[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <69e827e239dab9fd7986ee43cef599d024c8535f.camel@gmail.com>
Date: Thu, 29 Jun 2023 09:45:26 -0700
From: Alexander H Duyck <alexander.duyck@...il.com>
To: Alexander Lobakin <aleksander.lobakin@...el.com>,
"David S. Miller" <davem@...emloft.net>,
Eric Dumazet <edumazet@...gle.com>,
Jakub Kicinski <kuba@...nel.org>,
Paolo Abeni <pabeni@...hat.com>
Cc: Maciej Fijalkowski <maciej.fijalkowski@...el.com>,
Larysa Zaremba <larysa.zaremba@...el.com>,
Yunsheng Lin <linyunsheng@...wei.com>,
Alexander Duyck <alexanderduyck@...com>,
Jesper Dangaard Brouer <hawk@...nel.org>,
Ilias Apalodimas <ilias.apalodimas@...aro.org>,
netdev@...r.kernel.org, linux-kernel@...r.kernel.org
Subject: Re: [PATCH RFC net-next 2/4] net: page_pool: avoid calling no-op
externals when possible
On Thu, 2023-06-29 at 17:23 +0200, Alexander Lobakin wrote:
> Turned out page_pool_put{,_full}_page() can burn quite a bunch of cycles
> even when on DMA-coherent platforms (like x86) with no active IOMMU or
> swiotlb, just for the call ladder.
> Indeed, it's
>
> page_pool_put_page()
> page_pool_put_defragged_page() <- external
> __page_pool_put_page()
> page_pool_dma_sync_for_device() <- non-inline
> dma_sync_single_range_for_device()
> dma_sync_single_for_device() <- external
> dma_direct_sync_single_for_device()
> dev_is_dma_coherent() <- exit
>
> For the inline functions, no guarantees the compiler won't uninline them
> (they're clearly not one-liners and sometimes compilers uninline even
> 2 + 2). The first external call is necessary, but the rest 2+ are done
> for nothing each time, plus a bunch of checks here and there.
> Since Page Pool mappings are long-term and for one "device + addr" pair
> dma_need_sync() will always return the same value (basically, whether it
> belongs to an swiotlb pool), addresses can be tested once right after
> they're obtained and the result can be reused until the page is unmapped.
> Define new PP flag, which will mean "do DMA syncs for device, but only
> when needed" and turn it on by default when the driver asks to sync
> pages. When a page is mapped, check whether it needs syncs and if so,
> replace that "sync when needed" back to "always do syncs" globally for
> the whole pool (better safe than sorry). As long as a pool has no pages
> requiring DMA syncs, this cuts off a good piece of calls and checks.
> On my x86_64, this gives from 2% to 5% performance benefit with no
> negative impact for cases when IOMMU is on and the shortcut can't be
> used.
>
> Signed-off-by: Alexander Lobakin <aleksander.lobakin@...el.com>
> ---
> include/net/page_pool.h | 3 +++
> net/core/page_pool.c | 10 ++++++++++
> 2 files changed, 13 insertions(+)
>
> diff --git a/include/net/page_pool.h b/include/net/page_pool.h
> index 829dc1f8ba6b..ff3772fab707 100644
> --- a/include/net/page_pool.h
> +++ b/include/net/page_pool.h
> @@ -23,6 +23,9 @@
> * Please note DMA-sync-for-CPU is still
> * device driver responsibility
> */
> +#define PP_FLAG_DMA_MAYBE_SYNC BIT(2) /* Internal, should not be used in
> + * drivers
> + */
> #define PP_FLAG_ALL (PP_FLAG_DMA_MAP |\
> PP_FLAG_DMA_SYNC_DEV)
>
> diff --git a/net/core/page_pool.c b/net/core/page_pool.c
> index dff0b4fa2316..498e058140b3 100644
> --- a/net/core/page_pool.c
> +++ b/net/core/page_pool.c
> @@ -197,6 +197,10 @@ static int page_pool_init(struct page_pool *pool,
> /* pool->p.offset has to be set according to the address
> * offset used by the DMA engine to start copying rx data
> */
> +
> + /* Try to avoid calling no-op syncs */
> + pool->p.flags |= PP_FLAG_DMA_MAYBE_SYNC;
> + pool->p.flags &= ~PP_FLAG_DMA_SYNC_DEV;
> }
>
> #ifdef CONFIG_PAGE_POOL_STATS
> @@ -341,6 +345,12 @@ static bool page_pool_dma_map(struct page_pool *pool, struct page *page)
>
> page_pool_set_dma_addr(page, dma);
>
> + if ((pool->p.flags & PP_FLAG_DMA_MAYBE_SYNC) &&
> + dma_need_sync(pool->p.dev, dma)) {
> + pool->p.flags |= PP_FLAG_DMA_SYNC_DEV;
> + pool->p.flags &= ~PP_FLAG_DMA_MAYBE_SYNC;
> + }
> +
> if (pool->p.flags & PP_FLAG_DMA_SYNC_DEV)
> page_pool_dma_sync_for_device(pool, page, pool->p.max_len);
>
I am pretty sure the logic is flawed here. The problem is
dma_needs_sync depends on the DMA address being used. In the worst case
scenario we could have a device that has something like a 32b DMA
address space on a system with over 4GB of memory. In such a case the
higher addresses would need to be synced because they will go off to a
swiotlb bounce buffer while the lower addresses wouldn't.
If you were to store a flag like this it would have to be generated per
page.
Powered by blists - more mailing lists