Convert driver to new net_device_ops. Compile tested only. Signed-off-by: Stephen Hemminger --- a/drivers/net/mlx4/en_netdev.c 2008-11-20 22:34:43.000000000 -0800 +++ b/drivers/net/mlx4/en_netdev.c 2008-11-20 22:36:59.000000000 -0800 @@ -953,6 +953,23 @@ static int mlx4_en_change_mtu(struct net return 0; } +static const struct net_device_ops mlx4_netdev_ops = { + .ndo_open = mlx4_en_open, + .ndo_stop = mlx4_en_close, + .ndo_start_xmit = mlx4_en_xmit, + .ndo_get_stats = mlx4_en_get_stats, + .ndo_set_multicast_list = mlx4_en_set_multicast, + .ndo_set_mac_address = mlx4_en_set_mac, + .ndo_change_mtu = mlx4_en_change_mtu, + .ndo_tx_timeout = mlx4_en_tx_timeout, + .ndo_vlan_rx_register = mlx4_en_vlan_rx_register, + .ndo_vlan_rx_add_vid = mlx4_en_vlan_rx_add_vid, + .ndo_vlan_rx_kill_vid = mlx4_en_vlan_rx_kill_vid, +#ifdef CONFIG_NET_POLL_CONTROLLER + .ndo_poll_controller = mlx4_en_netpoll, +#endif +}; + int mlx4_en_init_netdev(struct mlx4_en_dev *mdev, int port, struct mlx4_en_port_profile *prof) { @@ -1029,22 +1046,9 @@ int mlx4_en_init_netdev(struct mlx4_en_d /* * Initialize netdev entry points */ - - dev->open = &mlx4_en_open; - dev->stop = &mlx4_en_close; - dev->hard_start_xmit = &mlx4_en_xmit; - dev->get_stats = &mlx4_en_get_stats; - dev->set_multicast_list = &mlx4_en_set_multicast; - dev->set_mac_address = &mlx4_en_set_mac; - dev->change_mtu = &mlx4_en_change_mtu; - dev->tx_timeout = &mlx4_en_tx_timeout; + dev->netdev_ops = &mlx4_netdev_ops; dev->watchdog_timeo = MLX4_EN_WATCHDOG_TIMEOUT; - dev->vlan_rx_register = mlx4_en_vlan_rx_register; - dev->vlan_rx_add_vid = mlx4_en_vlan_rx_add_vid; - dev->vlan_rx_kill_vid = mlx4_en_vlan_rx_kill_vid; -#ifdef CONFIG_NET_POLL_CONTROLLER - dev->poll_controller = mlx4_en_netpoll; -#endif + SET_ETHTOOL_OPS(dev, &mlx4_en_ethtool_ops); /* Set defualt MAC */ -- -- To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html