| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <466F5645.1060501@garzik.org> Date: Tue, 12 Jun 2007 22:28:21 -0400 From: Jeff Garzik <jeff@...zik.org> To: "John W. Linville" <linville@...driver.com> CC: linux-wireless@...r.kernel.org, netdev@...r.kernel.org, Dan Williams <dcbw@...hat.com> Subject: Re: Please pull 'libertas' branch of wireless-2.6 (resent w/o attachment) John W. Linville wrote: > Resending w/o the attached patch, in case it was too big...yikes! > > Individual patches are available here: > > http://www.kernel.org/pub/linux/kernel/people/linville/wireless-2.6/libertas > > John > > --- > > Jeff, > > This is the same as the previous pull request, only rebased on > 2.6.22-rc4. Since this is a big pull already, I didn't want to > complicate it with the additional patches identified by the libertas > team as 2.6.22-worthy. > > John > > --- > > The following changes since commit 5ecd3100e695228ac5e0ce0e325e252c0f11806f: > Linus Torvalds (1): > Linux 2.6.22-rc4 > > are found in the git repository at: > > git://git.kernel.org/pub/scm/linux/kernel/git/linville/wireless-2.6.git libertas > > Chris Ball (1): > libertas: wakeup both mesh and normal wakeup when getting out of scan > > Dan Williams (25): > libertas: call SET_NETDEV_DEV from common code > libertas: replace 'macaddress' with 'bssid' > libertas: correctly unregister mesh netdev on error > libertas: don't tear down netdev in libertas_activate_card > libertas: make scan result handling more flexible > libertas: fix 'keep previous scan' behavior > libertas: move channel changing into association framework > libertas: make association paths consistent > libertas: use MAC_FMT and MAC_ARG where appropriate > libertas: use compare_ether_addr() rather than memcmp() where appropriate > libertas: fix debug enter/leave prints for libertas_execute_next_command > libertas: correctly balance locking in libertas_process_rx_command > libertas: correct error report paths for wlan_fwt_list_ioctl > libertas: fix deadlock SIOCGIWSCAN handler > libertas: fix default adhoc channel > libertas: honor specific channel requests during association > libertas: send SIOCGIWSCAN event after partial scans too > libertas: debug print spacing fixes in assoc.c > libertas: add more verbose debugging to libertas_cmd_80211_authenticate > libertas: Make WPA work through supplicant handshake > libertas: sparse fixes > libertas: tweak association debug output > libertas: remove structure WLAN_802_11_SSID and libertas_escape_essid > libertas: remove WPA_SUPPLICANT structure > libertas: reduce SSID and BSSID mixed-case abuse > > David Woodhouse (6): > libertas: fix character set in README > libertas: first pass at fixing up endianness issues > libertas: More endianness fixes. > libertas: more endianness fixes, in tx.c this time > libertas: don't byte-swap firmware version number. It's a byte array. > libertas: fix big-endian associate command. > > Holger Schurig (23): > libertas: rename wlan_association_worker > libertas: a debug output was missing a newline > libertas: fix removal of all debugfs files > libertas: remove __FILE__ from debug output > libertas: remove unused/superfluous definitions of DEV_NAME_LEN > libertas: move vendor & product id's into if_usb.c > libertas: make libertas_wlan_data_rates static > libertas: exclude non-used code when PROC_DEBUG is not set > libertas: make debug configurable > libertas: tune debug code > libertas: single out mesh code > libertas: change debug output of libertas_interrupt() > libertas: get rid of libertas_sbi_get_priv() > libertas: fix SSID output > libertas: changed some occurences of kmalloc() + memset(&a,0,sz) to kzalloc() > libertas: move reset_device() code main.c to if_usb.c > libertas: split wlan_add_card() > libertas: indirect all hardware access via hw_XXXX functions > libertas: move contents of fw.h to decl.h > libertas: split module into two (libertas.ko and usb8xxx.ko) > libertas: fix RESET logic at unload time > libertas: let DRV_NAME be overridable > libertas: remove unused variables in wlan_dev_t > > Javier Cardona (2): > libertas: fixed transmission flow control on the mesh interface > libertas: added transmission failures to mesh statistics > > Luis Carlos Cobo (4): > libertas: fixed incorrect assigment of fcs errors to frag errors > libertas: add URB debug info > libertas: fixed kernel oops on module/card removal > libertas: updated mesh commands for 5.220.9.p11 > > Luis Carlos Cobo Rus (6): > libertas: version bump (321p0) and cmds update for new fw (5.220.10.p0) > libertas: cleanup of fwt_list_route processing > libertas: updated readme file > libertas: make mac address configuration work with mesh interface too > libertas: split wext for eth and msh > libertas: support for mesh autostart on firmware 5.220.11 > > Marcelo Tosatti (5): > libertas: scan two channels per scan command > libertas: remove deprecated pm_register and associated code > libertas: fix scanning from associate path > libertas: fix error handling of card initialization > libertas: fix oops on rmmod > > drivers/net/wireless/Kconfig | 19 +- > drivers/net/wireless/libertas/11d.c | 152 ++-- > drivers/net/wireless/libertas/11d.h | 6 +- > drivers/net/wireless/libertas/Makefile | 4 +- > drivers/net/wireless/libertas/README | 52 +- > drivers/net/wireless/libertas/assoc.c | 345 +++++--- > drivers/net/wireless/libertas/assoc.h | 8 +- > drivers/net/wireless/libertas/cmd.c | 559 +++++------ > drivers/net/wireless/libertas/cmdresp.c | 375 ++++---- > drivers/net/wireless/libertas/debugfs.c | 432 ++++---- > drivers/net/wireless/libertas/decl.h | 20 +- > drivers/net/wireless/libertas/defs.h | 101 ++- > drivers/net/wireless/libertas/dev.h | 98 +- > drivers/net/wireless/libertas/ethtool.c | 55 +- > drivers/net/wireless/libertas/fw.c | 111 +-- > drivers/net/wireless/libertas/fw.h | 13 - > drivers/net/wireless/libertas/host.h | 13 +- > drivers/net/wireless/libertas/hostcmd.h | 392 ++++---- > drivers/net/wireless/libertas/if_bootcmd.c | 6 +- > drivers/net/wireless/libertas/if_usb.c | 448 +++++---- > drivers/net/wireless/libertas/if_usb.h | 32 +- > drivers/net/wireless/libertas/ioctl.c | 286 ++++-- > drivers/net/wireless/libertas/join.c | 464 ++++----- > drivers/net/wireless/libertas/join.h | 13 +- > drivers/net/wireless/libertas/main.c | 673 ++++++------- > drivers/net/wireless/libertas/rx.c | 63 +- > drivers/net/wireless/libertas/sbi.h | 40 - > drivers/net/wireless/libertas/scan.c | 1529 +++++++++++++--------------- > drivers/net/wireless/libertas/scan.h | 81 +- > drivers/net/wireless/libertas/thread.h | 8 +- > drivers/net/wireless/libertas/tx.c | 74 +- > drivers/net/wireless/libertas/types.h | 63 +- > drivers/net/wireless/libertas/wext.c | 778 ++++++++------- > drivers/net/wireless/libertas/wext.h | 13 +- > 34 files changed, 3679 insertions(+), 3647 deletions(-) > delete mode 100644 drivers/net/wireless/libertas/fw.h > delete mode 100644 drivers/net/wireless/libertas/sbi.h pulled into #upstream-fixes - To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majordomo@...r.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
Powered by blists - more mailing lists