[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <20241011050518.GJ1421305@hu-shashim-hyd.qualcomm.com>
Date: Fri, 11 Oct 2024 10:35:18 +0530
From: Shiraz Hashim <quic_shashim@...cinc.com>
To: <neil.armstrong@...aro.org>
CC: Mukesh Ojha <quic_mojha@...cinc.com>,
Bjorn Andersson
<andersson@...nel.org>,
Mathieu Poirier <mathieu.poirier@...aro.org>,
"Rob
Herring" <robh@...nel.org>,
Krzysztof Kozlowski <krzk+dt@...nel.org>,
"Conor
Dooley" <conor+dt@...nel.org>,
Konrad Dybcio <konradybcio@...nel.org>,
"Bartosz Golaszewski" <bartosz.golaszewski@...aro.org>,
Manivannan Sadhasivam
<manivannan.sadhasivam@...aro.org>,
<linux-arm-msm@...r.kernel.org>, <linux-remoteproc@...r.kernel.org>,
<devicetree@...r.kernel.org>, <linux-kernel@...r.kernel.org>
Subject: Re: [PATCH 6/6] remoteproc: qcom: Enable map/unmap and SHM bridge
support
On Thu, Oct 10, 2024 at 08:57:56AM +0200, neil.armstrong@...aro.org wrote:
> On 08/10/2024 08:21, Mukesh Ojha wrote:
> > On Mon, Oct 07, 2024 at 08:22:39PM +0530, Mukesh Ojha wrote:
> > > On Mon, Oct 07, 2024 at 10:05:08AM +0200, neil.armstrong@...aro.org wrote:
> > > > On 04/10/2024 23:23, Mukesh Ojha wrote:
> > > > > For Qualcomm SoCs runnning with Qualcomm EL2 hypervisor(QHEE), IOMMU
> > > > > translation for remote processors is managed by QHEE and if the same SoC
> > > > > run under KVM, remoteproc carveout and devmem region should be IOMMU
> > > > > mapped from Linux PAS driver before remoteproc is brought up and
> > > > > unmapped once it is tear down and apart from this, SHM bridge also need
> > > > > to set up to enable memory protection on both remoteproc meta data
> > > > > memory as well as for the carveout region.
> > > > >
> > > > > Enable the support required to run Qualcomm remoteprocs on non-QHEE
> > > > > hypervisors.
> > > > >
> > > > > Signed-off-by: Mukesh Ojha <quic_mojha@...cinc.com>
> > > > > ---
> > > > > drivers/remoteproc/qcom_q6v5_pas.c | 41 +++++++++++++++++++++++++++++-
> > > > > 1 file changed, 40 insertions(+), 1 deletion(-)
> > > > >
> > > > > diff --git a/drivers/remoteproc/qcom_q6v5_pas.c b/drivers/remoteproc/qcom_q6v5_pas.c
> > > > > index ac339145e072..13bd13f1b989 100644
> > > > > --- a/drivers/remoteproc/qcom_q6v5_pas.c
> > > > > +++ b/drivers/remoteproc/qcom_q6v5_pas.c
<snip>
> > > > > + struct of_phandle_args args;
> > > > > +
> > > > > + ret = of_parse_phandle_with_args(pdev->dev.of_node, "iommus", "#iommu-cells", 0, &args);
> > > > > + if (ret < 0)
> > > > > + return ret;
> > > > > +
> > > > > + rproc->has_iommu = true;
> > > > > + adsp->sid = args.args[0];
> > > > > + of_node_put(args.np);
> > > > > + ret = adsp_devmem_init(adsp);
> > > > > + if (ret)
> > > > > + return ret;
> > > >
> > > > Why don't you get this table from the firmware like presumably
> > > > QHEE does ?
> > >
> > > Well, AFAIK, QHEE(EL2) has this information statically present
> > > and does not get it from anywhere., but will confirm this
> > > twice..
> >
> > Double confirmed, device memory region required by remoteproc is
> > statically present with QHEE.
>
> Right, in this case why those tables can't be embedded in the elf
> .resource_table like it's done with qcom_q6v5_adsp.c by calling
> rproc_elf_load_rsc_table() and let the remoteproc framework load the
> resource table and setup the devmem ssmu_map ?
Mainly for two reasons -
firmware images on platforms where we like to bring additional no-qhee
support do not have resource table.
QCOM PAS implementation for secure remoteproc supports single TZ call
of auth_and_rest that authenticates and brings remoteproc out of
reset. And we don't have provision to authenticate resource table
before it is used for devmem/iommu setup.
regards
Shiraz
Powered by blists - more mailing lists