[<prev] [next>] [<thread-prev] [day] [month] [year] [list]
Message-ID: <89fabd50-66ce-d94f-38c8-6dd6f343958d@linaro.org>
Date: Wed, 16 Aug 2023 12:21:30 +0200
From: Daniel Lezcano <daniel.lezcano@...aro.org>
To: Nícolas F. R. A. Prado
<nfraprado@...labora.com>
Cc: kernel@...labora.com,
AngeloGioacchino Del Regno
<angelogioacchino.delregno@...labora.com>,
Chen-Yu Tsai <wenst@...omium.org>,
Bernhard Rosenkränzer <bero@...libre.com>,
Alexandre Mergnat <amergnat@...libre.com>,
Amit Kucheria <amitk@...nel.org>,
Balsam CHIHI <bchihi@...libre.com>,
Matthias Brugger <matthias.bgg@...il.com>,
"Rafael J. Wysocki" <rafael@...nel.org>,
Yangtao Li <frank.li@...o.com>,
Zhang Rui <rui.zhang@...el.com>,
linux-arm-kernel@...ts.infradead.org, linux-kernel@...r.kernel.org,
linux-mediatek@...ts.infradead.org, linux-pm@...r.kernel.org
Subject: Re: [PATCH v2] thermal/drivers/mediatek/lvts_thermal: Make readings
valid in filtered mode
On 13/07/2023 17:42, Nícolas F. R. A. Prado wrote:
> Currently, when a controller is configured to use filtered mode, thermal
> readings are valid only about 30% of the time.
>
> Upon testing, it was noticed that lowering any of the interval settings
> resulted in an improved rate of valid data. The same was observed when
> decreasing the number of samples for each sensor (which also results in
> quicker measurements).
>
> Retrying the read with a timeout longer than the time it takes to
> resample (about 344us with these settings and 4 sensors) also improves
> the rate.
>
> Lower all timing settings to the minimum, configure the filtering to
> single sample, and poll the measurement register for at least one period
> to improve the data validity on filtered mode. With these changes in
> place, out of 100000 reads, a single one failed, ie 99.999% of the data
> was valid.
>
> Reviewed-by: Chen-Yu Tsai <wenst@...omium.org>
> Tested-by: Chen-Yu Tsai <wenst@...omium.org>
> Signed-off-by: Nícolas F. R. A. Prado <nfraprado@...labora.com>
>
> ---
Applied, thanks
--
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs
Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog
Powered by blists - more mailing lists