Remove the old hack to program an initial EEPROM setting into the DM9000 as we now have ethtool support for reading and writing the EEPROM. Signed-off-by: Ben Dooks Index: linux-2.6.24-quilt3/drivers/net/dm9000.c =================================================================== --- linux-2.6.24-quilt3.orig/drivers/net/dm9000.c +++ linux-2.6.24-quilt3/drivers/net/dm9000.c @@ -191,10 +191,6 @@ static void dm9000_write_eeprom(board_in static void dm9000_rx(struct net_device *); static void dm9000_hash_table(struct net_device *); -//#define DM9000_PROGRAM_EEPROM -#ifdef DM9000_PROGRAM_EEPROM -static void program_eeprom(board_info_t * db); -#endif /* DM9000 network board routine ---------------------------- */ static void @@ -699,9 +695,6 @@ dm9000_probe(struct platform_device *pde ndev->poll_controller = &dm9000_poll_controller; #endif -#ifdef DM9000_PROGRAM_EEPROM - program_eeprom(db); -#endif db->msg_enable = NETIF_MSG_LINK; db->mii.phy_id_mask = 0x1f; db->mii.reg_num_mask = 0x1f; @@ -1115,28 +1108,6 @@ dm9000_write_eeprom(board_info_t *db, in mutex_unlock(&db->addr_lock); } -#ifdef DM9000_PROGRAM_EEPROM -/* - * Only for development: - * Here we write static data to the eeprom in case - * we don't have valid content on a new board - */ -static void -program_eeprom(board_info_t * db) -{ - u16 eeprom[] = { 0x0c00, 0x007f, 0x1300, /* MAC Address */ - 0x0000, /* Autoload: accept nothing */ - 0x0a46, 0x9000, /* Vendor / Product ID */ - 0x0000, /* pin control */ - 0x0000, - }; /* Wake-up mode control */ - int i; - for (i = 0; i < 8; i++) - write_srom_word(db, i, eeprom[i]); -} -#endif - - /* * Calculate the CRC valude of the Rx packet * flag = 1 : return the reverse CRC (for the received packet CRC) -- Ben (ben@fluff.org, http://www.fluff.org/) 'a smiley only costs 4 bytes' -- To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html