| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20240904100506.3665892-1-danishanwar@ti.com>
Date: Wed, 4 Sep 2024 15:35:01 +0530
From: MD Danish Anwar <danishanwar@...com>
To: Jan Kiszka <jan.kiszka@...mens.com>, Andrew Lunn <andrew@...n.ch>,
Dan
Carpenter <dan.carpenter@...aro.org>,
Sai Krishna <saikrishnag@...vell.com>,
Jacob Keller <jacob.e.keller@...el.com>,
Javier Carrasco
<javier.carrasco.cruz@...il.com>,
Diogo Ivo <diogo.ivo@...mens.com>, Simon
Horman <horms@...nel.org>,
Richard Cochran <richardcochran@...il.com>,
Paolo
Abeni <pabeni@...hat.com>, Jakub Kicinski <kuba@...nel.org>,
Eric Dumazet
<edumazet@...gle.com>,
"David S. Miller" <davem@...emloft.net>
CC: Alexander Lobakin <aleksander.lobakin@...el.com>,
<linux-kernel@...r.kernel.org>, <netdev@...r.kernel.org>,
<linux-arm-kernel@...ts.infradead.org>, <srk@...com>,
Vignesh Raghavendra
<vigneshr@...com>,
Roger Quadros <rogerq@...nel.org>, <danishanwar@...com>
Subject: [PATCH net-next v4 0/5] Introduce HSR offload support for ICSSG
Hi All,
This series introduces HSR offload support for ICSSG driver. To support HSR
offload to hardware, ICSSG HSR firmware is used.
This series introduces,
1. HSR frame offload support for ICSSG driver.
2. HSR Tx Packet duplication offload
3. HSR Tx Tag and Rx Tag offload
4. Multicast filtering support in HSR offload mode.
5. Dependencies related to IEP.
HSR Test Setup:
--------------
___________ ___________ ___________
| | Link AB | | Link BC | |
__| AM64* |_________| AM64 |_________| AM64* |___
| | Station A | | Station B | | Station C | |
| |___________| |___________| |___________| |
| |
|______________________________________________________________|
Link CA
*Could be any device that supports two ethernet interfaces.
Steps to switch to HSR frame forward offload mode:
-------------------------------------------------
Example assuming eth1, eth2 ports of ICSSG1 on AM64-EVM
1) Enable HSR offload for both interfaces
ethtool -K eth1 hsr-fwd-offload on
ethtool -K eth1 hsr-dup-offload on
ethtool -K eth1 hsr-tag-ins-offload on
ethtool -K eth1 hsr-tag-rm-offload on
ethtool -K eth2 hsr-fwd-offload on
ethtool -K eth2 hsr-dup-offload on
ethtool -K eth2 hsr-tag-ins-offload on
ethtool -K eth2 hsr-tag-rm-offload on
2) Create HSR interface and add slave interfaces to it
ip link add name hsr0 type hsr slave1 eth1 slave2 eth2 \
supervision 45 version 1
3) Add IP address to the HSR interface
ip addr add <IP_ADDR>/24 dev hsr0
4) Bring up the HSR interface
ip link set hsr0 up
Switching back to previous mode:
--------------------------------
1) Delete HSR interface
ip link delete hsr0
2) Disable HSR port-to-port offloading mode, packet duplication
ethtool -K eth1 hsr-fwd-offload off
ethtool -K eth1 hsr-dup-offload off
ethtool -K eth1 hsr-tag-ins-offload off
ethtool -K eth1 hsr-tag-rm-offload off
ethtool -K eth2 hsr-fwd-offload off
ethtool -K eth2 hsr-dup-offload off
ethtool -K eth2 hsr-tag-ins-offload off
ethtool -K eth2 hsr-tag-rm-offload off
Testing the port-to-port frame forward offload feature:
-----------------------------------------------------
1) Connect the LAN cables as shown in the test setup.
2) Configure Station A and Station C in HSR non-offload mode.
3) Configure Station B is HSR offload mode.
4) Since HSR is a redundancy protocol, disconnect cable "Link CA",
to ensure frames from Station A reach Station C only through
Station B.
5) Run iperf3 Server on Station C and client on station A.
7) Check the CPU usage on Station B.
CPU usage report on Station B using mpstat when running UDP iperf3:
-------------------------------------------------------------------
1) Non-Offload case
-------------------
CPU %usr %nice %sys %iowait %irq %soft %steal %guest %idle
all 0.00 0.00 0.50 0.00 3.52 29.15 0.00 0.00 66.83
0 0.00 0.00 0.00 0.00 7.00 58.00 0.00 0.00 35.00
1 0.00 0.00 0.99 0.00 0.99 0.00 0.00 0.00 98.02
2) Offload case
---------------
CPU %usr %nice %sys %iowait %irq %soft %steal %guest %idle
all 0.00 0.00 0.00 0.00 0.50 0.00 0.00 0.00 99.50
0 0.00 0.00 0.99 0.00 0.00 0.00 0.00 0.00 99.01
1 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 100.00
Note:
1) At the very least, hsr-fwd-offload must be enabled.
Without offloading the port-to-port offload, other
HSR offloads cannot be enabled.
2) Inorder to enable hsr-tag-ins-offload, hsr-dup-offload
must also be enabled as these are tightly coupled in
the firmware implementation.
Changes from v3 to v4:
*) Simplified ndo_set_features() implementation as suggested by Roger Quadros
<rogerq@...nel.org>
*) Maintained 80 character limit per line wherever possible.
*) Returning -EOPNOTSUPP whenever offloading is not possible.
*) Changed dev_dbg() prints to netdev_dbg() as suggested by Alexander
Lobakin <aleksander.lobakin@...el.com>
*) Squashed patch [1] and [2] together as hsr tag ins is dependent on hsr
tx duplication. Also didn't add Roger's RB tag from patch [2] as the patch
is now merged with [1] in patch 4/5.
*) Implemented emac_ndo_fix_features() to make sure NETIF_F_HW_HSR_DUP is
enabled / disabled with NETIF_F_HW_HSR_TAG_INS as suggested by Roger
Quadros <rogerq@...nel.org>
*) Added Roger's RB tag to patch 5/5.
*) Modified commit message of patch 3/5 to state that driver will be back
to previously used mode once HSR is disabled.
Changes from v2 to v3:
*) Renamed APIs common to switch and hsr modes with suffix _fw_offload.
*) Returning EOPNOTSUPP in prueth_hsr_port_link() as suggested by
Andrew Lunn <andrew@...n.ch>
*) Dropped unneccassary dev_err prints and changed dev_err to dev_dbg
where applicable.
*) Renamed NETIF_PRUETH_HSR_OFFLOAD to NETIF_PRUETH_HSR_OFFLOAD_FEATURES
to make it clear it is a collection of features, not an alias for one
feature.
*) Added Kernel doc entries for @hsr_members and @is_hsr_offload_mode as
suggested by Simon Horman <horms@...nel.org>
*) Dropped patch [3] as it is no longer needed in this series. It is
already merged to net/main by commit [4].
*) Collected Reviewed-by tag from Roger Quadros <rogerq@...nel.org> for
PATCH 1/6 and PATCH 2/6.
*) Added if check for current mode before calling __dev_mc_unsync as
suggested by Roger Quadros <rogerq@...nel.org>
*) Updated commit message of PATCH 6/6 to describe handling of duplicate
discard in the driver.
Changes from v1 to v2:
*) Modified patch 2/7 to only contain code movement as suggested by
Dan Carpenter <dan.carpenter@...aro.org>
*) Added patch 3/7 by splitting it from 2/6 as the patch is not part of
code movement done in patch 2/7.
*) Rebased on latest net-next/main.
v1: https://lore.kernel.org/all/20240808110800.1281716-1-danishanwar@ti.com/
v2: https://lore.kernel.org/all/20240813074233.2473876-1-danishanwar@ti.com
v3: https://lore.kernel.org/all/20240828091901.3120935-1-danishanwar@ti.com/
[1] https://lore.kernel.org/all/20240828091901.3120935-5-danishanwar@ti.com/
[2] https://lore.kernel.org/all/20240828091901.3120935-7-danishanwar@ti.com/
[3] https://lore.kernel.org/all/20240813074233.2473876-2-danishanwar@ti.com/
[4] https://git.kernel.org/pub/scm/linux/kernel/git/netdev/net.git/commit/?id=e846be0fba85
MD Danish Anwar (4):
net: ti: icss-iep: Move icss_iep structure
net: ti: icssg-prueth: Stop hardcoding def_inc
net: ti: icssg-prueth: Add support for HSR frame forward offload
net: ti: icssg-prueth: Add multicast filtering support in HSR mode
Ravi Gunasekaran (1):
net: ti: icssg-prueth: Enable HSR Tx duplication, Tx Tag and Rx Tag
offload
drivers/net/ethernet/ti/icssg/icss_iep.c | 72 ------
drivers/net/ethernet/ti/icssg/icss_iep.h | 73 ++++++-
.../net/ethernet/ti/icssg/icssg_classifier.c | 1 +
drivers/net/ethernet/ti/icssg/icssg_common.c | 18 +-
drivers/net/ethernet/ti/icssg/icssg_config.c | 22 +-
drivers/net/ethernet/ti/icssg/icssg_config.h | 2 +
drivers/net/ethernet/ti/icssg/icssg_prueth.c | 206 +++++++++++++++++-
drivers/net/ethernet/ti/icssg/icssg_prueth.h | 9 +
8 files changed, 311 insertions(+), 92 deletions(-)
base-commit: 075e3d30e4a3da8eadd12f2f063dc8e2ea9e1f08
--
2.34.1
Powered by blists - more mailing lists