| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20240216070555.2483977-4-tudor.ambarus@linaro.org>
Date: Fri, 16 Feb 2024 07:05:46 +0000
From: Tudor Ambarus <tudor.ambarus@...aro.org>
To: broonie@...nel.org,
robh@...nel.org,
andi.shyti@...nel.org,
krzysztof.kozlowski@...aro.org,
semen.protsenko@...aro.org,
conor+dt@...nel.org
Cc: alim.akhtar@...sung.com,
linux-spi@...r.kernel.org,
linux-samsung-soc@...r.kernel.org,
linux-arm-kernel@...ts.infradead.org,
linux-kernel@...r.kernel.org,
andre.draszik@...aro.org,
peter.griffin@...aro.org,
kernel-team@...roid.com,
willmcvicker@...gle.com,
devicetree@...r.kernel.org,
Tudor Ambarus <tudor.ambarus@...aro.org>
Subject: [PATCH v3 03/12] spi: s3c64xx: allow full FIFO masks
The driver is wrong because is using partial register field masks for the
SPI_STATUS.{RX, TX}_FIFO_LVL register fields.
We see s3c64xx_spi_port_config.fifo_lvl_mask with different values for
different instances of the same IP. Take s5pv210_spi_port_config for
example, it defines:
.fifo_lvl_mask = { 0x1ff, 0x7F },
fifo_lvl_mask is used to determine the FIFO depth of the instance of the
IP. In this case, the integrator uses a 256 bytes FIFO for the first SPI
instance of the IP, and a 64 bytes FIFO for the second instance. While
the first mask reflects the SPI_STATUS.{RX, TX}_FIFO_LVL register
fields, the second one is two bits short. Using partial field masks is
misleading and can hide problems of the driver's logic.
Allow platforms to specify the full FIFO mask, regardless of the FIFO
depth.
Introduce {rx, tx}_fifomask to represent the SPI_STATUS.{RX, TX}_FIFO_LVL
register fields. It's a shifted mask defining the field's length and
position. We'll be able to deprecate the use of @rx_lvl_offset, as the
shift value can be determined from the mask. The existing compatibles
shall start using {rx, tx}_fifomask so that they use the full field mask
and to avoid shifting the mask to position, and then shifting it back to
zero in the {TX, RX}_FIFO_LVL macros.
@rx_lvl_offset will be deprecated in a further patch, after we have the
infrastructure to deprecate @fifo_lvl_mask as well.
No functional change intended.
Signed-off-by: Tudor Ambarus <tudor.ambarus@...aro.org>
---
drivers/spi/spi-s3c64xx.c | 40 +++++++++++++++++++++++++++++++++++----
1 file changed, 36 insertions(+), 4 deletions(-)
diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
index 6ff3b25b6feb..338ca3f03ea5 100644
--- a/drivers/spi/spi-s3c64xx.c
+++ b/drivers/spi/spi-s3c64xx.c
@@ -3,6 +3,7 @@
// Copyright (c) 2009 Samsung Electronics Co., Ltd.
// Jaswinder Singh <jassi.brar@...sung.com>
+#include <linux/bitops.h>
#include <linux/bits.h>
#include <linux/clk.h>
#include <linux/delay.h>
@@ -109,10 +110,10 @@
#define FIFO_LVL_MASK(i) ((i)->port_conf->fifo_lvl_mask[i->port_id])
#define S3C64XX_SPI_ST_TX_DONE(v, i) (((v) & \
(1 << (i)->port_conf->tx_st_done)) ? 1 : 0)
-#define TX_FIFO_LVL(v, i) (((v) >> S3C64XX_SPI_ST_TX_FIFO_LVL_SHIFT) & \
- FIFO_LVL_MASK(i))
-#define RX_FIFO_LVL(v, i) (((v) >> (i)->port_conf->rx_lvl_offset) & \
- FIFO_LVL_MASK(i))
+#define TX_FIFO_LVL(v, sdd) (((v) & (sdd)->tx_fifomask) >> \
+ __ffs((sdd)->tx_fifomask))
+#define RX_FIFO_LVL(v, sdd) (((v) & (sdd)->rx_fifomask) >> \
+ __ffs((sdd)->rx_fifomask))
#define FIFO_DEPTH(i) ((FIFO_LVL_MASK(i) >> 1) + 1)
#define S3C64XX_SPI_MAX_TRAILCNT 0x3ff
@@ -136,6 +137,10 @@ struct s3c64xx_spi_dma_data {
* struct s3c64xx_spi_port_config - SPI Controller hardware info
* @fifo_lvl_mask: Bit-mask for {TX|RX}_FIFO_LVL bits in SPI_STATUS register.
* @rx_lvl_offset: Bit offset of RX_FIFO_LVL bits in SPI_STATUS regiter.
+ * @rx_fifomask: SPI_STATUS.RX_FIFO_LVL mask. Shifted mask defining the field's
+ * length and position.
+ * @tx_fifomask: SPI_STATUS.TX_FIFO_LVL mask. Shifted mask defining the field's
+ * length and position.
* @tx_st_done: Bit offset of TX_DONE bit in SPI_STATUS regiter.
* @clk_div: Internal clock divider
* @quirks: Bitmask of known quirks
@@ -154,6 +159,8 @@ struct s3c64xx_spi_dma_data {
struct s3c64xx_spi_port_config {
int fifo_lvl_mask[MAX_SPI_PORTS];
int rx_lvl_offset;
+ u32 rx_fifomask;
+ u32 tx_fifomask;
int tx_st_done;
int quirks;
int clk_div;
@@ -184,6 +191,10 @@ struct s3c64xx_spi_port_config {
* @tx_dma: Local transmit DMA data (e.g. chan and direction)
* @port_conf: Local SPI port configuration data
* @port_id: Port identification number
+ * @rx_fifomask: SPI_STATUS.RX_FIFO_LVL mask. Shifted mask defining the field's
+ * length and position.
+ * @tx_fifomask: SPI_STATUS.TX_FIFO_LVL mask. Shifted mask defining the field's
+ * length and position.
*/
struct s3c64xx_spi_driver_data {
void __iomem *regs;
@@ -203,6 +214,8 @@ struct s3c64xx_spi_driver_data {
struct s3c64xx_spi_dma_data tx_dma;
const struct s3c64xx_spi_port_config *port_conf;
unsigned int port_id;
+ u32 rx_fifomask;
+ u32 tx_fifomask;
};
static void s3c64xx_flush_fifo(struct s3c64xx_spi_driver_data *sdd)
@@ -1183,6 +1196,23 @@ static inline const struct s3c64xx_spi_port_config *s3c64xx_spi_get_port_config(
return (const struct s3c64xx_spi_port_config *)platform_get_device_id(pdev)->driver_data;
}
+static void s3c64xx_spi_set_fifomask(struct s3c64xx_spi_driver_data *sdd)
+{
+ const struct s3c64xx_spi_port_config *port_conf = sdd->port_conf;
+
+ if (port_conf->rx_fifomask)
+ sdd->rx_fifomask = port_conf->rx_fifomask;
+ else
+ sdd->rx_fifomask = FIFO_LVL_MASK(sdd) <<
+ port_conf->rx_lvl_offset;
+
+ if (port_conf->tx_fifomask)
+ sdd->tx_fifomask = port_conf->tx_fifomask;
+ else
+ sdd->tx_fifomask = FIFO_LVL_MASK(sdd) <<
+ S3C64XX_SPI_ST_TX_FIFO_LVL_SHIFT;
+}
+
static int s3c64xx_spi_probe(struct platform_device *pdev)
{
struct resource *mem_res;
@@ -1231,6 +1261,8 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
sdd->port_id = pdev->id;
}
+ s3c64xx_spi_set_fifomask(sdd);
+
sdd->cur_bpw = 8;
sdd->tx_dma.direction = DMA_MEM_TO_DEV;
--
2.44.0.rc0.258.g7320e95886-goog
Powered by blists - more mailing lists