Convert this driver to network device ops. Compile tested only. Signed-off-by: Stephen Hemminger --- a/drivers/net/chelsio/cxgb2.c 2008-11-17 13:56:56.000000000 -0800 +++ b/drivers/net/chelsio/cxgb2.c 2008-11-17 14:46:24.000000000 -0800 @@ -1010,6 +1010,21 @@ void t1_fatal_err(struct adapter *adapte adapter->name); } +static const struct net_device_ops cxgb_netdev_ops = { + .open = cxgb_open, + .stop = cxgb_close, + .get_stats = t1_get_stats, + .validate_addr = eth_validate_addr, + .set_multicast_list = t1_set_rxmode, + .do_ioctl = t1_ioctl, + .change_mtu = t1_change_mtu, + .set_mac_address = t1_set_mac_addr, + .vlan_rx_register = vlan_rx_register, +#ifdef CONFIG_NET_POLL_CONTROLLER + .poll_controller = t1_netpoll, +#endif +}; + static int __devinit init_one(struct pci_dev *pdev, const struct pci_device_id *ent) { @@ -1130,7 +1145,6 @@ static int __devinit init_one(struct pci adapter->flags |= VLAN_ACCEL_CAPABLE; netdev->features |= NETIF_F_HW_VLAN_TX | NETIF_F_HW_VLAN_RX; - netdev->vlan_rx_register = vlan_rx_register; #endif /* T204: disable TSO */ @@ -1140,19 +1154,11 @@ static int __devinit init_one(struct pci } } - netdev->open = cxgb_open; - netdev->stop = cxgb_close; + netdev->netdev_ops = &cxgb_netdev_ops; netdev->hard_start_xmit = t1_start_xmit; netdev->hard_header_len += (adapter->flags & TSO_CAPABLE) ? sizeof(struct cpl_tx_pkt_lso) : sizeof(struct cpl_tx_pkt); - netdev->get_stats = t1_get_stats; - netdev->set_multicast_list = t1_set_rxmode; - netdev->do_ioctl = t1_ioctl; - netdev->change_mtu = t1_change_mtu; - netdev->set_mac_address = t1_set_mac_addr; -#ifdef CONFIG_NET_POLL_CONTROLLER - netdev->poll_controller = t1_netpoll; -#endif + netif_napi_add(netdev, &adapter->napi, t1_poll, 64); SET_ETHTOOL_OPS(netdev, &t1_ethtool_ops); -- -- To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html