[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <kbz72jma3bj7dnfnvdjo6m5yqrvjwkvz2gtt6bxpezkslwt3kh@a7wqzkssdfvf>
Date: Fri, 30 Aug 2024 11:20:45 +0100
From: Diogo Ivo <diogo.ivo@...nico.ulisboa.pt>
To: Thierry Reding <thierry.reding@...il.com>
Cc: Rob Herring <robh@...nel.org>,
Krzysztof Kozlowski <krzk+dt@...nel.org>, Conor Dooley <conor+dt@...nel.org>,
Jonathan Hunter <jonathanh@...dia.com>, devicetree@...r.kernel.org, linux-tegra@...r.kernel.org,
linux-kernel@...r.kernel.org
Subject: Re: [PATCH 0/2] arm64: tegra: add wp-gpio to P2957 board
Hi Thierry,
On Thu, Aug 29, 2024 at 05:31:23PM GMT, Thierry Reding wrote:
> From: Thierry Reding <treding@...dia.com>
>
>
> On Thu, 15 Aug 2024 16:50:38 +0100, Diogo Ivo wrote:
> > Define the wp-gpio for the P2597 board.
> >
> > For this, patch 1 fixes the assignment of the vmmc supply's gpio that
> > was incorrectly assigned to the wp-gpio of the external slot.
> >
> > Patch 2 adds the definition of the wp-gpio.
> >
> > [...]
>
> Applied, thanks!
Thanks for picking up the patches! In my testing around SD/MMC I found that
currently UHS-I cards are broken on the P2597. When trying to use one
the system shows somewhat erratic behaviour where it sometimes hangs and
some other times it simply fails to read from the SD card. I have
tracked the point at which this happens to be around
tegra_sdhci_pad_autocalib() when switching to SDR104 mode, where there
is the possibility of using specific offsets for this mode. Currently
there are no values specified in tegra210.dtsi, so the 1.8V values are
being used. However, when I tried specifying them as
nvidia,pad-autocal-pull-up-offset-sdr104 = <0>;
nvidia,pad-autocal-pull-down-offset-sdr104 = <0>;
in the DT things started working fine. I did not send a patch with these
values since I could not find what they should be on the X1 TRM, are
there any recommended values for these parameters so that we can have
this fixed?
Diogo
Powered by blists - more mailing lists