linux-kernel - Re: [PATCH v3 00/14] spi: airoha: driver fixes & improvements

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [day] [month] [year] [list]

Message-ID: <f846056f-b6d7-4503-b23f-672039fc3fc4@iopsys.eu>
Date: Thu, 21 Aug 2025 15:24:33 +0300
From: Mikhail Kshevetskiy <mikhail.kshevetskiy@...sys.eu>
To: Lorenzo Bianconi <lorenzo@...nel.org>
Cc: Ray Liu <ray.liu@...oha.com>, Mark Brown <broonie@...nel.org>,
 linux-arm-kernel@...ts.infradead.org, linux-spi@...r.kernel.org,
 linux-kernel@...r.kernel.org, Frieder Schrempf <frieder.schrempf@...tron.de>
Subject: Re: [PATCH v3 00/14] spi: airoha: driver fixes & improvements


On 21.08.2025 14:34, Lorenzo Bianconi wrote:
>> On 21.08.2025 09:58, Lorenzo Bianconi wrote:
>>>> This patch series greatly improve airoha snfi driver and fix a
>>>> number of serious bug.
>>>>
>>>> Fixed bugs:
>>>>  * Fix reading/writing of flashes with more than one plane per lun
>>>>  * Fix inability to read/write oob area
>>>>  * Fill the buffer with 0xff before writing
>>>>  * Fix reading of flashes supporting continuous reading mode
>>>>  * Fix error paths
>>>>
>>>> Improvements:
>>>>  * Add support of dual/quad wires spi modes in exec_op().
>>>>  * Support of dualio/quadio flash reading commands
>>>>  * Remove dirty hack that reads flash page settings from SNFI registers
>>>>    during driver startup
>>>>
>>>> Unfortunately I am unable to test the driver with linux at the moment,
>>>> so only the following testing was done:
>>> It seems to me this is quite an important rework of the driver. I would prefer
>>> to have some test results for this series. Are you able to run mtd_test kernel
>>> module for testing?
>> I'll try to build latest openwrt with this patches  and mtd_test kernel
>> module and try it on one of our boards.
> what board are you using for testing? If it is based on Airoha-7581 you could
> use the following repo for testing.
>
> https://github.com/Ansuel/openwrt/tree/openwrt-24.10-airoha-an7581-stable
>
> Regards,
> Lorenzo
>
yes, it's based on Airoha-7581

>> Actually patches can be divided on to parts:
>> * fixes of current driver (patches 1-10)
>> * change of behavior to avoid reading flash page settings from SNFI
>> registers during driver startup (patches 11-14)
>>
>> The changes are based on the code we are using for more than 3 years. I
>> adapt it to latest linux/u-boot code.
>>
>> Up to now the only known issue appears on en7523 chips only. Here a
>> corresponding patch description (not added to this series)
>> ====================================================== spi: airoha:
>> en7523: workaround flash damaging if UART_TXD was short to GND We found
>> that some serial console may pull TX line to GROUND during board boot
>> time. Airoha uses TX line as one of it's BOOT pins. This will lead to
>> booting in RESERVED boot mode. It was found that some flashes operates
>> incorrectly in RESERVED mode. Micron and Skyhigh flashes are definitely
>> affected by the issue, Winbond flashes are NOT affected. Details:
>> -------- DMA reading of odd pages on affected flashes operates
>> incorrectly. Page reading offset (start of the page) on hardware level
>> is replaced by 0x10. Thus results in incorrect data reading. Usage of
>> UBI make things even worse. Any attempt to access UBI leads to ubi
>> damaging. As result OS loading becomes impossible. Non-DMA reading is
>> OK. =======================================================
>>
>> Regards,
>> Mikhail
>>
>>
>>> Regards,
>>> Lorenzo
>>>
>>>>  * Driver compiles without error.
>>>>  * All changes were tested with corresponding u-boot driver. U-Boot
>>>>    SpiNAND driver was modified as well to match linux-6.17-rc2 with
>>>>    additional fixes for continuous mode.
>>>>
>>>> Changes v2:
>>>>  * minor fix
>>>>  * add comments to code
>>>>
>>>> Changes v3:
>>>>  * add patch to prevent continuous reading
>>>>
>>>> Mikhail Kshevetskiy (14):
>>>>   spi: airoha: return an error for continuous mode dirmap creation cases
>>>>   spi: airoha: remove unnecessary restriction length
>>>>   spi: airoha: add support of dual/quad wires spi modes
>>>>   spi: airoha: remove unnecessary switch to non-dma mode
>>>>   spi: airoha: unify dirmap read/write code
>>>>   spi: airoha: switch back to non-dma mode in the case of error
>>>>   spi: airoha: fix reading/writing of flashes with more than one plane
>>>>     per lun
>>>>   spi: airoha: support of dualio/quadio flash reading commands
>>>>   spi: airoha: allow reading/writing of oob area
>>>>   spi: airoha: buffer must be 0xff-ed before writing
>>>>   spi: airoha: avoid setting of page/oob sizes in REG_SPI_NFI_PAGEFMT
>>>>   spi: airoha: reduce the number of modification of REG_SPI_NFI_CNFG and
>>>>     REG_SPI_NFI_SECCUS_SIZE registers
>>>>   spi: airoha: set custom sector size equal to flash page size
>>>>   spi: airoha: avoid reading flash page settings from SNFI registers
>>>>     during driver startup
>>>>
>>>>  drivers/spi/spi-airoha-snfi.c | 508 +++++++++++++++++-----------------
>>>>  1 file changed, 260 insertions(+), 248 deletions(-)
>>>>
>>>> -- 
>>>> 2.50.1
>>>>