Convert to new network device ops interface. Signed-off-by: Stephen Hemminger --- a/drivers/net/e1000/e1000_main.c 2008-11-17 07:57:18.000000000 -0800 +++ b/drivers/net/e1000/e1000_main.c 2008-11-17 12:55:04.000000000 -0800 @@ -888,6 +888,25 @@ static int e1000_is_need_ioport(struct p } } +static const struct net_device_ops e1000_netdev_ops = { + .open = e1000_open, + .stop = e1000_close, + .get_stats = e1000_get_stats, + .set_rx_mode = e1000_set_rx_mode, + .set_mac_address = e1000_set_mac, + .tx_timeout = e1000_tx_timeout, + .change_mtu = e1000_change_mtu, + .do_ioctl = e1000_ioctl, + .validate_addr = eth_validate_addr, + + .vlan_rx_register = e1000_vlan_rx_register, + .vlan_rx_add_vid = e1000_vlan_rx_add_vid, + .vlan_rx_kill_vid = e1000_vlan_rx_kill_vid, +#ifdef CONFIG_NET_POLL_CONTROLLER + .poll_controller = e1000_netpoll, +#endif +}; + /** * e1000_probe - Device Initialization Routine * @pdev: PCI device information struct @@ -981,24 +1000,12 @@ static int __devinit e1000_probe(struct } } - netdev->open = &e1000_open; - netdev->stop = &e1000_close; + netdev->netdev_ops = &e1000_netdev_ops; netdev->hard_start_xmit = &e1000_xmit_frame; - netdev->get_stats = &e1000_get_stats; - netdev->set_rx_mode = &e1000_set_rx_mode; - netdev->set_mac_address = &e1000_set_mac; - netdev->change_mtu = &e1000_change_mtu; - netdev->do_ioctl = &e1000_ioctl; e1000_set_ethtool_ops(netdev); - netdev->tx_timeout = &e1000_tx_timeout; netdev->watchdog_timeo = 5 * HZ; netif_napi_add(netdev, &adapter->napi, e1000_clean, 64); - netdev->vlan_rx_register = e1000_vlan_rx_register; - netdev->vlan_rx_add_vid = e1000_vlan_rx_add_vid; - netdev->vlan_rx_kill_vid = e1000_vlan_rx_kill_vid; -#ifdef CONFIG_NET_POLL_CONTROLLER - netdev->poll_controller = e1000_netpoll; -#endif + strncpy(netdev->name, pci_name(pdev), sizeof(netdev->name) - 1); adapter->bd_number = cards_found; -- -- To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html