U-Boot 1.1.6 (Oct  9 2007 - 20:42:39) MPC83XX

Clock configuration:
  Coherent System Bus:  166 MHz
  Core:                 333 MHz
  Local Bus Controller: 166 MHz
  Local Bus:             41 MHz
  DDR:                  333 MHz
  SEC:                   55 MHz
  I2C1:                 166 MHz
  I2C2:                 166 MHz
  TSEC1:                166 MHz
  TSEC2:                166 MHz
  USB MPH:                0 MHz
  USB DR:                55 MHz
CPU: MPC8313E, Rev: 10 at 333.333 MHz
Board: Freescale MPC8313ERDB
I2C:   ready
DRAM:  Initializing
   DDR RAM: 128 MB
FLASH:  8 MB
NAND:  32 MiB
In:    serial
Out:   serial
Err:   serial
Net:   TSEC0, TSEC1
=>
=>
=> setenv ethact TSEC1 ; setenv ipaddr 10.0.0.99 ; setenv serverip 10.0.0.2 ; setenv bootargs console=ttyS0,115200 ip=on debug ; tftp a00000 uImage ; tftp 900000 dtb ; bootm a00000 - 900000
Waiting for PHY auto negotiation to complete. done
Speed: 100, full duplex
Using TSEC1 device
TFTP from server 10.0.0.2; our IP address is 10.0.0.99
Filename 'uImage'.
Load address: 0xa00000
Loading: #################################################################
         #################################################################
         #################################################################
         #################################################################
         ##############################
done
Bytes transferred = 1482399 (169e9f hex)
Speed: 100, full duplex
Using TSEC1 device
TFTP from server 10.0.0.2; our IP address is 10.0.0.99
Filename 'dtb'.
Load address: 0x900000
Loading: ####
done
Bytes transferred = 20000 (4e20 hex)
## Booting image at 00a00000 ...
   Image Name:   Linux-2.6.35-rc2-00059-gf7c3a62
   Created:      2010-06-10   8:59:46 UTC
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    1482335 Bytes =  1.4 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
   Booting using flat device tree at 0x900000
Using MPC831x RDB machine description
Linux version 2.6.35-rc2-00059-gf7c3a62 (cbou@oksana) (gcc version 4.2.0 (MontaVista 4.2.0-16.0.20.0800760 2008-04-05)) #85 Thu Jun 10 12:59:44 MSD 2010
Found legacy serial port 0 for /soc8313@e0000000/serial@4500
  mem=e0004500, taddr=e0004500, irq=0, clk=166666660, speed=0
Found legacy serial port 1 for /soc8313@e0000000/serial@4600
  mem=e0004600, taddr=e0004600, irq=0, clk=166666660, speed=0
bootconsole [udbg0] enabled
setup_arch: bootmem
mpc831x_rdb_setup_arch()
arch: exit
Top of RAM: 0x8000000, Total RAM: 0x8000000
Memory hole size: 0MB
Zone PFN ranges:
  DMA      0x00000000 -> 0x00008000
  Normal   empty
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0: 0x00000000 -> 0x00008000
On node 0 totalpages: 32768
free_area_init_node: node 0, pgdat c0302840, node_mem_map c0321000
  DMA zone: 256 pages used for memmap
  DMA zone: 0 pages reserved
  DMA zone: 32512 pages, LIFO batch:7
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 32512
Kernel command line: console=ttyS0,115200 ip=on debug
PID hash table entries: 512 (order: -1, 2048 bytes)
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 126708k/131072k available (2980k kernel code, 4364k reserved, 136k data, 83k bss, 164k init)
Kernel virtual memory layout:
  * 0xfffdf000..0xfffff000  : fixmap
  * 0xfdffc000..0xfe000000  : early ioremap
  * 0xc9000000..0xfdffc000  : vmalloc & ioremap
SLUB: Genslabs=13, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Hierarchical RCU implementation.
        RCU-based detection of stalled CPUs is disabled.
        Verbose stalled-CPUs detection is disabled.
NR_IRQS:512 nr_irqs:512
IPIC (128 IRQ sources) at c9000700
time_init: decrementer frequency = 41.666665 MHz
time_init: processor frequency   = 333.333320 MHz
clocksource: timebase mult[6000004] shift[22] registered
clockevent: decrementer mult[aaaaaa3] shift[32] cpu[0]
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
NET: Registered protocol family 16

  alloc irq_desc for 38 on node 0
  alloc kstat_irqs on node 0
irq: irq 38 on host /soc8313@e0000000/pic@700 mapped to virtual irq 38
Registering ipic with sysfs...
bio: create slab <bio-0> at 0
SCSI subsystem initialized
Switching to clocksource timebase
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
  alloc irq_desc for 16 on node 0
  alloc kstat_irqs on node 0
irq: irq 9 on host /soc8313@e0000000/pic@700 mapped to virtual irq 16
  alloc irq_desc for 17 on node 0
  alloc kstat_irqs on node 0
irq: irq 10 on host /soc8313@e0000000/pic@700 mapped to virtual irq 17
msgmni has been set to 247
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0xe0004500 (irq = 16) is a 16550A
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
serial8250.0: ttyS1 at MMIO 0xe0004600 (irq = 17) is a 16550A
brd: module loaded
loop: module loaded
Fixed MDIO Bus: probed
  alloc irq_desc for 37 on node 0
  alloc kstat_irqs on node 0
irq: irq 37 on host /soc8313@e0000000/pic@700 mapped to virtual irq 37
  alloc irq_desc for 36 on node 0
  alloc kstat_irqs on node 0
irq: irq 36 on host /soc8313@e0000000/pic@700 mapped to virtual irq 36
  alloc irq_desc for 35 on node 0
  alloc kstat_irqs on node 0
irq: irq 35 on host /soc8313@e0000000/pic@700 mapped to virtual irq 35
eth0: Gianfar Ethernet Controller Version 1.2, 00:04:9f:ef:23:33
eth0: Running with NAPI enabled
eth0: RX BD ring size for Q[0]: 256
eth0: TX BD ring size for Q[0]: 256
  alloc irq_desc for 34 on node 0
  alloc kstat_irqs on node 0
irq: irq 34 on host /soc8313@e0000000/pic@700 mapped to virtual irq 34
  alloc irq_desc for 33 on node 0
  alloc kstat_irqs on node 0
irq: irq 33 on host /soc8313@e0000000/pic@700 mapped to virtual irq 33
  alloc irq_desc for 32 on node 0
  alloc kstat_irqs on node 0
irq: irq 32 on host /soc8313@e0000000/pic@700 mapped to virtual irq 32
eth1: Gianfar Ethernet Controller Version 1.2, 00:e0:0c:00:7e:21
eth1: Running with NAPI enabled
eth1: RX BD ring size for Q[0]: 256
eth1: TX BD ring size for Q[0]: 256
Freescale PowerQUICC MII Bus: probed
  alloc irq_desc for 20 on node 0
  alloc kstat_irqs on node 0
irq: irq 20 on host /soc8313@e0000000/pic@700 mapped to virtual irq 20
Freescale PowerQUICC MII Bus: probed
md: linear personality registered for level -1
md: raid0 personality registered for level 0
md: raid1 personality registered for level 1
TCP cubic registered
NET: Registered protocol family 17
Sending DHCP requests .
PHY: 0:01 - Link is Up - 1000/Full
PHY: mdio@e0024520:04 - Link is Up - 100/Full
., OK
IP-Config: Got DHCP answer from 10.0.0.2, my address is 10.0.0.32
IP-Config: Complete:
     device=eth1, addr=10.0.0.32, mask=255.255.255.0, gw=10.0.0.2,
     host=10.0.0.32, domain=local.net, nis-domain=(none),
     bootserver=10.0.0.2, rootserver=10.0.0.2, rootpath=/opt/montavista/cge/devkit/ppc/83xx/target/
md: Waiting for all devices to be available before autodetect
md: If you don't use raid, use raid=noautodetect
md: Autodetecting RAID arrays.
md: Scanned 0 and added 0 devices.
md: autorun ...
md: ... autorun DONE.
Looking up port of RPC 100003/2 on 10.0.0.2
Looking up port of RPC 100005/1 on 10.0.0.2
VFS: Mounted root (nfs filesystem) readonly on device 0:10.
Freeing unused kernel memory: 164k init