| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20070418062721.GE11308@lixom.net>
Date: Wed, 18 Apr 2007 01:27:21 -0500
From: olof@...om.net (Olof Johansson)
To: jgarzik@...ox.com
Cc: netdev@...r.kernel.org, linuxppc-dev@...abs.org
Subject: [PATCH] [4/5] [v2] pasemi_mac: phy support
PHY support for pasemi_mac. Also add msg_enable flags for future
disablement of the link messages.
Signed-off-by: Olof Johansson <olof@...om.net>
Index: powerpc/drivers/net/pasemi_mac.c
===================================================================
--- powerpc.orig/drivers/net/pasemi_mac.c
+++ powerpc/drivers/net/pasemi_mac.c
@@ -594,6 +592,110 @@ static irqreturn_t pasemi_mac_tx_intr(in
return IRQ_HANDLED;
}
+static void pasemi_adjust_link(struct net_device *dev)
+{
+ struct pasemi_mac *mac = netdev_priv(dev);
+ int msg;
+ unsigned int flags;
+ unsigned int new_flags;
+
+ if (!mac->phydev->link) {
+ /* If no link, MAC speed settings don't matter. Just report
+ * link down and return.
+ */
+ if (mac->link && netif_msg_link(mac))
+ printk(KERN_INFO "%s: Link is down.\n", dev->name);
+
+ netif_carrier_off(dev);
+ mac->link = 0;
+
+ return;
+ } else
+ netif_carrier_on(dev);
+
+ pci_read_config_dword(mac->pdev, PAS_MAC_CFG_PCFG, &flags);
+ new_flags = flags & ~(PAS_MAC_CFG_PCFG_HD | PAS_MAC_CFG_PCFG_SPD_M);
+
+ if (!mac->phydev->duplex)
+ new_flags |= PAS_MAC_CFG_PCFG_HD;
+
+ switch (mac->phydev->speed) {
+ case 1000:
+ new_flags |= PAS_MAC_CFG_PCFG_SPD_1G;
+ break;
+ case 100:
+ new_flags |= PAS_MAC_CFG_PCFG_SPD_100M;
+ break;
+ case 10:
+ new_flags |= PAS_MAC_CFG_PCFG_SPD_10M;
+ break;
+ default:
+ printk("Unsupported speed %d\n", mac->phydev->speed);
+ }
+
+ /* Print on link or speed/duplex change */
+ msg = mac->link != mac->phydev->link || flags != new_flags;
+
+ mac->duplex = mac->phydev->duplex;
+ mac->speed = mac->phydev->speed;
+ mac->link = mac->phydev->link;
+
+ if (new_flags != flags)
+ pci_write_config_dword(mac->pdev, PAS_MAC_CFG_PCFG, new_flags);
+
+ if (msg && netif_msg_link(mac))
+ printk(KERN_INFO "%s: Link is up at %d Mbps, %s duplex.\n",
+ dev->name, mac->speed, mac->duplex ? "full" : "half");
+}
+
+static int pasemi_mac_phy_init(struct net_device *dev)
+{
+ struct pasemi_mac *mac = netdev_priv(dev);
+ struct device_node *dn, *phy_dn;
+ struct phy_device *phydev;
+ unsigned int phy_id;
+ const phandle *ph;
+ const unsigned int *prop;
+ struct resource r;
+ int ret;
+
+ dn = pci_device_to_OF_node(mac->pdev);
+ ph = get_property(dn, "phy-handle", NULL);
+ if (!ph)
+ return -ENODEV;
+ phy_dn = of_find_node_by_phandle(*ph);
+
+ prop = get_property(phy_dn, "reg", NULL);
+ ret = of_address_to_resource(phy_dn->parent, 0, &r);
+ if (ret)
+ goto err;
+
+ phy_id = *prop;
+ snprintf(mac->phy_id, BUS_ID_SIZE, PHY_ID_FMT, (int)r.start, phy_id);
+
+ of_node_put(phy_dn);
+
+ mac->link = 0;
+ mac->speed = 0;
+ mac->duplex = -1;
+
+ phydev = phy_connect(dev, mac->phy_id, &pasemi_adjust_link, 0, PHY_INTERFACE_MODE_SGMII);
+
+ if (IS_ERR(phydev)) {
+ printk(KERN_ERR "%s: Could not attach to phy\n", dev->name);
+ return PTR_ERR(phydev);
+ }
+
+ mac->phydev = phydev;
+
+ return 0;
+
+err:
+ of_node_put(phy_dn);
+ return -ENODEV;
+}
+
+
static int pasemi_mac_open(struct net_device *dev)
{
struct pasemi_mac *mac = netdev_priv(dev);
@@ -667,6 +769,13 @@ static int pasemi_mac_open(struct net_de
pasemi_mac_replenish_rx_ring(dev);
+ ret = pasemi_mac_phy_init(dev);
+ /* Some configs don't have PHYs (XAUI etc), so don't complain about
+ * failed init due to -ENODEV.
+ */
+ if (ret && ret != -ENODEV)
+ dev_warn(&mac->pdev->dev, "phy init failed: %d\n", ret);
+
netif_start_queue(dev);
netif_poll_enable(dev);
@@ -697,6 +806,9 @@ static int pasemi_mac_open(struct net_de
goto out_rx_int;
}
+ if (mac->phydev)
+ phy_start(mac->phydev);
+
return 0;
out_rx_int:
@@ -720,6 +832,11 @@ static int pasemi_mac_close(struct net_d
unsigned int stat;
int retries;
+ if (mac->phydev) {
+ phy_stop(mac->phydev);
+ phy_disconnect(mac->phydev);
+ }
+
netif_stop_queue(dev);
/* Clean out any pending buffers */
@@ -1013,6 +1130,9 @@ pasemi_mac_probe(struct pci_dev *pdev, c
mac->rx_status = &dma_status->rx_sta[mac->dma_rxch];
mac->tx_status = &dma_status->tx_sta[mac->dma_txch];
+ /* Enable most messages by default */
+ mac->msg_enable = (NETIF_MSG_IFUP << 1 ) - 1;
+
err = register_netdev(dev);
if (err) {
Index: powerpc/drivers/net/pasemi_mac.h
===================================================================
--- powerpc.orig/drivers/net/pasemi_mac.h
+++ powerpc/drivers/net/pasemi_mac.h
@@ -24,6 +24,7 @@
#include <linux/ethtool.h>
#include <linux/netdevice.h>
#include <linux/spinlock.h>
+#include <linux/phy.h>
struct pasemi_mac_txring {
spinlock_t lock;
@@ -54,6 +55,7 @@ struct pasemi_mac {
struct pci_dev *pdev;
struct pci_dev *dma_pdev;
struct pci_dev *iob_pdev;
+ struct phy_device *phydev;
struct net_device_stats stats;
/* Pointer to the cacheable per-channel status registers */
@@ -75,6 +77,12 @@ struct pasemi_mac {
struct pasemi_mac_rxring *rx;
unsigned long tx_irq;
unsigned long rx_irq;
+ int link;
+ int speed;
+ int duplex;
+
+ unsigned int msg_enable;
+ char phy_id[BUS_ID_SIZE];
};
/* Software status descriptor (desc_info) */
Index: powerpc/drivers/net/Kconfig
===================================================================
--- powerpc.orig/drivers/net/Kconfig
+++ powerpc/drivers/net/Kconfig
@@ -2490,6 +2490,7 @@ config NETXEN_NIC
config PASEMI_MAC
tristate "PA Semi 1/10Gbit MAC"
depends on PPC64 && PCI
+ select PHYLIB
help
This driver supports the on-chip 1/10Gbit Ethernet controller on
PA Semi's PWRficient line of chips.
-
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Powered by blists - more mailing lists