[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-ID: <20250329190132.855196-1-martin.blumenstingl@googlemail.com>
Date: Sat, 29 Mar 2025 20:01:32 +0100
From: Martin Blumenstingl <martin.blumenstingl@...glemail.com>
To: linux-amlogic@...ts.infradead.org,
linux-gpio@...r.kernel.org
Cc: linux-kernel@...r.kernel.org,
linux-arm-kernel@...ts.infradead.org,
linus.walleij@...aro.org,
Martin Blumenstingl <martin.blumenstingl@...glemail.com>
Subject: [PATCH] pinctrl: meson: define the pull up/down resistor value as 60 kOhm
The public datasheets of the following Amlogic SoCs describe a typical
resistor value for the built-in pull up/down resistor:
- Meson8/8b/8m2: not documented
- GXBB (S905): 60 kOhm
- GXL (S905X): 60 kOhm
- GXM (S912): 60 kOhm
- G12B (S922X): 60 kOhm
- SM1 (S905D3): 60 kOhm
The public G12B and SM1 datasheets additionally state min and max
values:
- min value: 50 kOhm for both, pull-up and pull-down
- max value for the pull-up: 70 kOhm
- max value for the pull-down: 130 kOhm
Use 60 kOhm in the pinctrl-meson driver as well so it's shown in the
debugfs output. It may not be accurate for Meson8/8b/8m2 but in reality
60 kOhm is closer to the actual value than 1 Ohm.
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@...glemail.com>
---
drivers/pinctrl/meson/pinctrl-meson.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/pinctrl/meson/pinctrl-meson.c b/drivers/pinctrl/meson/pinctrl-meson.c
index 253a0cc57e39..e5a32a0532ee 100644
--- a/drivers/pinctrl/meson/pinctrl-meson.c
+++ b/drivers/pinctrl/meson/pinctrl-meson.c
@@ -487,7 +487,7 @@ static int meson_pinconf_get(struct pinctrl_dev *pcdev, unsigned int pin,
case PIN_CONFIG_BIAS_PULL_DOWN:
case PIN_CONFIG_BIAS_PULL_UP:
if (meson_pinconf_get_pull(pc, pin) == param)
- arg = 1;
+ arg = 60000;
else
return -EINVAL;
break;
--
2.49.0
Powered by blists - more mailing lists