U-Boot 1.1.6 (Oct 9 2007 - 20:42:39) MPC83XX Clock configuration: Coherent System Bus: 166 MHz Core: 333 MHz Local Bus Controller: 166 MHz Local Bus: 41 MHz DDR: 333 MHz SEC: 55 MHz I2C1: 166 MHz I2C2: 166 MHz TSEC1: 166 MHz TSEC2: 166 MHz USB MPH: 0 MHz USB DR: 55 MHz CPU: MPC8313E, Rev: 10 at 333.333 MHz Board: Freescale MPC8313ERDB I2C: ready DRAM: Initializing DDR RAM: 128 MB FLASH: 8 MB NAND: 32 MiB In: serial Out: serial Err: serial Net: TSEC0, TSEC1 => => => setenv ethact TSEC1 ; setenv ipaddr 10.0.0.99 ; setenv serverip 10.0.0.2 ; setenv bootargs console=ttyS0,115200 ip=on debug ; tftp a00000 uImage ; tftp 900000 dtb ; bootm a00000 - 900000 Waiting for PHY auto negotiation to complete. done Speed: 100, full duplex Using TSEC1 device TFTP from server 10.0.0.2; our IP address is 10.0.0.99 Filename 'uImage'. Load address: 0xa00000 Loading: ################################################################# ################################################################# ################################################################# ################################################################# ############################## done Bytes transferred = 1482397 (169e9d hex) Speed: 100, full duplex Using TSEC1 device TFTP from server 10.0.0.2; our IP address is 10.0.0.99 Filename 'dtb'. Load address: 0x900000 Loading: #### done Bytes transferred = 20000 (4e20 hex) ## Booting image at 00a00000 ... Image Name: Linux-2.6.35-rc2-00058-ge411f2d Created: 2010-06-10 8:52:33 UTC Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 1482333 Bytes = 1.4 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK Booting using flat device tree at 0x900000 Using MPC831x RDB machine description Linux version 2.6.35-rc2-00058-ge411f2d (cbou@oksana) (gcc version 4.2.0 (MontaVista 4.2.0-16.0.20.0800760 2008-04-05)) #84 Thu Jun 10 12:52:32 MSD 2010 Found legacy serial port 0 for /soc8313@e0000000/serial@4500 mem=e0004500, taddr=e0004500, irq=0, clk=166666660, speed=0 Found legacy serial port 1 for /soc8313@e0000000/serial@4600 mem=e0004600, taddr=e0004600, irq=0, clk=166666660, speed=0 bootconsole [udbg0] enabled setup_arch: bootmem mpc831x_rdb_setup_arch() arch: exit Top of RAM: 0x8000000, Total RAM: 0x8000000 Memory hole size: 0MB Zone PFN ranges: DMA 0x00000000 -> 0x00008000 Normal empty Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0x00000000 -> 0x00008000 On node 0 totalpages: 32768 free_area_init_node: node 0, pgdat c0302840, node_mem_map c0321000 DMA zone: 256 pages used for memmap DMA zone: 0 pages reserved DMA zone: 32512 pages, LIFO batch:7 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512 Kernel command line: console=ttyS0,115200 ip=on debug PID hash table entries: 512 (order: -1, 2048 bytes) Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 126708k/131072k available (2980k kernel code, 4364k reserved, 136k data, 83k bss, 164k init) Kernel virtual memory layout: * 0xfffdf000..0xfffff000 : fixmap * 0xfdffc000..0xfe000000 : early ioremap * 0xc9000000..0xfdffc000 : vmalloc & ioremap SLUB: Genslabs=13, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 Hierarchical RCU implementation. RCU-based detection of stalled CPUs is disabled. Verbose stalled-CPUs detection is disabled. NR_IRQS:512 nr_irqs:512 IPIC (128 IRQ sources) at c9000700 time_init: decrementer frequency = 41.666665 MHz time_init: processor frequency = 333.333320 MHz clocksource: timebase mult[6000004] shift[22] registered clockevent: decrementer mult[aaaaaa3] shift[32] cpu[0] pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 NET: Registered protocol family 16 alloc irq_desc for 38 on node 0 alloc kstat_irqs on node 0 irq: irq 38 on host /soc8313@e0000000/pic@700 mapped to virtual irq 38 Registering ipic with sysfs... bio: create slab at 0 SCSI subsystem initialized Switching to clocksource timebase NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 4096 bind 4096) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 RPC: Registered udp transport module. RPC: Registered tcp transport module. RPC: Registered tcp NFSv4.1 backchannel transport module. alloc irq_desc for 16 on node 0 alloc kstat_irqs on node 0 irq: irq 9 on host /soc8313@e0000000/pic@700 mapped to virtual irq 16 alloc irq_desc for 17 on node 0 alloc kstat_irqs on node 0 irq: irq 10 on host /soc8313@e0000000/pic@700 mapped to virtual irq 17 msgmni has been set to 247 alg: No test for stdrng (krng) io scheduler noop registered io scheduler deadline registered io scheduler cfq registered (default) Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0xe0004500 (irq = 16) is a 16550A console [ttyS0] enabled, bootconsole disabled console [ttyS0] enabled, bootconsole disabled serial8250.0: ttyS1 at MMIO 0xe0004600 (irq = 17) is a 16550A brd: module loaded loop: module loaded Fixed MDIO Bus: probed alloc irq_desc for 37 on node 0 alloc kstat_irqs on node 0 irq: irq 37 on host /soc8313@e0000000/pic@700 mapped to virtual irq 37 alloc irq_desc for 36 on node 0 alloc kstat_irqs on node 0 irq: irq 36 on host /soc8313@e0000000/pic@700 mapped to virtual irq 36 alloc irq_desc for 35 on node 0 alloc kstat_irqs on node 0 irq: irq 35 on host /soc8313@e0000000/pic@700 mapped to virtual irq 35 eth0: Gianfar Ethernet Controller Version 1.2, 00:04:9f:ef:23:33 eth0: Running with NAPI enabled eth0: RX BD ring size for Q[0]: 256 eth0: TX BD ring size for Q[0]: 256 alloc irq_desc for 34 on node 0 alloc kstat_irqs on node 0 irq: irq 34 on host /soc8313@e0000000/pic@700 mapped to virtual irq 34 alloc irq_desc for 33 on node 0 alloc kstat_irqs on node 0 irq: irq 33 on host /soc8313@e0000000/pic@700 mapped to virtual irq 33 alloc irq_desc for 32 on node 0 alloc kstat_irqs on node 0 irq: irq 32 on host /soc8313@e0000000/pic@700 mapped to virtual irq 32 eth1: Gianfar Ethernet Controller Version 1.2, 00:e0:0c:00:7e:21 eth1: Running with NAPI enabled eth1: RX BD ring size for Q[0]: 256 eth1: TX BD ring size for Q[0]: 256 Freescale PowerQUICC MII Bus: probed alloc irq_desc for 20 on node 0 alloc kstat_irqs on node 0 irq: irq 20 on host /soc8313@e0000000/pic@700 mapped to virtual irq 20 Freescale PowerQUICC MII Bus: probed md: linear personality registered for level -1 md: raid0 personality registered for level 0 md: raid1 personality registered for level 1 TCP cubic registered NET: Registered protocol family 17 Sending DHCP requests . PHY: 0:01 - Link is Up - 1000/Full PHY: mdio@e0024520:04 - Link is Up - 100/Full ..... timed out! IP-Config: Reopening network devices... Sending DHCP requests . PHY: 0:01 - Link is Up - 1000/Full PHY: mdio@e0024520:04 - Link is Up - 100/Full .