[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <wipu6tdqjbjlrv2sbljgzvoxvpjvkoaz6ic3keq24n3v4tap4j@entxhnd42rml>
Date: Tue, 28 May 2024 08:48:33 -0500
From: Bjorn Andersson <andersson@...nel.org>
To: Neil Armstrong <neil.armstrong@...aro.org>
Cc: Vinod Koul <vkoul@...nel.org>,
Kishon Vijay Abraham I <kishon@...nel.org>, Rob Herring <robh@...nel.org>,
Krzysztof Kozlowski <krzk+dt@...nel.org>, Conor Dooley <conor+dt@...nel.org>,
Konrad Dybcio <konrad.dybcio@...aro.org>, Krzysztof Kozlowski <krzysztof.kozlowski+dt@...aro.org>,
linux-arm-msm@...r.kernel.org, linux-phy@...ts.infradead.org, devicetree@...r.kernel.org,
linux-kernel@...r.kernel.org
Subject: Re: [PATCH v2 0/7] arm64: qcom: allow up to 4 lanes for the Type-C
DisplayPort Altmode
On Mon, May 27, 2024 at 10:42:32AM GMT, Neil Armstrong wrote:
> Register a typec mux in order to change the PHY mode on the Type-C
> mux events depending on the mode and the svid when in Altmode setup.
>
> The DisplayPort phy should be left enabled if is still powered on
> by the DRM DisplayPort controller, so bail out until the DisplayPort
> PHY is not powered off.
>
> The Type-C Mode/SVID only changes on plug/unplug, and USB SAFE states
> will be set in between of USB-Only, Combo and DisplayPort Only so
> this will leave enough time to the DRM DisplayPort controller to
> turn of the DisplayPort PHY.
>
> The patchset also includes bindings changes and DT changes.
>
> This has been successfully tested on an SM8550 board, but the
> Thinkpad X13s deserved testing between non-PD USB, non-PD DisplayPort,
> PD USB Hubs and PD Altmode Dongles to make sure the switch works
> as expected.
>
> The DisplayPort 4 lanes setup can be check with:
> $ cat /sys/kernel/debug/dri/ae01000.display-controller/DP-1/dp_debug
> name = msm_dp
> drm_dp_link
> rate = 540000
> num_lanes = 4
Has the issue with the USB controller dying on us been resolved?
Regards,
Bjorn
Powered by blists - more mailing lists