ACPI: PCI Interrupt 0000:0c:00.0[A] -> GSI 17 (level, low) -> IRQ 17
PCI: Setting latency timer of device 0000:0c:00.0 to 64
ssb: Core 0 found: cc 0800, rev 11, vendor 4243
ssb: Core 1 found: cc 0812, rev 0A, vendor 4243
ssb: Core 2 found: cc 0817, rev 03, vendor 4243
ssb: Core 3 found: cc 0820, rev 01, vendor 4243
bcm43xx_d80211: Broadcom 4311 WLAN found
ssb: Switching to core 3
ssb: Switching to core 1
bcm43xx_d80211: PHY connected
bcm43xx_d80211: Detected PHY: Version: 4, Type 2, Revision 8
bcm43xx_d80211: Detected Radio: ID: 2205017f (Manuf: 17f Ver: 2050 Rev: 2)
bcm43xx_d80211: Radio turned off
bcm43xx_d80211: Radio turned off
wmaster0: Selected rate control algorithm 'simple'
bcm43xx_d80211: Virtual interface added (type: 0x00000002, ID: 8, MAC: 00:19:7d:21:7b:50)
ssb: Switching to core 0
ssb: Switching to core 1
bcm43xx_d80211: PHY connected
bcm43xx_d80211: firmware revision 15F, patchlevel 7E, date 2006-07-29 05:54:02
ssb: Switching to core 0
ssb: Switching to core 1
bcm43xx_d80211: Radio turned on
ssb: Switching to core 0
ssb: Switching to core 1
bcm43xx_d80211: Chip initialized
bcm43xx_d80211: 32-bit DMA initialized
bcm43xx_d80211: Selected 802.11 core (phytype 2)
wmaster0: Does not support passive scan, disabled
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: Initial auth_alg=0
wlan0: authenticate with AP 00:0f:66:2f:ef:59
wlan0: authenticate with AP 00:0f:66:2f:ef:59
wlan0: authenticate with AP 00:0f:66:2f:ef:59
wlan0: authentication with AP 00:0f:66:2f:ef:59 timed out
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
warning: many lost ticks.
Your time source seems to be instable or some driver is hogging interupts
rip _spin_unlock_irqrestore+0xb/0xd
Falling back to HPET
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Radio turned off
ssb: Switching to core 0
bcm43xx_d80211: DMA-32 0x0200 (RX) max used slots: 1/64
ssb: Switching to core 1
bcm43xx_d80211: DMA-32 0x02A0 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0280 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0260 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0240 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0220 (TX) max used slots: 2/128
bcm43xx_d80211: DMA-32 0x0200 (TX) max used slots: 0/128
bcm43xx_d80211: Virtual interface removed (type: 0x00000002, ID: 8, MAC: 00:19:7d:21:7b:50)