dsi_bridge_post_atomic_disable,
> .mode_set = dw_mipi_dsi_bridge_mode_set,
Powered by blists - more mailing lists