lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
Open Source and information security mailing list archives
| ||
|
Date: Mon, 29 Mar 2010 09:58:49 -0700 From: "Ira W. Snyder" <iws@...o.caltech.edu> To: linux-kernel@...r.kernel.org Cc: socketcan-core@...ts.berlios.de, netdev@...r.kernel.org, sameo@...ux.intel.com Subject: [PATCH 0/3] add support for Janz MODULbus devices This patch series adds support for the Janz CMOD-IO carrier board, as well as the Janz VMOD-ICAN3 Intelligent CAN controller and the Janz VMOD-TTL Digital IO controller. The CMOD-IO carrier board is a PCI to MODULbus bridge, into which plug MODULbus daughterboards. I only have access to two types of daughtercards, the VMOD-ICAN3 and VMOD-TTL boards mentioned above. The CAN driver has been tested under high loads. I am able to generate ~60% bus utilization. With two VMOD-ICAN3 boards looped back to each other, neither one loses any packets when only a single board is generating packets at maximum speed. Once both boards start generating packets, one board will sometimes loose arbitration, and cause some lost packets. After much review from the last posting of the series, I believe that this should be ready for mainline. Many thanks to everyone that helped! RFCv4 -> RFCv5: - removed some dev_dbg() statements - change default MODULbus modules to "none" - accept both "empty" and "" in the MODULbus modules parameter - print an error message when no MODULbus modules are specified - add sysfs support to get/set CAN bus termination - fix error-active and error-passive state reporting - add support for netlink bus-error messages - fixed sparse warnings - used mfd-core API for multifunction device probing RFCv3 -> RFCv4: - addressed many review comments - switch to NAPI - add TX flow control - mark functions with __devinit and __devexit - add sysfs readout of MODULbus number (hex switch) - implement GPIO driver for VMOD-TTL RFCv2 -> RFCv3: - addressed many review comments - correct CAN bus error handling - use struct device to track subdevices - use structures for register layout - add lots of #defines for register values - use better function prefixes RFCv1 -> RFCv2: - converted to a multi-driver model - addressed many review comments - added CAN bus error handling - use a work function only instead of work + NAPI - use SJA1000 bittiming calculation code Thanks, Ira -- To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majordomo@...r.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
Powered by blists - more mailing lists