linux-kernel - Re: [PATCH v7 2/2] drm: bridge: Add TI tmds181 and sn65dp159 driver

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [day] [month] [year] [list]

Message-ID: <lq2etybizdf3jqregv2gj64u3kwdtmz3ly23c7wy4chjue7agx@2n6ehezkahz3>
Date: Mon, 13 Oct 2025 23:59:10 +0300
From: Dmitry Baryshkov <dmitry.baryshkov@....qualcomm.com>
To: Mike Looijmans <mike.looijmans@...ic.nl>
Cc: dri-devel@...ts.freedesktop.org, Andrzej Hajda <andrzej.hajda@...el.com>,
        David Airlie <airlied@...il.com>,
        Jernej Skrabec <jernej.skrabec@...il.com>,
        Jonas Karlman <jonas@...boo.se>,
        Laurent Pinchart <Laurent.pinchart@...asonboard.com>,
        Maarten Lankhorst <maarten.lankhorst@...ux.intel.com>,
        Maxime Ripard <mripard@...nel.org>,
        Neil Armstrong <neil.armstrong@...aro.org>,
        Robert Foss <rfoss@...nel.org>, Simona Vetter <simona@...ll.ch>,
        Thomas Zimmermann <tzimmermann@...e.de>, linux-kernel@...r.kernel.org
Subject: Re: [PATCH v7 2/2] drm: bridge: Add TI tmds181 and sn65dp159 driver

On Mon, Oct 13, 2025 at 04:36:50PM +0200, Mike Looijmans wrote:
> The tmds181 and sn65dp159 are "retimers" and hence can be considered
> HDMI-to-HDMI bridges. Typical usage is to convert the output of an
> FPGA into a valid HDMI signal, and it will typically be inserted
> between an encoder and hdmi-connector.
> 
> Signed-off-by: Mike Looijmans <mike.looijmans@...ic.nl>
> ---
> 
> Changes in v7:
> Add DRM_DISPLAY_HELPER to Kconfig
> 
> Changes in v6:
> Add DRM_DISPLAY_HDMI_HELPER to Kconfig
> Change "ti,mode" to "ti,retimer-mode"
> 
> Changes in v5:
> Really added vcc/vdd regulator support
> "oe" gpio is now "reset" (reversed logic)
> devicetree enums ti,equalizer and ti,mode
> Always disable HDMI_SEL (formerly "dvi-mode")
> 
> Changes in v4:
> dev_err_probe, this_module, of_match_ptr
> Use fallback compatible
> Add vcc-supply and vdd-supply
> 
> Changes in v3:
> Lower-case hex values and use defines for EYESCAN registers
> Remove equalizer code (unlikely to be used)
> Remove attributes (no longer useful, undocumented)
> Fix build for 6.17 kernel
> Use devm_drm_bridge_alloc
> Sort includes and add linux/bitfield.h
> Check chip type and complain on mismatch
> 
> Changes in v2:
> Use atomic_enable/disable
> Use #defines for bit fields in registers
> Allow HDMI 2 compliance
> Filter modes on clock range
> Use cross-over pixel frequency instead of manual overides
> Devicetree bindings according to standards
> 
>  drivers/gpu/drm/bridge/Kconfig      |  13 +
>  drivers/gpu/drm/bridge/Makefile     |   1 +
>  drivers/gpu/drm/bridge/ti-tmds181.c | 427 ++++++++++++++++++++++++++++
>  3 files changed, 441 insertions(+)
>  create mode 100644 drivers/gpu/drm/bridge/ti-tmds181.c
> 

Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@....qualcomm.com>


-- 
With best wishes
Dmitry