[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <202A0C36-D1F6-4BB4-BDEC-F36A76B757A2@walle.cc>
Date: Tue, 15 Aug 2023 17:59:34 +0200
From: Michael Walle <michael@...le.cc>
To: Hsin-Yi Wang <hsinyi@...omium.org>,
Tudor Ambarus <tudor.ambarus@...aro.org>,
Krzysztof Kozlowski <krzysztof.kozlowski+dt@...aro.org>,
Conor Dooley <conor+dt@...nel.org>,
Matthias Brugger <matthias.bgg@...il.com>,
Bjorn Andersson <andersson@...nel.org>
CC: Pratyush Yadav <pratyush@...nel.org>,
"Miquel Raynal )" <miquel.raynal@...tlin.com>,
"Richard Weinberger )" <richard@....at>,
"Vignesh Raghavendra )" <vigneshr@...com>,
Rob Herring <robh+dt@...nel.org>,
linux-mtd@...ts.infradead.org, devicetree@...r.kernel.org,
linux-kernel@...r.kernel.org,
AngeloGioacchino Del Regno
<angelogioacchino.delregno@...labora.com>,
linux-arm-kernel@...ts.infradead.org,
linux-mediatek@...ts.infradead.org,
cros-qcom-dts-watchers@...omium.org,
Andy Gross <agross@...nel.org>,
Konrad Dybcio <konrad.dybcio@...aro.org>
Subject: Re: [PATCH 0/4] Add a property to override the quad mode
Hi,
>On gigadevice gd25lq64c, the quad mode is enabled after BFPT is parsed.
>According to datasheet[1], Quad enable (QE) bit needs to be set to 0 to
>use write protection (WP) pin. It also recommends setting default value of
>QE to 0 to avoid a potential short issue.
So you are using either dual or single io mode. Why can't you use the device tree property spi-{tx,rx}-bus-width?
>Add a disable-quad-mode property in devicetree that platform can use it to
>override the quad mode status parsed from BFPT to use write protection.
>
>[1]
>https://www.elm-tech.com/ja/products/spi-flash-memory/gd25lq64/gd25lq64.pdf
should be a link on the vendor Homepage if possible.
-michael
Powered by blists - more mailing lists