| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <917a9dc4-bcae-4a1d-b5b5-d086431e8650@intel.com>
Date: Wed, 13 Dec 2023 17:30:24 +0800
From: "Yang, Weijiang" <weijiang.yang@...el.com>
To: Maxim Levitsky <mlevitsk@...hat.com>, <chang.seok.bae@...el.com>
CC: <linux-kernel@...r.kernel.org>, <kvm@...r.kernel.org>,
<dave.hansen@...el.com>, <pbonzini@...hat.com>,
<seanjc@...gle.com>, <peterz@...radead.org>, <chao.gao@...el.com>,
<rick.p.edgecombe@...el.com>, <john.allen@....com>
Subject: Re: [PATCH v7 02/26] x86/fpu/xstate: Refine CET user xstate bit
enabling
On 12/8/2023 11:15 PM, Maxim Levitsky wrote:
> On Fri, 2023-12-08 at 22:57 +0800, Yang, Weijiang wrote:
>> On 12/6/2023 11:57 PM, Maxim Levitsky wrote:
>>> On Wed, 2023-12-06 at 09:03 +0800, Yang, Weijiang wrote:
>>>> On 12/5/2023 5:53 PM, Maxim Levitsky wrote:
>>>>> On Fri, 2023-12-01 at 14:51 +0800, Yang, Weijiang wrote:
>>>>>> On 12/1/2023 1:26 AM, Maxim Levitsky wrote:
>>>>>>> On Fri, 2023-11-24 at 00:53 -0500, Yang Weijiang wrote:
>>>>>>>> Remove XFEATURE_CET_USER entry from dependency array as the entry doesn't
>>>>>>>> reflect true dependency between CET features and the user xstate bit.
>>>>>>>> Enable the bit in fpu_kernel_cfg.max_features when either SHSTK or IBT is
>>>>>>>> available.
>>>>>>>>
>>>>>>>> Both user mode shadow stack and indirect branch tracking features depend
>>>>>>>> on XFEATURE_CET_USER bit in XSS to automatically save/restore user mode
>>>>>>>> xstate registers, i.e., IA32_U_CET and IA32_PL3_SSP whenever necessary.
>>>>>>>>
>>>>>>>> Note, the issue, i.e., CPUID only enumerates IBT but no SHSTK is resulted
>>>>>>>> from CET KVM series which synthesizes guest CPUIDs based on userspace
>>>>>>>> settings,in real world the case is rare. In other words, the exitings
>>>>>>>> dependency check is correct when only user mode SHSTK is available.
>>>>>>>>
>>>>>>>> Signed-off-by: Yang Weijiang <weijiang.yang@...el.com>
>>>>>>>> Reviewed-by: Rick Edgecombe <rick.p.edgecombe@...el.com>
>>>>>>>> Tested-by: Rick Edgecombe <rick.p.edgecombe@...el.com>
>>>>>>>> ---
>>>>>>>> arch/x86/kernel/fpu/xstate.c | 9 ++++++++-
>>>>>>>> 1 file changed, 8 insertions(+), 1 deletion(-)
>>>>>>>>
>>>>>>>> diff --git a/arch/x86/kernel/fpu/xstate.c b/arch/x86/kernel/fpu/xstate.c
>>>>>>>> index 73f6bc00d178..6e50a4251e2b 100644
>>>>>>>> --- a/arch/x86/kernel/fpu/xstate.c
>>>>>>>> +++ b/arch/x86/kernel/fpu/xstate.c
>>>>>>>> @@ -73,7 +73,6 @@ static unsigned short xsave_cpuid_features[] __initdata = {
>>>>>>>> [XFEATURE_PT_UNIMPLEMENTED_SO_FAR] = X86_FEATURE_INTEL_PT,
>>>>>>>> [XFEATURE_PKRU] = X86_FEATURE_OSPKE,
>>>>>>>> [XFEATURE_PASID] = X86_FEATURE_ENQCMD,
>>>>>>>> - [XFEATURE_CET_USER] = X86_FEATURE_SHSTK,
>>>>>>>> [XFEATURE_XTILE_CFG] = X86_FEATURE_AMX_TILE,
>>>>>>>> [XFEATURE_XTILE_DATA] = X86_FEATURE_AMX_TILE,
>>>>>>>> };
>>>>>>>> @@ -798,6 +797,14 @@ void __init fpu__init_system_xstate(unsigned int legacy_size)
>>>>>>>> fpu_kernel_cfg.max_features &= ~BIT_ULL(i);
>>>>>>>> }
>>>>>>>>
>>>>>>>> + /*
>>>>>>>> + * CET user mode xstate bit has been cleared by above sanity check.
>>>>>>>> + * Now pick it up if either SHSTK or IBT is available. Either feature
>>>>>>>> + * depends on the xstate bit to save/restore user mode states.
>>>>>>>> + */
>>>>>>>> + if (boot_cpu_has(X86_FEATURE_SHSTK) || boot_cpu_has(X86_FEATURE_IBT))
>>>>>>>> + fpu_kernel_cfg.max_features |= BIT_ULL(XFEATURE_CET_USER);
>>>>>>>> +
>>>>>>>> if (!cpu_feature_enabled(X86_FEATURE_XFD))
>>>>>>>> fpu_kernel_cfg.max_features &= ~XFEATURE_MASK_USER_DYNAMIC;
>>>>>>>>
>>>>>>> I am curious:
>>>>>>>
>>>>>>> Any reason why my review feedback was not applied even though you did agree
>>>>>>> that it is reasonable?
>>>>>> My apology! I changed the patch per you feedback but found XFEATURE_CET_USER didn't
>>>>>> work before sending out v7 version, after a close look at the existing code:
>>>>>>
>>>>>> for (i = 0; i < ARRAY_SIZE(xsave_cpuid_features); i++) {
>>>>>> unsigned short cid = xsave_cpuid_features[i];
>>>>>>
>>>>>> /* Careful: X86_FEATURE_FPU is 0! */
>>>>>> if ((i != XFEATURE_FP && !cid) || !boot_cpu_has(cid))
>>>>>> fpu_kernel_cfg.max_features &= ~BIT_ULL(i);
>>>>>> }
>>>>>>
>>>>>> With removal of XFEATURE_CET_USER entry from xsave_cpuid_features, actually
>>>>>> above check will clear the bit from fpu_kernel_cfg.max_features.
>>>>> Are you sure about this? If we remove the XFEATURE_CET_USER from the xsave_cpuid_features,
>>>>> then the above loop will not touch it - it loops only over the items in the xsave_cpuid_features
>>>>> array.
>>>> No, the code is a bit tricky, the actual array size is XFEATURE_XTILE_DATA( ie, 18) + 1, those xfeature bits not listed in init code leave a blank entry with xsave_cpuid_features[i] == 0, so for the blank elements, the loop hits (i != XFEATURE_FP && !cid) then the relevant xfeature bit for i is cleared in fpu_kernel_cfg.max_features. I had the same illusion at first when I replied your comments in v6, and modified the code as you suggested but found the issue during tests. Please double check it.
>>> Oh I see now. IMHO the current code is broken, or at least it violates the
>>> 'Clear XSAVE features that are disabled in the normal CPUID' comment, because
>>> it also clears all xfeatures which have no CPUID bit in the table (except FPU,
>>> for which we have a workaround).
>>>
>>>
>>> How about we do this instead:
>>>
>>> for (i = 0; i < ARRAY_SIZE(xsave_cpuid_features); i++) {
>>> unsigned short cid = xsave_cpuid_features[i];
>>>
>>> if (cid && !boot_cpu_has(cid))
>>> fpu_kernel_cfg.max_features &= ~BIT_ULL(i);
>>> }
>> I think existing code is more reasonable, the side-effect of current code, i.e., masking out
>> the unclaimed xfeature bits, sanitizes the bits in max_features at the first place, then following calculations derived from it become reasonable too.
>
> I strongly disagree with that. Kernel already removes all features bits which it knows nothing about.
>
> There is no need to also remove the xfeatures that it knows about but knows nothing about a CPUID bit.
> For such features the kernel needs either to accept it (like FPU) or remove the feature from set of supported features.
Let me involve Chang, the author of the code in question.
Hi, Chang,
In commit 70c3f1671b0c ("x86/fpu/xstate: Prepare XSAVE feature table for gaps in state component numbers"),
you modified the loop as below:
for (i = 0; i < ARRAY_SIZE(xsave_cpuid_features); i++) {
- if (!boot_cpu_has(xsave_cpuid_features[i]))
+ unsigned short cid = xsave_cpuid_features[i];
+
+ /* Careful: X86_FEATURE_FPU is 0! */
+ if ((i != XFEATURE_FP && !cid) || !boot_cpu_has(cid))
fpu_kernel_cfg.max_features &= ~BIT_ULL(i);
}
IMHO the change resulted functional change of the loop, i.e., before that only it only clears the bits without CPUIDs,
but after the change, the side-effect of the loop will clear the bits of blank entries ( where xsave_cpuid_features[i] == 0 )
since the loop hits (i != XFEATURE_FP && !cid), is it intended or something else?
Powered by blists - more mailing lists