[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <13821245.uLZWGnKmhe@jernej-laptop>
Date: Wed, 13 Aug 2025 17:27:58 +0200
From: Jernej Škrabec <jernej.skrabec@...il.com>
To: Andrew Lunn <andrew+netdev@...n.ch>,
"David S. Miller" <davem@...emloft.net>, Eric Dumazet <edumazet@...gle.com>,
Jakub Kicinski <kuba@...nel.org>, Paolo Abeni <pabeni@...hat.com>,
Rob Herring <robh@...nel.org>, Krzysztof Kozlowski <krzk+dt@...nel.org>,
Conor Dooley <conor+dt@...nel.org>, Chen-Yu Tsai <wens@...e.org>,
Jernej Skrabec <jernej@...nel.org>, Samuel Holland <samuel@...lland.org>,
Chen-Yu Tsai <wens@...nel.org>
Cc: netdev@...r.kernel.org, devicetree@...r.kernel.org,
linux-arm-kernel@...ts.infradead.org, linux-sunxi@...ts.linux.dev,
linux-kernel@...r.kernel.org, Andre Przywara <andre.przywara@....com>
Subject:
Re: [PATCH net-next v2 09/10] arm64: dts: allwinner: t527: avaota-a1: enable
second Ethernet port
Dne sreda, 13. avgust 2025 ob 16:55:39 Srednjeevropski poletni čas je Chen-Yu Tsai napisal(a):
> From: Chen-Yu Tsai <wens@...e.org>
>
> On the Avaota A1 board, the second Ethernet controller, aka the GMAC200,
> is connected to a second external RTL8211F-CG PHY. The PHY uses an
> external 25MHz crystal, and has the SoC's PJ16 pin connected to its
> reset pin.
>
> Enable the second Ethernet port. Also fix up the label for the existing
> external PHY connected to the first Ethernet port.
>
> Signed-off-by: Chen-Yu Tsai <wens@...e.org>
Acked-by: Jernej Skrabec <jernej.skrabec@...il.com>
Best regards,
Jernej
> ---
>
> Changes since v1:
> - Switch to generic (tx|rx)-internal-delay-ps properties
> ---
> .../dts/allwinner/sun55i-t527-avaota-a1.dts | 26 +++++++++++++++++--
> 1 file changed, 24 insertions(+), 2 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/allwinner/sun55i-t527-avaota-a1.dts b/arch/arm64/boot/dts/allwinner/sun55i-t527-avaota-a1.dts
> index e7713678208d..f540965ffaa4 100644
> --- a/arch/arm64/boot/dts/allwinner/sun55i-t527-avaota-a1.dts
> +++ b/arch/arm64/boot/dts/allwinner/sun55i-t527-avaota-a1.dts
> @@ -13,6 +13,7 @@ / {
>
> aliases {
> ethernet0 = &gmac0;
> + ethernet1 = &gmac1;
> serial0 = &uart0;
> };
>
> @@ -67,7 +68,7 @@ &ehci1 {
>
> &gmac0 {
> phy-mode = "rgmii-id";
> - phy-handle = <&ext_rgmii_phy>;
> + phy-handle = <&ext_rgmii0_phy>;
> phy-supply = <®_dcdc4>;
>
> allwinner,tx-delay-ps = <100>;
> @@ -76,13 +77,24 @@ &gmac0 {
> status = "okay";
> };
>
> +&gmac1 {
> + phy-mode = "rgmii-id";
> + phy-handle = <&ext_rgmii1_phy>;
> + phy-supply = <®_dcdc4>;
> +
> + tx-internal-delay-ps = <100>;
> + rx-internal-delay-ps = <100>;
> +
> + status = "okay";
> +};
> +
> &gpu {
> mali-supply = <®_dcdc2>;
> status = "okay";
> };
>
> &mdio0 {
> - ext_rgmii_phy: ethernet-phy@1 {
> + ext_rgmii0_phy: ethernet-phy@1 {
> compatible = "ethernet-phy-ieee802.3-c22";
> reg = <1>;
> reset-gpios = <&pio 7 8 GPIO_ACTIVE_LOW>; /* PH8 */
> @@ -91,6 +103,16 @@ ext_rgmii_phy: ethernet-phy@1 {
> };
> };
>
> +&mdio1 {
> + ext_rgmii1_phy: ethernet-phy@1 {
> + compatible = "ethernet-phy-ieee802.3-c22";
> + reg = <1>;
> + reset-gpios = <&pio 9 16 GPIO_ACTIVE_LOW>; /* PJ16 */
> + reset-assert-us = <10000>;
> + reset-deassert-us = <150000>;
> + };
> +};
> +
> &mmc0 {
> vmmc-supply = <®_cldo3>;
> cd-gpios = <&pio 5 6 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>; /* PF6 */
>
Powered by blists - more mailing lists