[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-Id: <20250423-flexspipatch-v1-2-292e530509d3@nxp.com>
Date: Wed, 23 Apr 2025 14:11:39 +0800
From: Haibo Chen <haibo.chen@....com>
To: Haibo Chen <haibo.chen@....com>, Han Xu <han.xu@....com>,
Yogesh Gaur <yogeshgaur.83@...il.com>, Mark Brown <broonie@...nel.org>
Cc: linux-spi@...r.kernel.org, imx@...ts.linux.dev,
linux-kernel@...r.kernel.org
Subject: [PATCH v1 2/5] spi: spi-nxp-fspi: enable runtime pm for fspi
Enable the runtime PM in fspi driver.
Also for system PM, On some board like i.MX8ULP-EVK board,
after system suspend, IOMUX module will lost power, so all
the pinctrl setting will lost when system resume back, need
driver to save/restore the pinctrl setting.
Signed-off-by: Han Xu <han.xu@....com>
Signed-off-by: Haibo Chen <haibo.chen@....com>
---
drivers/spi/spi-nxp-fspi.c | 93 ++++++++++++++++++++++++++++++++++++++--------
1 file changed, 77 insertions(+), 16 deletions(-)
diff --git a/drivers/spi/spi-nxp-fspi.c b/drivers/spi/spi-nxp-fspi.c
index 00da184be88a026bf562c9808e18e2335a0959e9..23099e60b6fb7e899f95fa0427208b33bc5522ac 100644
--- a/drivers/spi/spi-nxp-fspi.c
+++ b/drivers/spi/spi-nxp-fspi.c
@@ -48,6 +48,8 @@
#include <linux/mutex.h>
#include <linux/of.h>
#include <linux/platform_device.h>
+#include <linux/pinctrl/consumer.h>
+#include <linux/pm_runtime.h>
#include <linux/pm_qos.h>
#include <linux/regmap.h>
#include <linux/sizes.h>
@@ -57,6 +59,9 @@
#include <linux/spi/spi.h>
#include <linux/spi/spi-mem.h>
+/* runtime pm timeout */
+#define FSPI_RPM_TIMEOUT 50 /* 50ms */
+
/* Registers used by the driver */
#define FSPI_MCR0 0x00
#define FSPI_MCR0_AHB_TIMEOUT(x) ((x) << 24)
@@ -394,6 +399,8 @@ struct nxp_fspi {
struct mutex lock;
struct pm_qos_request pm_qos_req;
int selected;
+#define FSPI_NEED_INIT (1 << 0)
+ int flags;
};
static inline int needs_ip_only(struct nxp_fspi *f)
@@ -927,6 +934,13 @@ static int nxp_fspi_exec_op(struct spi_mem *mem, const struct spi_mem_op *op)
mutex_lock(&f->lock);
+ err = pm_runtime_get_sync(f->dev);
+ if (err < 0) {
+ mutex_unlock(&f->lock);
+ dev_err(f->dev, "Failed to enable clock %d\n", __LINE__);
+ return err;
+ }
+
/* Wait for controller being ready. */
err = fspi_readl_poll_tout(f, f->iobase + FSPI_STS0,
FSPI_STS0_ARB_IDLE, 1, POLL_TOUT, true);
@@ -955,8 +969,10 @@ static int nxp_fspi_exec_op(struct spi_mem *mem, const struct spi_mem_op *op)
/* Invalidate the data in the AHB buffer. */
nxp_fspi_invalid(f);
- mutex_unlock(&f->lock);
+ pm_runtime_mark_last_busy(f->dev);
+ pm_runtime_put_autosuspend(f->dev);
+ mutex_unlock(&f->lock);
return err;
}
@@ -1216,9 +1232,14 @@ static int nxp_fspi_probe(struct platform_device *pdev)
if (irq < 0)
return dev_err_probe(dev, irq, "Failed to get irq source");
- ret = nxp_fspi_clk_prep_enable(f);
- if (ret)
- return dev_err_probe(dev, ret, "Can't enable the clock\n");
+ pm_runtime_enable(dev);
+ pm_runtime_set_autosuspend_delay(dev, FSPI_RPM_TIMEOUT);
+ pm_runtime_use_autosuspend(dev);
+
+ /* enable clock */
+ ret = pm_runtime_get_sync(f->dev);
+ if (ret < 0)
+ return dev_err_probe(dev, ret, "Failed to enable clock");
/* Clear potential interrupts */
reg = fspi_readl(f, f->iobase + FSPI_INTR);
@@ -1227,12 +1248,14 @@ static int nxp_fspi_probe(struct platform_device *pdev)
nxp_fspi_default_setup(f);
+ ret = pm_runtime_put_sync(dev);
+ if (ret < 0)
+ return dev_err_probe(dev, ret, "Failed to disable clock");
+
ret = devm_request_irq(dev, irq,
nxp_fspi_irq_handler, 0, pdev->name, f);
- if (ret) {
- nxp_fspi_clk_disable_unprep(f);
+ if (ret)
return dev_err_probe(dev, ret, "Failed to request irq\n");
- }
devm_mutex_init(dev, &f->lock);
@@ -1249,29 +1272,72 @@ static void nxp_fspi_remove(struct platform_device *pdev)
{
struct nxp_fspi *f = platform_get_drvdata(pdev);
+ /* enable clock first since there is reigster access */
+ pm_runtime_get_sync(f->dev);
+
/* disable the hardware */
fspi_writel(f, FSPI_MCR0_MDIS, f->iobase + FSPI_MCR0);
+ pm_runtime_disable(f->dev);
+ pm_runtime_put_noidle(f->dev);
nxp_fspi_clk_disable_unprep(f);
if (f->ahb_addr)
iounmap(f->ahb_addr);
}
-static int nxp_fspi_suspend(struct device *dev)
+#ifdef CONFIG_PM
+static int nxp_fspi_runtime_suspend(struct device *dev)
{
+ struct nxp_fspi *f = dev_get_drvdata(dev);
+
+ nxp_fspi_clk_disable_unprep(f);
+
return 0;
}
-static int nxp_fspi_resume(struct device *dev)
+static int nxp_fspi_runtime_resume(struct device *dev)
{
struct nxp_fspi *f = dev_get_drvdata(dev);
+ int ret;
- nxp_fspi_default_setup(f);
+ ret = nxp_fspi_clk_prep_enable(f);
+ if (ret)
+ return ret;
- return 0;
+ if (f->flags & FSPI_NEED_INIT) {
+ nxp_fspi_default_setup(f);
+ ret = pinctrl_pm_select_default_state(dev);
+ if (ret)
+ dev_err(dev, "select flexspi default pinctrl failed!\n");
+ f->flags &= ~FSPI_NEED_INIT;
+ }
+
+ return ret;
}
+static int nxp_fspi_suspend(struct device *dev)
+{
+ struct nxp_fspi *f = dev_get_drvdata(dev);
+ int ret;
+
+ ret = pinctrl_pm_select_sleep_state(dev);
+ if (ret) {
+ dev_err(dev, "select flexspi sleep pinctrl failed!\n");
+ return ret;
+ }
+
+ f->flags |= FSPI_NEED_INIT;
+
+ return pm_runtime_force_suspend(dev);
+}
+#endif /* CONFIG_PM */
+
+static const struct dev_pm_ops nxp_fspi_pm_ops = {
+ SET_RUNTIME_PM_OPS(nxp_fspi_runtime_suspend, nxp_fspi_runtime_resume, NULL)
+ SET_SYSTEM_SLEEP_PM_OPS(nxp_fspi_suspend, pm_runtime_force_resume)
+};
+
static const struct of_device_id nxp_fspi_dt_ids[] = {
{ .compatible = "nxp,lx2160a-fspi", .data = (void *)&lx2160a_data, },
{ .compatible = "nxp,imx8mm-fspi", .data = (void *)&imx8mm_data, },
@@ -1291,11 +1357,6 @@ static const struct acpi_device_id nxp_fspi_acpi_ids[] = {
MODULE_DEVICE_TABLE(acpi, nxp_fspi_acpi_ids);
#endif
-static const struct dev_pm_ops nxp_fspi_pm_ops = {
- .suspend = nxp_fspi_suspend,
- .resume = nxp_fspi_resume,
-};
-
static struct platform_driver nxp_fspi_driver = {
.driver = {
.name = "nxp-fspi",
--
2.34.1
Powered by blists - more mailing lists