linux-kernel - [PATCH v2 1/5] w1: ds2490: support block sizes larger than 128 bytes in ds_read

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-Id: <20231127201856.3836178-2-marc.ferland@sonatest.com>
Date:   Mon, 27 Nov 2023 15:18:52 -0500
From:   marc.ferland@...il.com
To:     krzysztof.kozlowski@...aro.org
Cc:     gregkh@...uxfoundation.org, marc.ferland@...atest.com,
        jeff.dagenais@...il.com, rdunlap@...radead.org,
        linux-kernel@...r.kernel.org
Subject: [PATCH v2 1/5] w1: ds2490: support block sizes larger than 128 bytes in ds_read_block

From: Marc Ferland <marc.ferland@...atest.com>

The current ds_read_block function only supports block sizes up to
128 bytes, which is the depth of the 'data out' fifo on the ds2490.

Reading larger blocks will fail with a: -110 (ETIMEDOUT) from
usb_control_msg(). Example:

    $ dd if=/sys/bus/w1/devices/43-000000478756/eeprom bs=256 count=1

yields to the following message from the kernel:

    usb 5-1: Failed to write 1-wire data to ep0x2: err=-110.

I discovered this issue while implementing support for the ds28ec20
eeprom in the w1-2433 driver. This driver accepts reading blocks of
sizes up to the size of the entire memory (2560 bytes in the case of
the ds28ec20). Note that this issue _does not_ arises when the kernel
is configured with CONFIG_W1_SLAVE_DS2433_CRC enabled since in this
mode the driver reads one 32 byte block at a time (a single memory
page).

Also, from the ds2490 datasheet (2995.pdf, page 22, BLOCK I/O
command):

     For a block write sequence the EP2 FIFO must be pre-filled with
     data before command execution. Additionally, for block sizes
     greater then the FIFO size, the FIFO content status must be
     monitored by host SW so that additional data can be sent to the
     FIFO when necessary. A similar EP3 FIFO content monitoring
     requirement exists for block read sequences. During a block read
     the number of bytes loaded into the EP3 FIFO must be monitored so
     that the data can be read before the FIFO overflows.

Breaking the buffer in 128 bytes blocks and simply calling the
original code sequence has solved the issue for me.

Tested with a DS1490F usb<->one-wire adapter and both the DS28EC20 and
DS2433 eeprom memories.

Note: The v1 of this patch changed both the ds_read_block and
ds_write_block functions, but since I don't have any way to test the
'write' part with writes bigger than a page size (maximum accepted by
my eeprom), I preferred not to make any assumptions and I just
removed that part.

Signed-off-by: Marc Ferland <marc.ferland@...atest.com>
---
 drivers/w1/masters/ds2490.c | 25 +++++++++++++++++++++----
 1 file changed, 21 insertions(+), 4 deletions(-)

diff --git a/drivers/w1/masters/ds2490.c b/drivers/w1/masters/ds2490.c
index 5f5b97e24700..b6e244992c15 100644
--- a/drivers/w1/masters/ds2490.c
+++ b/drivers/w1/masters/ds2490.c
@@ -98,6 +98,8 @@
 #define ST_EPOF				0x80
 /* Status transfer size, 16 bytes status, 16 byte result flags */
 #define ST_SIZE				0x20
+/* 1-wire data i/o fifo size, 128 bytes */
+#define FIFO_SIZE			0x80

 /* Result Register flags */
 #define RR_DETECT			0xA5 /* New device detected */
@@ -614,14 +616,11 @@ static int ds_read_byte(struct ds_device *dev, u8 *byte)
 	return 0;
 }

-static int ds_read_block(struct ds_device *dev, u8 *buf, int len)
+static int __read_block(struct ds_device *dev, u8 *buf, int len)
 {
 	struct ds_status st;
 	int err;

-	if (len > 64*1024)
-		return -E2BIG;
-
 	memset(buf, 0xFF, len);

 	err = ds_send_data(dev, buf, len);
@@ -640,6 +639,24 @@ static int ds_read_block(struct ds_device *dev, u8 *buf, int len)
 	return err;
 }

+static int ds_read_block(struct ds_device *dev, u8 *buf, int len)
+{
+	int err, to_read, rem = len;
+
+	if (len > 64*1024)
+		return -E2BIG;
+
+	do {
+		to_read = rem <= FIFO_SIZE ? rem : FIFO_SIZE;
+		err = __read_block(dev, &buf[len - rem], to_read);
+		if (err < 0)
+			return err;
+		rem -= to_read;
+	} while (rem);
+
+	return err;
+}
+
 static int ds_write_block(struct ds_device *dev, u8 *buf, int len)
 {
 	int err;
-- 
2.34.1