| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Date: Wed, 21 Jun 2023 21:12:56 +0200
From: Pawel Dembicki <paweldembicki@...il.com>
To: netdev@...r.kernel.org
Cc: linus.walleij@...aro.org, Pawel Dembicki <paweldembicki@...il.com>,
Andrew Lunn <andrew@...n.ch>,
Florian Fainelli <f.fainelli@...il.com>,
Vladimir Oltean <olteanv@...il.com>,
"David S. Miller" <davem@...emloft.net>,
Eric Dumazet <edumazet@...gle.com>,
Jakub Kicinski <kuba@...nel.org>,
Paolo Abeni <pabeni@...hat.com>,
Russell King <linux@...linux.org.uk>,
linux-kernel@...r.kernel.org
Subject: [PATCH net-next 1/6] net: dsa: vsc73xx: convert to PHYLINK
This patch replaces the adjust_link api with the phylink apis that provide
equivalent functionality.
The remaining functionality from the adjust_link is now covered in the
phylink_mac_link_* and phylink_mac_config.
Removes:
.adjust_link
Adds:
.phylink_get_caps
.phylink_mac_link_down
.phylink_mac_link_up
.phylink_mac_link_down
Signed-off-by: Pawel Dembicki <paweldembicki@...il.com>
---
drivers/net/dsa/vitesse-vsc73xx-core.c | 179 ++++++++++++++-----------
1 file changed, 99 insertions(+), 80 deletions(-)
diff --git a/drivers/net/dsa/vitesse-vsc73xx-core.c b/drivers/net/dsa/vitesse-vsc73xx-core.c
index ae55167ce0a6..e853b57b0bc8 100644
--- a/drivers/net/dsa/vitesse-vsc73xx-core.c
+++ b/drivers/net/dsa/vitesse-vsc73xx-core.c
@@ -39,6 +39,7 @@
#define VSC73XX_BLOCK_SYSTEM 0x7 /* Only subblock 0 */
#define CPU_PORT 6 /* CPU port */
+#define VSC73XX_TABLE_ATTEMPTS 10
/* MAC Block registers */
#define VSC73XX_MAC_CFG 0x00
@@ -715,8 +716,7 @@ static void vsc73xx_init_port(struct vsc73xx *vsc, int port)
}
static void vsc73xx_adjust_enable_port(struct vsc73xx *vsc,
- int port, struct phy_device *phydev,
- u32 initval)
+ int port, u32 initval)
{
u32 val = initval;
u8 seed;
@@ -754,12 +754,40 @@ static void vsc73xx_adjust_enable_port(struct vsc73xx *vsc,
VSC73XX_MAC_CFG_TX_EN | VSC73XX_MAC_CFG_RX_EN);
}
-static void vsc73xx_adjust_link(struct dsa_switch *ds, int port,
- struct phy_device *phydev)
+static void vsc73xx_phylink_get_caps(struct dsa_switch *ds, int port,
+ struct phylink_config *config)
{
- struct vsc73xx *vsc = ds->priv;
- u32 val;
+ /* This switch only supports full-duplex at 1Gbps */
+ config->mac_capabilities = MAC_10 | MAC_100 | MAC_1000FD |
+ MAC_ASYM_PAUSE | MAC_SYM_PAUSE;
+ if (port == CPU_PORT) {
+ __set_bit(PHY_INTERFACE_MODE_RGMII,
+ config->supported_interfaces);
+ __set_bit(PHY_INTERFACE_MODE_GMII,
+ config->supported_interfaces);
+ } else {
+ __set_bit(PHY_INTERFACE_MODE_INTERNAL,
+ config->supported_interfaces);
+ /* Compatibility for phylib's default interface type when the
+ * phy-mode property is absent
+ */
+ __set_bit(PHY_INTERFACE_MODE_GMII,
+ config->supported_interfaces);
+ }
+
+ /* This driver does not make use of the speed, duplex, pause or the
+ * advertisement in its mac_config, so it is safe to mark this driver
+ * as non-legacy.
+ */
+ config->legacy_pre_march2020 = false;
+}
+
+static void vsc73xx_phylink_mac_config(struct dsa_switch *ds, int port,
+ unsigned int mode,
+ const struct phylink_link_state *state)
+{
+ struct vsc73xx *vsc = ds->priv;
/* Special handling of the CPU-facing port */
if (port == CPU_PORT) {
/* Other ports are already initialized but not this one */
@@ -775,104 +803,92 @@ static void vsc73xx_adjust_link(struct dsa_switch *ds, int port,
VSC73XX_ADVPORTM_ENA_GTX |
VSC73XX_ADVPORTM_DDR_MODE);
}
+}
- /* This is the MAC confiuration that always need to happen
- * after a PHY or the CPU port comes up or down.
- */
- if (!phydev->link) {
- int maxloop = 10;
+static void vsc73xx_phylink_mac_link_down(struct dsa_switch *ds, int port,
+ unsigned int mode,
+ phy_interface_t interface)
+{
+ struct vsc73xx *vsc = ds->priv;
+ u32 val;
- dev_dbg(vsc->dev, "port %d: went down\n",
- port);
+ int maxloop = VSC73XX_TABLE_ATTEMPTS;
- /* Disable RX on this port */
- vsc73xx_update_bits(vsc, VSC73XX_BLOCK_MAC, port,
- VSC73XX_MAC_CFG,
- VSC73XX_MAC_CFG_RX_EN, 0);
+ dev_dbg(vsc->dev, "port %d: went down\n",
+ port);
- /* Discard packets */
- vsc73xx_update_bits(vsc, VSC73XX_BLOCK_ARBITER, 0,
- VSC73XX_ARBDISC, BIT(port), BIT(port));
+ /* Disable RX on this port */
+ vsc73xx_update_bits(vsc, VSC73XX_BLOCK_MAC, port,
+ VSC73XX_MAC_CFG,
+ VSC73XX_MAC_CFG_RX_EN, 0);
+
+ /* Discard packets */
+ vsc73xx_update_bits(vsc, VSC73XX_BLOCK_ARBITER, 0,
+ VSC73XX_ARBDISC, BIT(port), BIT(port));
- /* Wait until queue is empty */
+ /* Wait until queue is empty */
+ vsc73xx_read(vsc, VSC73XX_BLOCK_ARBITER, 0,
+ VSC73XX_ARBEMPTY, &val);
+ while (!(val & BIT(port))) {
+ msleep(1);
vsc73xx_read(vsc, VSC73XX_BLOCK_ARBITER, 0,
VSC73XX_ARBEMPTY, &val);
- while (!(val & BIT(port))) {
- msleep(1);
- vsc73xx_read(vsc, VSC73XX_BLOCK_ARBITER, 0,
- VSC73XX_ARBEMPTY, &val);
- if (--maxloop == 0) {
- dev_err(vsc->dev,
- "timeout waiting for block arbiter\n");
- /* Continue anyway */
- break;
- }
+ if (--maxloop == 0) {
+ dev_err(vsc->dev,
+ "timeout waiting for block arbiter\n");
+ /* Continue anyway */
+ break;
}
+ }
- /* Put this port into reset */
- vsc73xx_write(vsc, VSC73XX_BLOCK_MAC, port, VSC73XX_MAC_CFG,
- VSC73XX_MAC_CFG_RESET);
-
- /* Accept packets again */
- vsc73xx_update_bits(vsc, VSC73XX_BLOCK_ARBITER, 0,
- VSC73XX_ARBDISC, BIT(port), 0);
+ /* Put this port into reset */
+ vsc73xx_write(vsc, VSC73XX_BLOCK_MAC, port, VSC73XX_MAC_CFG,
+ VSC73XX_MAC_CFG_RESET);
- /* Allow backward dropping of frames from this port */
- vsc73xx_update_bits(vsc, VSC73XX_BLOCK_ARBITER, 0,
- VSC73XX_SBACKWDROP, BIT(port), BIT(port));
+ /* Accept packets again */
+ vsc73xx_update_bits(vsc, VSC73XX_BLOCK_ARBITER, 0,
+ VSC73XX_ARBDISC, BIT(port), 0);
- /* Receive mask (disable forwarding) */
- vsc73xx_update_bits(vsc, VSC73XX_BLOCK_ANALYZER, 0,
- VSC73XX_RECVMASK, BIT(port), 0);
+ /* Allow backward dropping of frames from this port */
+ vsc73xx_update_bits(vsc, VSC73XX_BLOCK_ARBITER, 0,
+ VSC73XX_SBACKWDROP, BIT(port), BIT(port));
- return;
- }
+ /* Receive mask (disable forwarding) */
+ vsc73xx_update_bits(vsc, VSC73XX_BLOCK_ANALYZER, 0,
+ VSC73XX_RECVMASK, BIT(port), 0);
+}
- /* Figure out what speed was negotiated */
- if (phydev->speed == SPEED_1000) {
- dev_dbg(vsc->dev, "port %d: 1000 Mbit mode full duplex\n",
- port);
+static void vsc73xx_phylink_mac_link_up(struct dsa_switch *ds, int port,
+ unsigned int mode,
+ phy_interface_t interface,
+ struct phy_device *phydev,
+ int speed, int duplex,
+ bool tx_pause, bool rx_pause)
+{
+ struct vsc73xx *vsc = ds->priv;
+ u32 val;
+ switch (speed) {
+ case SPEED_1000:
/* Set up default for internal port or external RGMII */
- if (phydev->interface == PHY_INTERFACE_MODE_RGMII)
+ if (interface == PHY_INTERFACE_MODE_RGMII)
val = VSC73XX_MAC_CFG_1000M_F_RGMII;
else
val = VSC73XX_MAC_CFG_1000M_F_PHY;
- vsc73xx_adjust_enable_port(vsc, port, phydev, val);
- } else if (phydev->speed == SPEED_100) {
- if (phydev->duplex == DUPLEX_FULL) {
- val = VSC73XX_MAC_CFG_100_10M_F_PHY;
- dev_dbg(vsc->dev,
- "port %d: 100 Mbit full duplex mode\n",
- port);
- } else {
- val = VSC73XX_MAC_CFG_100_10M_H_PHY;
- dev_dbg(vsc->dev,
- "port %d: 100 Mbit half duplex mode\n",
- port);
- }
- vsc73xx_adjust_enable_port(vsc, port, phydev, val);
- } else if (phydev->speed == SPEED_10) {
- if (phydev->duplex == DUPLEX_FULL) {
+ break;
+ case SPEED_100:
+ case SPEED_10:
+ if (duplex == DUPLEX_FULL)
val = VSC73XX_MAC_CFG_100_10M_F_PHY;
- dev_dbg(vsc->dev,
- "port %d: 10 Mbit full duplex mode\n",
- port);
- } else {
+ else
val = VSC73XX_MAC_CFG_100_10M_H_PHY;
- dev_dbg(vsc->dev,
- "port %d: 10 Mbit half duplex mode\n",
- port);
- }
- vsc73xx_adjust_enable_port(vsc, port, phydev, val);
- } else {
- dev_err(vsc->dev,
- "could not adjust link: unknown speed\n");
+ break;
}
/* Enable port (forwarding) in the receieve mask */
vsc73xx_update_bits(vsc, VSC73XX_BLOCK_ANALYZER, 0,
VSC73XX_RECVMASK, BIT(port), BIT(port));
+ vsc73xx_adjust_enable_port(vsc, port, val);
}
static int vsc73xx_port_enable(struct dsa_switch *ds, int port,
@@ -1043,7 +1059,10 @@ static const struct dsa_switch_ops vsc73xx_ds_ops = {
.setup = vsc73xx_setup,
.phy_read = vsc73xx_phy_read,
.phy_write = vsc73xx_phy_write,
- .adjust_link = vsc73xx_adjust_link,
+ .phylink_get_caps = vsc73xx_phylink_get_caps,
+ .phylink_mac_config = vsc73xx_phylink_mac_config,
+ .phylink_mac_link_down = vsc73xx_phylink_mac_link_down,
+ .phylink_mac_link_up = vsc73xx_phylink_mac_link_up,
.get_strings = vsc73xx_get_strings,
.get_ethtool_stats = vsc73xx_get_ethtool_stats,
.get_sset_count = vsc73xx_get_sset_count,
--
2.34.1
Powered by blists - more mailing lists