ACPI: PCI Interrupt 0000:0c:00.0[A] -> GSI 17 (level, low) -> IRQ 17
PCI: Setting latency timer of device 0000:0c:00.0 to 64
ssb: Sonics Silicon Backplane found on PCI device 0000:0c:00.0
ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x11, vendor 0x4243)
ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev 0x0A, vendor 0x4243)
ssb: Core 2 found: USB 1.1 Host (cc 0x817, rev 0x03, vendor 0x4243)
ssb: Core 3 found: PCI-E (cc 0x820, rev 0x01, vendor 0x4243)
ssb: Switching to ChipCommon core, index 0
ssb: Switching to PCI-E core, index 3
ssb: PCIcore in client mode found
wmaster0: Selected rate control algorithm 'simple'
ssb: Switching to IEEE 802.11 core, index 1
ssb: Switching to PCI-E core, index 3
ssb: Switching to IEEE 802.11 core, index 1
bcm43xx_d80211: Adding Interface type 2
bcm43xx_d80211: Found PHY: Version 4, Type 2, Revision 8
bcm43xx_d80211: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2
bcm43xx_d80211: Loading firmware version 351.126 (2006-07-29 05:54:02)
ssb: Switching to ChipCommon core, index 0
ssb: Switching to IEEE 802.11 core, index 1
bcm43xx_d80211: Radio turned on
bcm43xx_d80211: FIXME: Possibly broken code in bcm43xx_phy_initg() at drivers/net/wireless/d80211/bcm43xx/bcm43xx_phy.c:1650
bcm43xx_d80211: Chip initialized
bcm43xx_d80211: 32-bit DMA initialized
bcm43xx_d80211: Wireless interface started
wmaster0: Does not support passive scan, disabled
wlan0: starting scan
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: Initial auth_alg=0
wlan0: authenticate with AP 00:0f:66:2f:ef:59
wlan0: authenticate with AP 00:0f:66:2f:ef:59
wlan0: authenticate with AP 00:0f:66:2f:ef:59
wlan0: authentication with AP 00:0f:66:2f:ef:59 timed out
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
bcm43xx_d80211: Wireless interface stopped
bcm43xx_d80211: Removing Interface type 2
bcm43xx_d80211: DMA-32 0x0200 (RX) max used slots: 1/64
bcm43xx_d80211: DMA-32 0x02A0 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0280 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0260 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0240 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0220 (TX) max used slots: 2/128
bcm43xx_d80211: DMA-32 0x0200 (TX) max used slots: 0/128
bcm43xx_d80211: Radio turned off
ssb: Switching to ChipCommon core, index 0
bcm43xx_d80211: Adding Interface type 2
ssb: Switching to IEEE 802.11 core, index 1
bcm43xx_d80211: Found PHY: Version 4, Type 2, Revision 8
bcm43xx_d80211: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2
bcm43xx_d80211: Loading firmware version 351.126 (2006-07-29 05:54:02)
ssb: Switching to ChipCommon core, index 0
ssb: Switching to IEEE 802.11 core, index 1
bcm43xx_d80211: Radio turned on
bcm43xx_d80211: FIXME: Possibly broken code in bcm43xx_phy_initg() at drivers/net/wireless/d80211/bcm43xx/bcm43xx_phy.c:1650
bcm43xx_d80211: Chip initialized
bcm43xx_d80211: 32-bit DMA initialized
bcm43xx_d80211: Wireless interface started
wmaster0: Does not support passive scan, disabled
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: Initial auth_alg=0
wlan0: authenticate with AP 00:0f:66:2f:ef:59
wlan0: authenticate with AP 00:0f:66:2f:ef:59
wlan0: authenticate with AP 00:0f:66:2f:ef:59
wlan0: authentication with AP 00:0f:66:2f:ef:59 timed out
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
wlan0: starting scan
wlan0: scan completed
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Using hardware based encryption for keyidx: 0, mac: ff:ff:ff:ff:ff:ff
bcm43xx_d80211: Wireless interface stopped
bcm43xx_d80211: Removing Interface type 2
bcm43xx_d80211: DMA-32 0x0200 (RX) max used slots: 1/64
bcm43xx_d80211: DMA-32 0x02A0 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0280 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0260 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0240 (TX) max used slots: 0/128
bcm43xx_d80211: DMA-32 0x0220 (TX) max used slots: 2/128
bcm43xx_d80211: DMA-32 0x0200 (TX) max used slots: 0/128
bcm43xx_d80211: Radio turned off
ssb: Switching to ChipCommon core, index 0