[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <7b55c7469774c41d9896df3100df1630@manjaro.org>
Date: Mon, 13 Jan 2025 05:25:44 +0100
From: Dragan Simic <dsimic@...jaro.org>
To: Junhao Xie <bigfoot@...ssfun.cn>
Cc: devicetree@...r.kernel.org, linux-arm-kernel@...ts.infradead.org, Rob
Herring <robh@...nel.org>, Krzysztof Kozlowski <krzk+dt@...nel.org>, Conor
Dooley <conor+dt@...nel.org>, Heiko Stuebner <heiko@...ech.de>, Jonas
Karlman <jonas@...boo.se>, Chukun Pan <amadeus@....edu.cn>, FUKAUMI Naoki
<naoki@...xa.com>, linux-rockchip@...ts.infradead.org,
linux-kernel@...r.kernel.org
Subject: Re: [PATCH v6 3/3] arm64: dts: rockchip: add dts for Ariaboard
Photonicat RK3568
Hello Junhao,
On 2025-01-12 23:16, Junhao Xie wrote:
> On 2025/1/12 16:47, Dragan Simic wrote:
>> On 2025-01-12 08:33, Junhao Xie wrote:
>>> Add dts for Ariaboard Photonicat RK3568.
>>>
>>> Working IO:
>>> Debug UART
>>> SDIO QCA9377 WiFi and Bluetooth
>>> M.2 E-Key PCIe WiFi and Bluetooth
>>> M.2 B-Key USB Modem WWAN
>>> Ethernet WAN Port
>>> MicroSD Card slot
>>> eMMC
>>> HDMI Output
>>> Mali GPU
>>> USB Type-A
>>>
>>> Not working IO:
>>> Ethernet LAN Port (Lack of SGMII support)
>>> Power management MCU on UART4 (Driver pending)
>>>
>>> Not working IO in MCU:
>>> Battery voltage sensor
>>> Board temperature sensor
>>> Hardware Power-off
>>> Hardware Watchdog
>>> Network status LED
>>> Real-time clock
>>> USB Charger voltage sensor
>>>
>>> About onboard power management MCU:
>>> A heartbeat must be sent to the MCU within 60 seconds,
>>> otherwise the MCU will restart the system.
>>> When powering off, a shutdown command needs to be sent to the
>>> MCU.
>>> When the power button is long pressed, the MCU will send a
>>> shutdown
>>> command to the system. If system does not shutdown within 60
>>> seconds,
>>> the power will be turned off directly.
>>> MCU only provides voltage for charger and battery.
>>> Manufacturer removed RK8xx PMIC.
>>
>> Unless the design of the board is proprietary, it would be good
>> to provide a link to the board schematic, for those interested
>> in verifying the board DT file.
>>
>> As a note, I already tried to find the board schematic with no
>> success, so the design might be proprietary.
>
> Yes, this board is proprietary. I asked the manufacturer and
> they don't provide schematics.
>
> But I found a partial schematic diagram of some of connectors
> on the board here
> https://dl.ariaboard.com/photonicat_rk3568/Photonicat%20rk3568%20EVB%20Board%20spec.pdf
Yes, I also found that PDF file. It's somewhat similar to what
Raspberry Pi provides with its reduced schematics -- helpful to
an extent, but still leaving a lot to be desired.
Out of curiosity, what did you actually use as a reference to create
the board dts file? Perhaps some downstream dts file provided by
the manufacturer or found in some operating system image?
Powered by blists - more mailing lists