[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <CACRpkdajN7RjE5LOdv_SP6rR8U-vwXHXn=kZZo7thodeMem72Q@mail.gmail.com>
Date: Fri, 5 Jul 2024 11:50:09 +0200
From: Linus Walleij <linus.walleij@...aro.org>
To: Inochi Amaoto <inochiama@...look.com>
Cc: Rob Herring <robh@...nel.org>, Krzysztof Kozlowski <krzk+dt@...nel.org>,
Conor Dooley <conor+dt@...nel.org>, Chen Wang <unicorn_wang@...look.com>,
Paul Walmsley <paul.walmsley@...ive.com>, Palmer Dabbelt <palmer@...belt.com>,
Albert Ou <aou@...s.berkeley.edu>, Jisheng Zhang <jszhang@...nel.org>, Guo Ren <guoren@...nel.org>,
Haylen Chu <heylenay@...look.com>, Drew Fustini <dfustini@...libre.com>, linux-gpio@...r.kernel.org,
devicetree@...r.kernel.org, linux-kernel@...r.kernel.org,
linux-riscv@...ts.infradead.org
Subject: Re: [PATCH 1/7] dt-bindings: pinctrl: Add pinctrl for Sophgo CV1800
series SoC.
Hi Inochi,
thanks for your patch!
Some comments below:
On Thu, Jul 4, 2024 at 7:47 AM Inochi Amaoto <inochiama@...look.com> wrote:
> Add pinctrl support for Sophgo CV1800 series SoC.
>
> Signed-off-by: Inochi Amaoto <inochiama@...look.com>
(...)
> + bias-pull-up:
> + type: boolean
description: Setting this true will result in how many Ohms of pull up
and to what voltage?
> + bias-pull-down:
> + type: boolean
How many Ohms by default? It's very helpful for designers writing the
device tree to know this.
> + drive-strength:
> + $ref: /schemas/types.yaml#/definitions/uint32
> + minimum: 0
> + maximum: 7
0,1, ... 7 ... units of what? What does the values represent?
7 mA? I think not. This should be in mA and parsed to any custom
values.
If you need more resolution, consider using driver-strength-microamp and
parse that value instead.
> + input-schmitt:
> + $ref: /schemas/types.yaml#/definitions/uint32
> + minimum: 0
> + maximum: 7
What is this custom property? We support input-schmitt-enable
and input-schmitt-disable, if you want to add a new standard property
input-schmitt, then send a separate patch to
Documentation/devicetree/bindings/pinctrl/pincfg-node.yaml
and explain what the argument means, it should be in SI units.
For a full custom property, use sophgo, prefixes.
> + slew-rate:
> + enum: [ 0, 1 ]
What is slew rate 0 and 1? What does it represent?
microvolts per second how much (I don't know, just guessing)
> + sophgo,bus-holder:
> + description: enable bus holder
This description is a bit too little, we need to know what this thing
is and what it is
used for. If it is definied in some other DT binding then reference that file.
Yours,
Linus Walleij
Powered by blists - more mailing lists