| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20260120203905.23805-4-eichest@gmail.com>
Date: Tue, 20 Jan 2026 21:30:04 +0100
From: Stefan Eichenberger <eichest@...il.com>
To: andrew+netdev@...n.ch,
davem@...emloft.net,
edumazet@...gle.com,
kuba@...nel.org,
pabeni@...hat.com,
mcoquelin.stm32@...il.com,
alexandre.torgue@...s.st.com,
shawnguo@...nel.org,
s.hauer@...gutronix.de,
kernel@...gutronix.de,
festevam@...il.com,
hkallweit1@...il.com,
linux@...linux.org.uk,
linux-stm32@...md-mailman.stormreply.com,
maxime.chevallier@...tlin.com,
francesco.dolcini@...adex.com
Cc: netdev@...r.kernel.org,
linux-arm-kernel@...ts.infradead.org,
imx@...ts.linux.dev,
linux-kernel@...r.kernel.org,
Stefan Eichenberger <stefan.eichenberger@...adex.com>
Subject: [PATCH net-next v3 3/3] net: stmmac: dwmac-imx: keep preamble before sfd on i.MX8MP
From: Stefan Eichenberger <stefan.eichenberger@...adex.com>
The stmmac implementation used by NXP for the i.MX8MP SoC is subject to
errata ERR050694. According to this errata, when no preamble byte is
transferred before the SFD from the PHY to the MAC, the MAC will discard
the frame.
Setting the PHY_F_KEEP_PREAMBLE_BEFORE_SFD flag instructs PHYs that
support it to keep the preamble byte before the SFD. This ensures that
the MAC successfully receives frames.
As this is an issue in the MAC implementation, only enable the flag for
the i.MX8MP SoC where the errata applies but not for other SoCs using a
working stmmac implementation.
The exact wording of the errata ERR050694 from NXP:
The IEEE 802.3 standard states that, in MII/GMII modes, the byte
preceding the SFD (0xD5), SMD-S (0xE6,0x4C, 0x7F, or 0xB3), or SMD-C
(0x61, 0x52, 0x9E, or 0x2A) byte can be a non-PREAMBLE byte or there can
be no preceding preamble byte. The MAC receiver must successfully
receive a packet without any preamble(0x55) byte preceding the SFD,
SMD-S, or SMD-C byte.
However due to the defect, in configurations where frame preemption is
enabled, when preamble byte does not precede the SFD, SMD-S, or SMD-C
byte, the received packet is discarded by the MAC receiver. This is
because, the start-of-packet detection logic of the MAC receiver
incorrectly checks for a preamble byte.
NXP refers to IEEE 802.3 where in clause 35.2.3.2.2 Receive case (GMII)
they show two tables one where the preamble is preceding the SFD and one
where it is not. The text says:
The operation of 1000 Mb/s PHYs can result in shrinkage of the preamble
between transmission at the source GMII and reception at the destination
GMII. Table 35-3 depicts the case where no preamble bytes are conveyed
across the GMII. This case may not be possible with a specific PHY, but
illustrates the minimum preamble with which MAC shall be able to
operate. Table 35-4 depicts the case where the entire preamble is
conveyed across the GMII.
This workaround was tested on a Verdin iMX8MP by enforcing 10 MBit/s:
ethtool -s end0 speed 10
Without keeping the preamble, no packet were received. With keeping the
preamble, everything worked as expected.
Signed-off-by: Stefan Eichenberger <stefan.eichenberger@...adex.com>
---
drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c | 6 +++++-
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 8 +++++++-
include/linux/stmmac.h | 1 +
3 files changed, 13 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c
index db288fbd5a4df..c722ff2dc1fcb 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c
@@ -320,6 +320,9 @@ static int imx_dwmac_probe(struct platform_device *pdev)
if (data->flags & STMMAC_FLAG_HWTSTAMP_CORRECT_LATENCY)
plat_dat->flags |= STMMAC_FLAG_HWTSTAMP_CORRECT_LATENCY;
+ if (data->flags & STMMAC_FLAG_KEEP_PREAMBLE_BEFORE_SFD)
+ plat_dat->flags |= STMMAC_FLAG_KEEP_PREAMBLE_BEFORE_SFD;
+
/* Default TX Q0 to use TSO and rest TXQ for TBS */
for (int i = 1; i < plat_dat->tx_queues_to_use; i++)
plat_dat->tx_queues_cfg[i].tbs_en = 1;
@@ -355,7 +358,8 @@ static struct imx_dwmac_ops imx8mp_dwmac_data = {
.addr_width = 34,
.mac_rgmii_txclk_auto_adj = false,
.set_intf_mode = imx8mp_set_intf_mode,
- .flags = STMMAC_FLAG_HWTSTAMP_CORRECT_LATENCY,
+ .flags = STMMAC_FLAG_HWTSTAMP_CORRECT_LATENCY |
+ STMMAC_FLAG_KEEP_PREAMBLE_BEFORE_SFD,
};
static struct imx_dwmac_ops imx8dxl_dwmac_data = {
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index da206b24aaed9..08a6082fc0c02 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -1205,6 +1205,7 @@ static int stmmac_init_phy(struct net_device *dev)
struct fwnode_handle *phy_fwnode;
struct fwnode_handle *fwnode;
struct ethtool_keee eee;
+ u32 dev_flags = 0;
int ret;
if (!phylink_expects_phy(priv->phylink))
@@ -1223,6 +1224,9 @@ static int stmmac_init_phy(struct net_device *dev)
else
phy_fwnode = NULL;
+ if (priv->plat->flags & STMMAC_FLAG_KEEP_PREAMBLE_BEFORE_SFD)
+ dev_flags |= PHY_F_KEEP_PREAMBLE_BEFORE_SFD;
+
/* Some DT bindings do not set-up the PHY handle. Let's try to
* manually parse it
*/
@@ -1241,10 +1245,12 @@ static int stmmac_init_phy(struct net_device *dev)
return -ENODEV;
}
+ phydev->dev_flags |= dev_flags;
+
ret = phylink_connect_phy(priv->phylink, phydev);
} else {
fwnode_handle_put(phy_fwnode);
- ret = phylink_fwnode_phy_connect(priv->phylink, fwnode, 0);
+ ret = phylink_fwnode_phy_connect(priv->phylink, fwnode, dev_flags);
}
if (ret) {
diff --git a/include/linux/stmmac.h b/include/linux/stmmac.h
index f1054b9c2d8ac..e308c98c7bd33 100644
--- a/include/linux/stmmac.h
+++ b/include/linux/stmmac.h
@@ -191,6 +191,7 @@ enum dwmac_core_type {
#define STMMAC_FLAG_EN_TX_LPI_CLOCKGATING BIT(11)
#define STMMAC_FLAG_EN_TX_LPI_CLK_PHY_CAP BIT(12)
#define STMMAC_FLAG_HWTSTAMP_CORRECT_LATENCY BIT(13)
+#define STMMAC_FLAG_KEEP_PREAMBLE_BEFORE_SFD BIT(14)
struct mac_device_info;
--
2.51.0
Powered by blists - more mailing lists