lists.openwall.net   lists  /  announce  owl-users  owl-dev  john-users  john-dev  passwdqc-users  yescrypt  popa3d-users  /  oss-security  kernel-hardening  musl  sabotage  tlsify  passwords  /  crypt-dev  xvendor  /  Bugtraq  Full-Disclosure  linux-kernel  linux-netdev  linux-ext4  linux-hardening  linux-cve-announce  PHC 
Open Source and information security mailing list archives
 
Hash Suite: Windows password security audit tool. GUI, reports in PDF.
[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-Id: <20240702040926.3327530-5-faizal.abdul.rahim@linux.intel.com>
Date: Tue,  2 Jul 2024 00:09:26 -0400
From: Faizal Rahim <faizal.abdul.rahim@...ux.intel.com>
To: "David S . Miller" <davem@...emloft.net>,
	Eric Dumazet <edumazet@...gle.com>,
	Jakub Kicinski <kuba@...nel.org>,
	Paolo Abeni <pabeni@...hat.com>,
	Jesse Brandeburg <jesse.brandeburg@...el.com>,
	Tony Nguyen <anthony.l.nguyen@...el.com>,
	Vinicius Costa Gomes <vinicius.gomes@...el.com>
Cc: intel-wired-lan@...ts.osuosl.org,
	netdev@...r.kernel.org,
	linux-kernel@...r.kernel.org,
	stable@...r.kernel.org,
	Faizal Rahim <faizal.abdul.rahim@...ux.intel.com>
Subject: [PATCH iwl-net v1 4/4] igc: Fix qbv tx latency by setting gtxoffset

A large tx latency issue was discovered during testing when only QBV was
enabled. The issue occurs because gtxoffset was not set when QBV is
active, it was only set when launch time is active.

The patch "igc: Correct the launchtime offset" only sets gtxoffset when
the launchtime_enable field is set by the user. Enabling launchtime_enable
ultimately sets the register IGC_TXQCTL_QUEUE_MODE_LAUNCHT (referred to as
LaunchT in the SW user manual).

Section 7.5.2.6 of the IGC i225/6 SW User Manual Rev 1.2.4 states:
"The latency between transmission scheduling (launch time) and the
time the packet is transmitted to the network is listed in Table 7-61."

However, the patch misinterprets the phrase "launch time" in that section
by assuming it specifically refers to the LaunchT register, whereas it
actually denotes the generic term for when a packet is released from the
internal buffer to the MAC transmit logic.

This launch time, as per that section, also implicitly refers to the QBV
gate open time, where a packet waits in the buffer for the QBV gate to
open. Therefore, latency applies whenever QBV is in use. TSN features such
as QBU and QAV reuse QBV, making the latency universal to TSN features.

Discussed with i226 HW owner (Shalev, Avi) and we were in agreement that
the term "launch time" used in Section 7.5.2.6 is not clear and can be
easily misinterpreted. Avi will update this section to:
"When TQAVCTRL.TRANSMIT_MODE = TSN, the latency between transmission
scheduling and the time the packet is transmitted to the network is listed
in Table 7-61."

Fix this issue by using igc_tsn_is_tx_mode_in_tsn() as a condition to
write to gtxoffset, aligning with the newly updated SW User Manual.

Tested:
1. Enrol taprio on talker board
   base-time 0
   cycle-time 1000000
   flags 0x2
   index 0 cmd S gatemask 0x1 interval1
   index 0 cmd S gatemask 0x1 interval2

   Note:
   interval1 = interval for a 64 bytes packet to go through
   interval2 = cycle-time - interval1

2. Take tcpdump on listener board

3. Use udp tai app on talker to send packets to listener

4. Check the timestamp on listener via wireshark

Test Result:
100 Mbps: 113 ~193 ns
1000 Mbps: 52 ~ 84 ns
2500 Mbps: 95 ~ 223 ns

Note that the test result is similar to the patch "igc: Correct the
launchtime offset".

Fixes: 790835fcc0cb ("igc: Correct the launchtime offset")
Signed-off-by: Faizal Rahim <faizal.abdul.rahim@...ux.intel.com>
---
 drivers/net/ethernet/intel/igc/igc_tsn.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/intel/igc/igc_tsn.c b/drivers/net/ethernet/intel/igc/igc_tsn.c
index 26dbe3442ad1..e95502fc844b 100644
--- a/drivers/net/ethernet/intel/igc/igc_tsn.c
+++ b/drivers/net/ethernet/intel/igc/igc_tsn.c
@@ -61,7 +61,7 @@ void igc_tsn_adjust_txtime_offset(struct igc_adapter *adapter)
 	struct igc_hw *hw = &adapter->hw;
 	u16 txoffset;
 
-	if (!is_any_launchtime(adapter))
+	if (!igc_tsn_is_tx_mode_in_tsn(adapter))
 		return;
 
 	switch (adapter->link_speed) {
-- 
2.25.1


Powered by blists - more mailing lists

Powered by Openwall GNU/*/Linux Powered by OpenVZ