[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <ddcab8c0-3772-4134-a3bb-27729e864627@ti.com>
Date: Fri, 24 May 2024 09:13:41 -0500
From: Judith Mendez <jm@...com>
To: Nishanth Menon <nm@...com>
CC: Rob Herring <robh@...nel.org>,
Krzysztof Kozlowski
<krzysztof.kozlowski+dt@...aro.org>,
Conor Dooley <conor+dt@...nel.org>,
Catalin Marinas <catalin.marinas@....com>,
Will Deacon <will@...nel.org>,
William Breathitt Gray <william.gray@...aro.org>,
David Lechner
<david@...hnology.com>,
<linux-arm-kernel@...ts.infradead.org>, <devicetree@...r.kernel.org>,
<linux-kernel@...r.kernel.org>, <linux-iio@...r.kernel.org>,
Vignesh Raghavendra <vigneshr@...com>
Subject: Re: [PATCH v2 8/8] arm64: defconfig: Enable TI eQEP Driver
Hi Nishanth,
On 5/24/24 12:59 AM, Nishanth Menon wrote:
> On 18:15-20240523, Judith Mendez wrote:
>> TI K3 SoC's support eQEP hardware, so enable TI eQEP driver
>> to be built as a module.
>
> All the nodes seem to be only in disabled mode, is there even a single
> board that is actually using this? if so, why isn't it enabled?
I will add pinmux and enable in the board level dts file.
~ Judith
>
>>
>> Signed-off-by: Judith Mendez <jm@...com>
>> ---
>> Changes since v1:
>> - No change
>> ---
>> arch/arm64/configs/defconfig | 1 +
>> 1 file changed, 1 insertion(+)
>>
>> diff --git a/arch/arm64/configs/defconfig b/arch/arm64/configs/defconfig
>> index 2c30d617e1802..23d11a1b20195 100644
>> --- a/arch/arm64/configs/defconfig
>> +++ b/arch/arm64/configs/defconfig
>> @@ -1593,6 +1593,7 @@ CONFIG_INTERCONNECT_QCOM_SM8550=y
>> CONFIG_INTERCONNECT_QCOM_SM8650=y
>> CONFIG_INTERCONNECT_QCOM_X1E80100=y
>> CONFIG_COUNTER=m
>> +CONFIG_TI_EQEP=m
>> CONFIG_RZ_MTU3_CNT=m
>> CONFIG_HTE=y
>> CONFIG_HTE_TEGRA194=y
>> --
>> 2.45.1
>>
>
Powered by blists - more mailing lists