[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <CAHp75VeMqyhxsaR32up7d-+SeveZiV=XR4dE4Huqje2FLa+0ng@mail.gmail.com>
Date: Sun, 1 Jun 2025 22:12:05 +0300
From: Andy Shevchenko <andy.shevchenko@...il.com>
To: Lothar Rubusch <l.rubusch@...il.com>
Cc: jic23@...nel.org, dlechner@...libre.com, nuno.sa@...log.com,
andy@...nel.org, corbet@....net, lucas.p.stankus@...il.com, lars@...afoo.de,
Michael.Hennerich@...log.com, bagasdotme@...il.com, linux-iio@...r.kernel.org,
linux-doc@...r.kernel.org, linux-kernel@...r.kernel.org
Subject: Re: [PATCH v4 04/11] iio: accel: adxl313: add function to enable measurement
On Sun, Jun 1, 2025 at 8:21 PM Lothar Rubusch <l.rubusch@...il.com> wrote:
>
> Rework controlling measurement and standby of the sensor. Therefore,
> replace writing the register directly by encapsulating this and dealing
> with the return value in a separte function to enable and disable
separate
(Please, go with a spell check before sending a new version)
> measurement. This will help to avoid redundant code in all locations
> where the sensor configuration needs to be adjusted, thus measurement will
> be set to standby, in follow up patches.
>
> Further, reduce the control mask to only the measurement bit. The sleep bit
> actually controls a different behavior (not just putting the sensor to
> standby for configuration, but turning it into sleep mode) and it is not
> used so far. In consequence, there is no need to cover sleep bit and
cover the sleep
> measurement with the same mask.
--
With Best Regards,
Andy Shevchenko
Powered by blists - more mailing lists