| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20240322144355.878930-6-prabhakar.mahadev-lad.rj@bp.renesas.com>
Date: Fri, 22 Mar 2024 14:43:55 +0000
From: Prabhakar <prabhakar.csengg@...il.com>
To: Geert Uytterhoeven <geert+renesas@...der.be>,
Greg Kroah-Hartman <gregkh@...uxfoundation.org>,
Jiri Slaby <jirislaby@...nel.org>,
Rob Herring <robh+dt@...nel.org>,
Krzysztof Kozlowski <krzysztof.kozlowski+dt@...aro.org>,
Conor Dooley <conor+dt@...nel.org>,
Magnus Damm <magnus.damm@...il.com>
Cc: linux-kernel@...r.kernel.org,
devicetree@...r.kernel.org,
linux-serial@...r.kernel.org,
linux-renesas-soc@...r.kernel.org,
Prabhakar <prabhakar.csengg@...il.com>,
Fabrizio Castro <fabrizio.castro.jz@...esas.com>,
Lad Prabhakar <prabhakar.mahadev-lad.rj@...renesas.com>
Subject: [PATCH v4 5/5] serial: sh-sci: Add support for RZ/V2H(P) SoC
From: Lad Prabhakar <prabhakar.mahadev-lad.rj@...renesas.com>
Add serial support for RZ/V2H(P) SoC with earlycon.
The SCIF interface in the Renesas RZ/V2H(P) is similar to that available
in the RZ/G2L (R9A07G044) SoC, with the following differences:
- RZ/V2H(P) SoC has three additional interrupts: one for Tx end/Rx ready
and two for Rx and Tx buffer full, all of which are edge-triggered.
- RZ/V2H(P) supports asynchronous mode, whereas RZ/G2L supports both
synchronous and asynchronous modes.
- There are differences in the configuration of certain registers such
as SCSMR, SCFCR, and SCSPTR between the two SoCs.
To handle these differences on RZ/V2H(P) SoC SCIx_RZV2H_SCIF_REGTYPE
is added.
Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@...renesas.com>
---
Hi Geert,
To keep the changes minimal I've added a new regtype instead of
port type.
Cheers, Prabhakar
v3 - > v4
- Added SCIx_RZV2H_SCIF_REGTYPE to handle the differences on the
RZ/V2H(P) SoC
v2 - > v3
- new patch
---
drivers/tty/serial/sh-sci.c | 55 +++++++++++++++++++++++++++++++++----
include/linux/serial_sci.h | 1 +
2 files changed, 51 insertions(+), 5 deletions(-)
diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c
index a85e7b9a2e49..297787dc5c1c 100644
--- a/drivers/tty/serial/sh-sci.c
+++ b/drivers/tty/serial/sh-sci.c
@@ -317,6 +317,37 @@ static const struct sci_port_params sci_port_params[SCIx_NR_REGTYPES] = {
.error_clear = SCIF_ERROR_CLEAR,
},
+ /*
+ * The "SCIF" that is in RZ/V2H(P) SoC is similar to one found on RZ/G2L SoC
+ * with below differences,
+ * - Break out of interrupts are different: ERI, BRI, RXI, TXI, TEI, DRI,
+ * TEI-DRI, RXI-EDGE and TXI-EDGE.
+ * - SCSMR register does not have CM bit (BIT(7)) ie it does not support synchronous mode.
+ * - SCFCR register does not have SCFCR_MCE bit.
+ * - SCSPTR register has only bits SCSPTR_SPB2DT and SCSPTR_SPB2IO.
+ */
+ [SCIx_RZV2H_SCIF_REGTYPE] = {
+ .regs = {
+ [SCSMR] = { 0x00, 16 },
+ [SCBRR] = { 0x02, 8 },
+ [SCSCR] = { 0x04, 16 },
+ [SCxTDR] = { 0x06, 8 },
+ [SCxSR] = { 0x08, 16 },
+ [SCxRDR] = { 0x0a, 8 },
+ [SCFCR] = { 0x0c, 16 },
+ [SCFDR] = { 0x0e, 16 },
+ [SCSPTR] = { 0x10, 16 },
+ [SCLSR] = { 0x12, 16 },
+ [SEMR] = { 0x14, 8 },
+ },
+ .fifosize = 16,
+ .overrun_reg = SCLSR,
+ .overrun_mask = SCLSR_ORER,
+ .sampling_rate_mask = SCI_SR(32),
+ .error_mask = SCIF_DEFAULT_ERROR_MASK,
+ .error_clear = SCIF_ERROR_CLEAR,
+ },
+
/*
* Common SH-3 SCIF definitions.
*/
@@ -758,7 +789,7 @@ static void sci_init_pins(struct uart_port *port, unsigned int cflag)
}
serial_port_out(port, SCPDR, data);
serial_port_out(port, SCPCR, ctrl);
- } else if (sci_getreg(port, SCSPTR)->size) {
+ } else if (sci_getreg(port, SCSPTR)->size && s->cfg->regtype != SCIx_RZV2H_SCIF_REGTYPE) {
u16 status = serial_port_in(port, SCSPTR);
/* RTS# is always output; and active low, unless autorts */
@@ -2120,8 +2151,9 @@ static void sci_set_mctrl(struct uart_port *port, unsigned int mctrl)
if (!(mctrl & TIOCM_RTS)) {
/* Disable Auto RTS */
- serial_port_out(port, SCFCR,
- serial_port_in(port, SCFCR) & ~SCFCR_MCE);
+ if (s->cfg->regtype != SCIx_RZV2H_SCIF_REGTYPE)
+ serial_port_out(port, SCFCR,
+ serial_port_in(port, SCFCR) & ~SCFCR_MCE);
/* Clear RTS */
sci_set_rts(port, 0);
@@ -2133,8 +2165,9 @@ static void sci_set_mctrl(struct uart_port *port, unsigned int mctrl)
}
/* Enable Auto RTS */
- serial_port_out(port, SCFCR,
- serial_port_in(port, SCFCR) | SCFCR_MCE);
+ if (s->cfg->regtype != SCIx_RZV2H_SCIF_REGTYPE)
+ serial_port_out(port, SCFCR,
+ serial_port_in(port, SCFCR) | SCFCR_MCE);
} else {
/* Set RTS */
sci_set_rts(port, 1);
@@ -3224,6 +3257,10 @@ static const struct of_device_id of_sci_match[] __maybe_unused = {
.compatible = "renesas,scif-r9a07g044",
.data = SCI_OF_DATA(PORT_SCIF, SCIx_RZ_SCIFA_REGTYPE),
},
+ {
+ .compatible = "renesas,scif-r9a09g057",
+ .data = SCI_OF_DATA(PORT_SCIF, SCIx_RZV2H_SCIF_REGTYPE),
+ },
/* Family-specific types */
{
.compatible = "renesas,rcar-gen1-scif",
@@ -3534,6 +3571,13 @@ static int __init rzscifa_early_console_setup(struct earlycon_device *device,
return early_console_setup(device, PORT_SCIF);
}
+static int __init rzv2hscif_early_console_setup(struct earlycon_device *device,
+ const char *opt)
+{
+ port_cfg.regtype = SCIx_RZV2H_SCIF_REGTYPE;
+ return early_console_setup(device, PORT_SCIF);
+}
+
static int __init scifa_early_console_setup(struct earlycon_device *device,
const char *opt)
{
@@ -3554,6 +3598,7 @@ OF_EARLYCON_DECLARE(sci, "renesas,sci", sci_early_console_setup);
OF_EARLYCON_DECLARE(scif, "renesas,scif", scif_early_console_setup);
OF_EARLYCON_DECLARE(scif, "renesas,scif-r7s9210", rzscifa_early_console_setup);
OF_EARLYCON_DECLARE(scif, "renesas,scif-r9a07g044", rzscifa_early_console_setup);
+OF_EARLYCON_DECLARE(scif, "renesas,scif-r9a09g057", rzv2hscif_early_console_setup);
OF_EARLYCON_DECLARE(scifa, "renesas,scifa", scifa_early_console_setup);
OF_EARLYCON_DECLARE(scifb, "renesas,scifb", scifb_early_console_setup);
OF_EARLYCON_DECLARE(hscif, "renesas,hscif", hscif_early_console_setup);
diff --git a/include/linux/serial_sci.h b/include/linux/serial_sci.h
index 1c89611e0e06..0f2f50b8d28e 100644
--- a/include/linux/serial_sci.h
+++ b/include/linux/serial_sci.h
@@ -37,6 +37,7 @@ enum {
SCIx_SH7705_SCIF_REGTYPE,
SCIx_HSCIF_REGTYPE,
SCIx_RZ_SCIFA_REGTYPE,
+ SCIx_RZV2H_SCIF_REGTYPE,
SCIx_NR_REGTYPES,
};
--
2.34.1
Powered by blists - more mailing lists