[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-Id: <20230915130118.927821-1-david.wretman@ferroamp.se>
Date: Fri, 15 Sep 2023 15:01:19 +0200
From: David Wretman <david.wretman@...roamp.se>
To: parthiban.veerasooran@...rochip.com
Cc: Nicolas.Ferre@...rochip.com, Thorsten.Kummermehr@...rochip.com,
UNGLinuxDriver@...rochip.com, Woojung.Huh@...rochip.com,
andrew@...n.ch, casper.casan@...il.com, conor+dt@...nel.org,
corbet@....net, davem@...emloft.net, devicetree@...r.kernel.org,
edumazet@...gle.com, horatiu.vultur@...rochip.com,
horms@...nel.org, krzysztof.kozlowski+dt@...aro.org,
kuba@...nel.org, linux-doc@...r.kernel.org,
linux-kernel@...r.kernel.org, netdev@...r.kernel.org,
pabeni@...hat.com, rdunlap@...radead.org, robh+dt@...nel.org,
steen.hegelund@...rochip.com,
David Wretman <david.wretman@...roamp.se>
Subject: [RFC PATCH net-next 5/6] microchip: lan865x: add driver support for Microchip's LAN865X MACPHY
---
On Fri, Sep 08, 2023 at 07:59:18PM +0530, Parthiban Veerasooran wrote:
> The LAN8650/1 is designed to conform to the OPEN Alliance 10BASE‑T1x
> MAC‑PHY Serial Interface specification, Version 1.1. The IEEE Clause 4
> MAC integration provides the low pin count standard SPI interface to any
> microcontroller therefore providing Ethernet functionality without
> requiring MAC integration within the microcontroller. The LAN8650/1
> operates as an SPI client supporting SCLK clock rates up to a maximum of
> 25 MHz. This SPI interface supports the transfer of both data (Ethernet
> frames) and control (register access).
>
> By default, the chunk data payload is 64 bytes in size. A smaller payload
> data size of 32 bytes is also supported and may be configured in the
> Chunk Payload Size (CPS) field of the Configuration 0 (OA_CONFIG0)
> register. Changing the chunk payload size requires the LAN8650/1 be reset
> and shall not be done during normal operation.
>
> The Ethernet Media Access Controller (MAC) module implements a 10 Mbps
> half duplex Ethernet MAC, compatible with the IEEE 802.3 standard.
> 10BASE-T1S physical layer transceiver integrated into the LAN8650/1. The
> PHY and MAC are connected via an internal Media Independent Interface
> (MII).
>
> Signed-off-by: Parthiban Veerasooran <Parthiban.Veerasooran@...rochip.com>
Hi Parthiban,
Thanks for these patches.
One thing I am missing is settings for PLCA parameters. I feel that the
driver is a bit lacking as long as this is missing.
Adding support for the ethtool plca options would make this much more
complete.
Regards,
David
Powered by blists - more mailing lists