PM: suspend entry (deep)
Filesystems sync: 0.004 seconds
Freezing user space processes ... (elapsed 0.003 seconds) done.
OOM killer disabled.
Freezing remaining freezable tasks ... (elapsed 0.001 seconds) done.
printk: Suspending console(s) (use no_console_suspend to debug)
----------------------
here system is suspended
----------------------
sd 1:0:0:0: [sdb] Synchronizing SCSI cache
sd 0:0:0:0: [sda] Synchronizing SCSI cache
sd 3:0:0:0: [sdc] Synchronizing SCSI cache
sd 0:0:0:0: [sda] Stopping disk
sd 3:0:0:0: [sdc] Stopping disk
sd 1:0:0:0: [sdb] Stopping disk
serial 00:03: disabled
r8169 0000:07:00.0 eth0: Link is Down
ACPI: Preparing to enter system sleep state S3
PM: Saving platform NVS memory
Disabling non-boot CPUs ...
smpboot: CPU 1 is now offline
smpboot: CPU 2 is now offline
smpboot: CPU 3 is now offline
smpboot: CPU 4 is now offline
smpboot: CPU 5 is now offline
smpboot: CPU 6 is now offline
smpboot: CPU 7 is now offline
smpboot: CPU 8 is now offline
smpboot: CPU 9 is now offline
smpboot: CPU 10 is now offline
smpboot: CPU 11 is now offline
ACPI: Low-level resume complete
PM: Restoring platform NVS memory
smpboot: Scheduler frequency invariance went wobbly, disabling!
Enabling non-boot CPUs ...
x86: Booting SMP configuration:
smpboot: Booting Node 0 Processor 1 APIC 0x2
ACPI: \_SB_.PR01: Found 2 idle states
CPU1 is up
smpboot: Booting Node 0 Processor 2 APIC 0x4
ACPI: \_SB_.PR02: Found 2 idle states
CPU2 is up
smpboot: Booting Node 0 Processor 3 APIC 0x6
ACPI: \_SB_.PR03: Found 2 idle states
CPU3 is up
smpboot: Booting Node 0 Processor 4 APIC 0x8
ACPI: \_SB_.PR04: Found 2 idle states
CPU4 is up
smpboot: Booting Node 0 Processor 5 APIC 0xa
ACPI: \_SB_.PR05: Found 2 idle states
CPU5 is up
smpboot: Booting Node 0 Processor 6 APIC 0x1
ACPI: \_SB_.PR06: Found 2 idle states
CPU6 is up
smpboot: Booting Node 0 Processor 7 APIC 0x3
ACPI: \_SB_.PR07: Found 2 idle states
CPU7 is up
smpboot: Booting Node 0 Processor 8 APIC 0x5
ACPI: \_SB_.PR08: Found 2 idle states
CPU8 is up
smpboot: Booting Node 0 Processor 9 APIC 0x7
ACPI: \_SB_.PR09: Found 2 idle states
CPU9 is up
smpboot: Booting Node 0 Processor 10 APIC 0x9
ACPI: \_SB_.PR10: Found 2 idle states
CPU10 is up
smpboot: Booting Node 0 Processor 11 APIC 0xb
ACPI: \_SB_.PR11: Found 2 idle states
CPU11 is up
ACPI: Waking up from system sleep state S3
serial 00:03: activated
sd 0:0:0:0: [sda] Starting disk
i915 0000:00:02.0: [drm] GuC is uninitialized
sd 1:0:0:0: [sdb] Starting disk
sd 3:0:0:0: [sdc] Starting disk
r8169 0000:07:00.0 eth0: Link is Down
usb 1-7: reset high-speed USB device number 3 using xhci_hcd
ata5: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
ata1: SATA link up 6.0 Gbps (SStatus 133 SControl 300)
ata6: SATA link down (SStatus 4 SControl 300)
ata1.00: supports DRM functions and may not be fully accessible
ata1.00: disabling queued TRIM support
ata1.00: supports DRM functions and may not be fully accessible
ata1.00: disabling queued TRIM support
ata1.00: configured for UDMA/133
ahci 0000:00:17.0: port does not support device sleep
ata3: SATA link down (SStatus 4 SControl 300)
ata4: SATA link up 6.0 Gbps (SStatus 133 SControl 300)
ata4.00: supports DRM functions and may not be fully accessible
ata4.00: disabling queued TRIM support
ata4.00: supports DRM functions and may not be fully accessible
ata4.00: disabling queued TRIM support
ata4.00: configured for UDMA/133
ahci 0000:00:17.0: port does not support device sleep
ata4.00: Enabling discard_zeroes_data
ata5.00: configured for UDMA/133
acpi LNXPOWER:04: Turning OFF
acpi LNXPOWER:00: Turning OFF
OOM killer enabled.
Restarting tasks ... done.
PM: suspend exit
cx23885: cx23885 driver version 0.0.4 loaded
cx23885: CORE cx23885[0]: subsystem: 0070:6a28, board: Hauppauge WinTV-QuadHD-DV
B(885) [card=60,autodetected]
userif-3: sent link down event.
userif-3: sent link up event.
tveeprom: Hauppauge model 166200, rev B4I6, serial# 4036033296
tveeprom: MAC address is 00:0d:fe:90:fb:10
tveeprom: tuner model is SiLabs Si2157 (idx 186, type 4)
tveeprom: TV standards ATSC/DVB Digital (eeprom 0x80)
tveeprom: audio processor is CX23885 (idx 39)
tveeprom: decoder processor is CX23885 (idx 33)
tveeprom: has no radio, has IR receiver, has no IR transmitter
cx23885: cx23885[0]: hauppauge eeprom: model=166200
cx23885: cx23885_dvb_register() allocating 1 frontend(s)
cx23885: cx23885[0]: cx23885 based dvb card
cx23885: dvb_register(): board=60 port=1
i2c i2c-6: Added multiplexed i2c bus 9
si2168 6-0064: Silicon Labs Si2168-B40 successfully identified
si2168 6-0064: firmware version: B 4.0.2
si2157 7-0060: Silicon Labs Si2147/2148/2157/2158 successfully attached
dvbdev: DVB: registering new adapter (cx23885[0])
cx23885 0000:05:00.0: DVB: registering adapter 0 frontend 0 (Silicon Labs Si2168
)...
cx23885: cx23885_dvb_register() allocating 1 frontend(s)
cx23885: cx23885[0]: cx23885 based dvb card
cx23885: dvb_register(): board=60 port=2
i2c i2c-6: Added multiplexed i2c bus 10
si2168 6-0066: Silicon Labs Si2168-B40 successfully identified
si2168 6-0066: firmware version: B 4.0.2
si2157 7-0062: Silicon Labs Si2147/2148/2157/2158 successfully attached
dvbdev: DVB: registering new adapter (cx23885[0])
cx23885 0000:05:00.0: DVB: registering adapter 1 frontend 0 (Silicon Labs Si2168
)...
cx23885: cx23885_dev_checkrevision() Hardware revision = 0xa4
cx23885: cx23885[0]/0: found at 0000:05:00.0, rev: 3, irq: 18, latency: 0, mmio:
0xa1200000
cx23885: CORE cx23885[1]: subsystem: 0070:6b28, board: Hauppauge WinTV-QuadHD-DV
B(885) [card=60,autodetected]
r8169 0000:07:00.0 eth0: Link is Up - 100Mbps/Full - flow control rx/tx
tveeprom: Hauppauge model 166201, rev B4I6, serial# 4036033296
tveeprom: MAC address is 00:0d:fe:90:fb:10
tveeprom: tuner model is SiLabs Si2157 (idx 186, type 4)
tveeprom: TV standards ATSC/DVB Digital (eeprom 0x80)
tveeprom: audio processor is CX23885 (idx 39)
tveeprom: decoder processor is CX23885 (idx 33)
tveeprom: has no radio
cx23885: cx23885[1]: hauppauge eeprom: model=166201
cx23885: cx23885_dvb_register() allocating 1 frontend(s)
cx23885: cx23885[1]: cx23885 based dvb card
cx23885: dvb_register(): board=60 port=1
i2c i2c-11: Added multiplexed i2c bus 14
si2168 11-0064: Silicon Labs Si2168-B40 successfully identified
si2168 11-0064: firmware version: B 4.0.2
si2157 12-0060: Silicon Labs Si2147/2148/2157/2158 successfully attached
dvbdev: DVB: registering new adapter (cx23885[1])
cx23885 0000:06:00.0: DVB: registering adapter 2 frontend 0 (Silicon Labs Si2168
)...
cx23885: cx23885_dvb_register() allocating 1 frontend(s)
cx23885: cx23885[1]: cx23885 based dvb card
cx23885: dvb_register(): board=60 port=2
i2c i2c-11: Added multiplexed i2c bus 15
si2168 11-0066: Silicon Labs Si2168-B40 successfully identified
userif-3: sent link down event.
si2168 11-0066: firmware version: B 4.0.2
si2157 12-0062: Silicon Labs Si2147/2148/2157/2158 successfully attached
userif-3: sent link up event.
dvbdev: DVB: registering new adapter (cx23885[1])
cx23885 0000:06:00.0: DVB: registering adapter 3 frontend 0 (Silicon Labs Si2168
)...
cx23885: cx23885_dev_checkrevision() Hardware revision = 0xa4
cx23885: cx23885[1]/0: found at 0000:06:00.0, rev: 3, irq: 19, latency: 0, mmio:
0xa1000000
ata2: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
ata2.00: configured for UDMA/133