[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <6e91d85c-8cf4-4df9-838a-e5265daed726@amd.com>
Date: Mon, 4 Dec 2023 10:55:03 -0600
From: "Moger, Babu" <babu.moger@....com>
To: Tony Luck <tony.luck@...el.com>, Fenghua Yu <fenghua.yu@...el.com>,
Reinette Chatre <reinette.chatre@...el.com>,
Peter Newman <peternewman@...gle.com>,
Jonathan Corbet <corbet@....net>,
Shuah Khan <skhan@...uxfoundation.org>, x86@...nel.org
Cc: Shaopeng Tan <tan.shaopeng@...itsu.com>,
James Morse <james.morse@....com>,
Jamie Iles <quic_jiles@...cinc.com>,
Randy Dunlap <rdunlap@...radead.org>,
linux-kernel@...r.kernel.org, linux-doc@...r.kernel.org,
patches@...ts.linux.dev, Shaopeng Tan <tan.shaopeng@...fujitsu.com>
Subject: Re: [PATCH v12 8/8] x86/resctrl: Update documentation with Sub-NUMA
cluster changes
On 11/29/23 18:34, Tony Luck wrote:
> With Sub-NUMA Cluster mode enabled the scope of monitoring resources is
> per-NODE instead of per-L3 cache. Suffixes of directories with "L3" in
> their name refer to Sub-NUMA nodes instead of L3 cache ids.
>
> Users should be aware that SNC mode also affects the amount of L3 cache
> available for allocation within each SNC node.
>
> Signed-off-by: Tony Luck <tony.luck@...el.com>
> Reviewed-by: Peter Newman <peternewman@...gle.com>
> Reviewed-by: Reinette Chatre <reinette.chatre@...el.com>
> Reviewed-by: Shaopeng Tan <tan.shaopeng@...fujitsu.com>
> Tested-by: Shaopeng Tan <tan.shaopeng@...fujitsu.com>
> ---
> Documentation/arch/x86/resctrl.rst | 25 +++++++++++++++++++++----
> 1 file changed, 21 insertions(+), 4 deletions(-)
>
> diff --git a/Documentation/arch/x86/resctrl.rst b/Documentation/arch/x86/resctrl.rst
> index a6279df64a9d..49ff789db1d8 100644
> --- a/Documentation/arch/x86/resctrl.rst
> +++ b/Documentation/arch/x86/resctrl.rst
> @@ -366,10 +366,10 @@ When control is enabled all CTRL_MON groups will also contain:
> When monitoring is enabled all MON groups will also contain:
>
> "mon_data":
> - This contains a set of files organized by L3 domain and by
> - RDT event. E.g. on a system with two L3 domains there will
> - be subdirectories "mon_L3_00" and "mon_L3_01". Each of these
> - directories have one file per event (e.g. "llc_occupancy",
> + This contains a set of files organized by L3 domain or by NUMA
> + node (depending on whether Sub-NUMA Cluster (SNC) mode is disabled
> + or enabled respectively) and by RDT event. Each of these
> + directories has one file per event (e.g. "llc_occupancy",
> "mbm_total_bytes", and "mbm_local_bytes"). In a MON group these
> files provide a read out of the current value of the event for
> all tasks in the group. In CTRL_MON groups these files provide
> @@ -478,6 +478,23 @@ if non-contiguous 1s value is supported. On a system with a 20-bit mask
> each bit represents 5% of the capacity of the cache. You could partition
> the cache into four equal parts with masks: 0x1f, 0x3e0, 0x7c00, 0xf8000.
>
> +Notes on Sub-NUMA Cluster mode
> +==============================
> +When SNC mode is enabled Linux may load balance tasks between Sub-NUMA
enabled, Linux
Thanks
Babu
> +nodes much more readily than between regular NUMA nodes since the CPUs
> +on Sub-NUMA nodes share the same L3 cache and the system may report
> +the NUMA distance between Sub-NUMA nodes with a lower value than used
> +for regular NUMA nodes. Users who do not bind tasks to the CPUs of a
> +specific Sub-NUMA node must read the "llc_occupancy", "mbm_total_bytes",
> +and "mbm_local_bytes" for all Sub-NUMA nodes where the tasks may execute
> +to get the full view of traffic for which the tasks were the source.
> +
> +The cache allocation feature still provides the same number of
> +bits in a mask to control allocation into the L3 cache, but each
> +of those ways has its capacity reduced because the cache is divided
> +between the SNC nodes. The values reported in the resctrl
> +"size" files are adjusted accordingly.
> +
> Memory bandwidth Allocation and monitoring
> ==========================================
>
--
Thanks
Babu Moger
Powered by blists - more mailing lists