[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID:
<TYZPR01MB5556D3E73D7F7242F810F915C9762@TYZPR01MB5556.apcprd01.prod.exchangelabs.com>
Date: Sun, 21 Jan 2024 20:42:37 +0800
From: Ziyang Huang <hzyitc@...look.com>
To: mcoquelin.stm32@...il.com
Cc: alexandre.torgue@...s.st.com,
richardcochran@...il.com,
p.zabel@...gutronix.de,
matthias.bgg@...il.com,
angelogioacchino.delregno@...labora.com,
linux-kernel@...r.kernel.org,
linux-stm32@...md-mailman.stormreply.com,
linux-arm-kernel@...ts.infradead.org,
netdev@...r.kernel.org,
linux-mediatek@...ts.infradead.org,
Ziyang Huang <hzyitc@...look.com>
Subject: [PATCH 8/8] arm64: dts: qcom: ipq5018-rdp432-c2: enable ethernet support
Signed-off-by: Ziyang Huang <hzyitc@...look.com>
---
.../arm64/boot/dts/qcom/ipq5018-rdp432-c2.dts | 52 +++++++++++++++++++
1 file changed, 52 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/ipq5018-rdp432-c2.dts b/arch/arm64/boot/dts/qcom/ipq5018-rdp432-c2.dts
index e636a1cb9b77..074b78d7939c 100644
--- a/arch/arm64/boot/dts/qcom/ipq5018-rdp432-c2.dts
+++ b/arch/arm64/boot/dts/qcom/ipq5018-rdp432-c2.dts
@@ -15,6 +15,9 @@ / {
aliases {
serial0 = &blsp1_uart1;
+
+ ethernet0 = &gmac0;
+ ethernet1 = &gmac1;
};
chosen {
@@ -43,6 +46,22 @@ &sleep_clk {
};
&tlmm {
+ mdio1_pins: mdio1_pins {
+ mdc {
+ pins = "gpio36";
+ function = "mdc";
+ drive-strength = <8>;
+ bias-pull-up;
+ };
+
+ mdio {
+ pins = "gpio37";
+ function = "mdio";
+ drive-strength = <8>;
+ bias-pull-up;
+ };
+ };
+
sdc_default_state: sdc-default-state {
clk-pins {
pins = "gpio9";
@@ -70,3 +89,36 @@ data-pins {
&xo_board_clk {
clock-frequency = <24000000>;
};
+
+&mdio0 {
+ status = "ok";
+};
+
+&mdio1 {
+ pinctrl-0 = <&mdio1_pins>;
+ pinctrl-names = "default";
+ status = "ok";
+
+ reset-gpios = <&tlmm 39 GPIO_ACTIVE_LOW>;
+
+ qca8081: ethernet-phy@28 {
+ reg = <28>;
+ };
+};
+
+&uniphy0 {
+ mode = <QCOM_ETH_UNIPHY_MODE_SGMII>;
+ clkout-frequency = <QCOM_ETH_UNIPHY_CLKOUT_FREQ_50M>;
+ clkout-drive-strength = <QCOM_ETH_UNIPHY_CLKOUT_DS_1_5V>;
+ status = "ok";
+};
+
+&gmac0 {
+ status = "ok";
+};
+
+&gmac1 {
+ phy-handle = <&qca8081>;
+ phy-mode = "sgmii";
+ status = "ok";
+};
--
2.40.1
Powered by blists - more mailing lists