[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <20241017032213.22256-2-SkyLake.Huang@mediatek.com>
Date: Thu, 17 Oct 2024 11:22:11 +0800
From: Sky Huang <SkyLake.Huang@...iatek.com>
To: Andrew Lunn <andrew@...n.ch>, Heiner Kallweit <hkallweit1@...il.com>,
Russell King <linux@...linux.org.uk>, "David S. Miller"
<davem@...emloft.net>, Eric Dumazet <edumazet@...gle.com>, Jakub Kicinski
<kuba@...nel.org>, Paolo Abeni <pabeni@...hat.com>, Daniel Golle
<daniel@...rotopia.org>, Qingfang Deng <dqfext@...il.com>, SkyLake Huang
<SkyLake.Huang@...iatek.com>, Matthias Brugger <matthias.bgg@...il.com>,
AngeloGioacchino Del Regno <angelogioacchino.delregno@...labora.com>, Simon
Horman <horms@...nel.org>, <linux-kernel@...r.kernel.org>,
<netdev@...r.kernel.org>, <linux-arm-kernel@...ts.infradead.org>,
<linux-mediatek@...ts.infradead.org>
CC: Steven Liu <Steven.Liu@...iatek.com>, SkyLake.Huang
<skylake.huang@...iatek.com>
Subject: [PATCH net-next v2 1/3] net: phy: mediatek-ge-soc: Fix coding style
From: "SkyLake.Huang" <skylake.huang@...iatek.com>
This patch fixes spelling errors, re-arrange vars with
reverse Xmas tree and remove unnecessary parens in
mediatek-ge-soc.c.
Signed-off-by: SkyLake.Huang <skylake.huang@...iatek.com>
---
drivers/net/phy/mediatek-ge-soc.c | 36 ++++++++++++++++---------------
1 file changed, 19 insertions(+), 17 deletions(-)
diff --git a/drivers/net/phy/mediatek-ge-soc.c b/drivers/net/phy/mediatek-ge-soc.c
index f4f9412..e9c422f 100644
--- a/drivers/net/phy/mediatek-ge-soc.c
+++ b/drivers/net/phy/mediatek-ge-soc.c
@@ -408,16 +408,17 @@ static int tx_offset_cal_efuse(struct phy_device *phydev, u32 *buf)
static int tx_amp_fill_result(struct phy_device *phydev, u16 *buf)
{
- int i;
- int bias[16] = {};
- const int vals_9461[16] = { 7, 1, 4, 7,
- 7, 1, 4, 7,
- 7, 1, 4, 7,
- 7, 1, 4, 7 };
const int vals_9481[16] = { 10, 6, 6, 10,
10, 6, 6, 10,
10, 6, 6, 10,
10, 6, 6, 10 };
+ const int vals_9461[16] = { 7, 1, 4, 7,
+ 7, 1, 4, 7,
+ 7, 1, 4, 7,
+ 7, 1, 4, 7 };
+ int bias[16] = {};
+ int i;
+
switch (phydev->drv->phy_id) {
case MTK_GPHY_ID_MT7981:
/* We add some calibration to efuse values
@@ -1069,10 +1070,10 @@ static int start_cal(struct phy_device *phydev, enum CAL_ITEM cal_item,
static int mt798x_phy_calibration(struct phy_device *phydev)
{
+ struct nvmem_cell *cell;
int ret = 0;
- u32 *buf;
size_t len;
- struct nvmem_cell *cell;
+ u32 *buf;
cell = nvmem_cell_get(&phydev->mdio.dev, "phy-cal-data");
if (IS_ERR(cell)) {
@@ -1210,14 +1211,15 @@ static int mt798x_phy_led_brightness_set(struct phy_device *phydev,
return mt798x_phy_hw_led_on_set(phydev, index, (value != LED_OFF));
}
-static const unsigned long supported_triggers = (BIT(TRIGGER_NETDEV_FULL_DUPLEX) |
- BIT(TRIGGER_NETDEV_HALF_DUPLEX) |
- BIT(TRIGGER_NETDEV_LINK) |
- BIT(TRIGGER_NETDEV_LINK_10) |
- BIT(TRIGGER_NETDEV_LINK_100) |
- BIT(TRIGGER_NETDEV_LINK_1000) |
- BIT(TRIGGER_NETDEV_RX) |
- BIT(TRIGGER_NETDEV_TX));
+static const unsigned long supported_triggers =
+ BIT(TRIGGER_NETDEV_FULL_DUPLEX) |
+ BIT(TRIGGER_NETDEV_HALF_DUPLEX) |
+ BIT(TRIGGER_NETDEV_LINK) |
+ BIT(TRIGGER_NETDEV_LINK_10) |
+ BIT(TRIGGER_NETDEV_LINK_100) |
+ BIT(TRIGGER_NETDEV_LINK_1000) |
+ BIT(TRIGGER_NETDEV_RX) |
+ BIT(TRIGGER_NETDEV_TX);
static int mt798x_phy_led_hw_is_supported(struct phy_device *phydev, u8 index,
unsigned long rules)
@@ -1415,7 +1417,7 @@ static int mt7988_phy_probe_shared(struct phy_device *phydev)
* LED_C and LED_D respectively. At the same time those pins are used to
* bootstrap configuration of the reference clock source (LED_A),
* DRAM DDRx16b x2/x1 (LED_B) and boot device (LED_C, LED_D).
- * In practise this is done using a LED and a resistor pulling the pin
+ * In practice this is done using a LED and a resistor pulling the pin
* either to GND or to VIO.
* The detected value at boot time is accessible at run-time using the
* TPBANK0 register located in the gpio base of the pinctrl, in order
--
2.45.2
Powered by blists - more mailing lists