| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1288911122-28669-2-git-send-email-jon.mason@exar.com>
Date: Thu, 4 Nov 2010 17:51:53 -0500
From: Jon Mason <jon.mason@...r.com>
To: David Miller <davem@...emloft.net>
Cc: netdev@...r.kernel.org,
Sivakumar Subramani <sivakumar.subramani@...r.com>,
Sreenivasa Honnur <sreenivasa.honnur@...r.com>,
Ram Vepa <ram.vepa@...r.com>
Subject: [PATCH 02/11] vxge: Wait for Rx to become idle before reseting or closing
Wait for the receive traffic to become idle before attempting to close
or reset the adapter. To enable the processing of packets while Receive
Idle, move the clearing of __VXGE_STATE_CARD_UP bit in vxge_close to
after it. Also, modify the return value of the ISR when the adapter is
down to IRQ_HANDLED. Otherwise there are unhandled interrupts for the
device.
Signed-off-by: Jon Mason <jon.mason@...r.com>
Signed-off-by: Ram Vepa <ram.vepa@...r.com>
---
drivers/net/vxge/vxge-config.c | 86 ++++++++++++++++++++++++++++++++++++++-
drivers/net/vxge/vxge-config.h | 7 +++
drivers/net/vxge/vxge-main.c | 16 ++++++--
drivers/net/vxge/vxge-reg.h | 1 +
4 files changed, 103 insertions(+), 7 deletions(-)
diff --git a/drivers/net/vxge/vxge-config.c b/drivers/net/vxge/vxge-config.c
index 25f0938..dfc4d37 100644
--- a/drivers/net/vxge/vxge-config.c
+++ b/drivers/net/vxge/vxge-config.c
@@ -20,6 +20,88 @@
#include "vxge-traffic.h"
#include "vxge-config.h"
+static void
+vxge_hw_vpath_set_zero_rx_frm_len(struct vxge_hw_vpath_reg __iomem *vp_reg)
+{
+ u64 val64;
+
+ val64 = readq(&vp_reg->rxmac_vcfg0);
+ val64 &= ~VXGE_HW_RXMAC_VCFG0_RTS_MAX_FRM_LEN(0x3fff);
+ writeq(val64, &vp_reg->rxmac_vcfg0);
+ val64 = readq(&vp_reg->rxmac_vcfg0);
+
+ return;
+}
+
+/*
+ * vxge_hw_vpath_wait_receive_idle - Wait for Rx to become idle
+ */
+int vxge_hw_vpath_wait_receive_idle(struct __vxge_hw_device *hldev, u32 vp_id)
+{
+ struct vxge_hw_vpath_reg __iomem *vp_reg;
+ struct __vxge_hw_virtualpath *vpath;
+ u64 val64, rxd_count, rxd_spat;
+ int count = 0, total_count = 0;
+
+ vpath = &hldev->virtual_paths[vp_id];
+ vp_reg = vpath->vp_reg;
+
+ vxge_hw_vpath_set_zero_rx_frm_len(vp_reg);
+
+ /* Check that the ring controller for this vpath has enough free RxDs
+ * to send frames to the host. This is done by reading the
+ * PRC_RXD_DOORBELL_VPn register and comparing the read value to the
+ * RXD_SPAT value for the vpath.
+ */
+ val64 = readq(&vp_reg->prc_cfg6);
+ rxd_spat = VXGE_HW_PRC_CFG6_GET_RXD_SPAT(val64) + 1;
+ /* Use a factor of 2 when comparing rxd_count against rxd_spat for some
+ * leg room.
+ */
+ rxd_spat *= 2;
+
+ do {
+ mdelay(1);
+
+ rxd_count = readq(&vp_reg->prc_rxd_doorbell);
+
+ /* Check that the ring controller for this vpath does
+ * not have any frame in its pipeline.
+ */
+ val64 = readq(&vp_reg->frm_in_progress_cnt);
+ if ((rxd_count <= rxd_spat) || (val64 > 0))
+ count = 0;
+ else
+ count++;
+ total_count++;
+ } while ((count < VXGE_HW_MIN_SUCCESSIVE_IDLE_COUNT) &&
+ (total_count < VXGE_HW_MAX_POLLING_COUNT));
+
+ if (total_count >= VXGE_HW_MAX_POLLING_COUNT)
+ printk(KERN_ALERT "%s: Still Receiving traffic. Abort wait\n",
+ __func__);
+
+ return total_count;
+}
+
+/* vxge_hw_device_wait_receive_idle - This function waits until all frames
+ * stored in the frame buffer for each vpath assigned to the given
+ * function (hldev) have been sent to the host.
+ */
+void vxge_hw_device_wait_receive_idle(struct __vxge_hw_device *hldev)
+{
+ int i, total_count = 0;
+
+ for (i = 0; i < VXGE_HW_MAX_VIRTUAL_PATHS; i++) {
+ if (!(hldev->vpaths_deployed & vxge_mBIT(i)))
+ continue;
+
+ total_count += vxge_hw_vpath_wait_receive_idle(hldev, i);
+ if (total_count >= VXGE_HW_MAX_POLLING_COUNT)
+ break;
+ }
+}
+
/*
* __vxge_hw_channel_allocate - Allocate memory for channel
* This function allocates required memory for the channel and various arrays
@@ -217,7 +299,7 @@ __vxge_hw_device_register_poll(void __iomem *reg, u64 mask, u32 max_millis)
return ret;
}
- /* __vxge_hw_device_vpath_reset_in_prog_check - Check if vpath reset
+/* __vxge_hw_device_vpath_reset_in_prog_check - Check if vpath reset
* in progress
* This routine checks the vpath reset in progress register is turned zero
*/
@@ -1006,7 +1088,6 @@ exit:
* It can be used to set or reset Pause frame generation or reception
* support of the NIC.
*/
-
enum vxge_hw_status vxge_hw_device_setpause_data(struct __vxge_hw_device *hldev,
u32 port, u32 tx, u32 rx)
{
@@ -1250,7 +1331,6 @@ exit:
/*
* __vxge_hw_ring_create - Create a Ring
* This function creates Ring and initializes it.
- *
*/
enum vxge_hw_status
__vxge_hw_ring_create(struct __vxge_hw_vpath_handle *vp,
diff --git a/drivers/net/vxge/vxge-config.h b/drivers/net/vxge/vxge-config.h
index 66c6773..eaa38e6 100644
--- a/drivers/net/vxge/vxge-config.h
+++ b/drivers/net/vxge/vxge-config.h
@@ -2276,4 +2276,11 @@ enum vxge_hw_status vxge_hw_vpath_rts_rth_set(
enum vxge_hw_status
__vxge_hw_device_is_privilaged(u32 host_type, u32 func_id);
+
+#define VXGE_HW_MIN_SUCCESSIVE_IDLE_COUNT 5
+#define VXGE_HW_MAX_POLLING_COUNT 100
+
+int vxge_hw_vpath_wait_receive_idle(struct __vxge_hw_device *hldev, u32 vp_id);
+
+void vxge_hw_device_wait_receive_idle(struct __vxge_hw_device *hldev);
#endif
diff --git a/drivers/net/vxge/vxge-main.c b/drivers/net/vxge/vxge-main.c
index 8a59fe9..d977a63 100644
--- a/drivers/net/vxge/vxge-main.c
+++ b/drivers/net/vxge/vxge-main.c
@@ -1289,8 +1289,13 @@ void vxge_vpath_intr_enable(struct vxgedev *vdev, int vp_id)
void vxge_vpath_intr_disable(struct vxgedev *vdev, int vp_id)
{
struct vxge_vpath *vpath = &vdev->vpaths[vp_id];
+ struct __vxge_hw_device *hldev;
int msix_id;
+ hldev = (struct __vxge_hw_device *)pci_get_drvdata(vdev->pdev);
+
+ vxge_hw_vpath_wait_receive_idle(hldev, vpath->device_id);
+
vxge_hw_vpath_intr_disable(vpath->handle);
if (vdev->config.intr_type == INTA)
@@ -1420,6 +1425,7 @@ static int do_vxge_reset(struct vxgedev *vdev, int event)
}
if (event == VXGE_LL_FULL_RESET) {
+ vxge_hw_device_wait_receive_idle(vdev->devh);
vxge_hw_device_intr_disable(vdev->devh);
switch (vdev->cric_err_event) {
@@ -2068,7 +2074,7 @@ static irqreturn_t vxge_isr_napi(int irq, void *dev_id)
return IRQ_NONE;
if (unlikely(!is_vxge_card_up(vdev)))
- return IRQ_NONE;
+ return IRQ_HANDLED;
status = vxge_hw_device_begin_irq(hldev, vdev->exec_mode,
&reason);
@@ -2775,7 +2781,6 @@ int do_vxge_close(struct net_device *dev, int do_io)
while (test_and_set_bit(__VXGE_STATE_RESET_CARD, &vdev->state))
msleep(50);
- clear_bit(__VXGE_STATE_CARD_UP, &vdev->state);
if (do_io) {
/* Put the vpath back in normal mode */
vpath_vector = vxge_mBIT(vdev->vpaths[0].device_id);
@@ -2819,6 +2824,11 @@ int do_vxge_close(struct net_device *dev, int do_io)
del_timer_sync(&vdev->vp_reset_timer);
+ if (do_io)
+ vxge_hw_device_wait_receive_idle(hldev);
+
+ clear_bit(__VXGE_STATE_CARD_UP, &vdev->state);
+
/* Disable napi */
if (vdev->config.intr_type != MSI_X)
napi_disable(&vdev->napi);
@@ -2835,8 +2845,6 @@ int do_vxge_close(struct net_device *dev, int do_io)
if (do_io)
vxge_hw_device_intr_disable(vdev->devh);
- mdelay(1000);
-
vxge_rem_isr(vdev);
vxge_napi_del_all(vdev);
diff --git a/drivers/net/vxge/vxge-reg.h b/drivers/net/vxge/vxge-reg.h
index 3dd5c96..93fd752 100644
--- a/drivers/net/vxge/vxge-reg.h
+++ b/drivers/net/vxge/vxge-reg.h
@@ -3998,6 +3998,7 @@ struct vxge_hw_vpath_reg {
#define VXGE_HW_PRC_CFG6_L4_CPC_TRSFR_CODE_EN vxge_mBIT(9)
#define VXGE_HW_PRC_CFG6_RXD_CRXDT(val) vxge_vBIT(val, 23, 9)
#define VXGE_HW_PRC_CFG6_RXD_SPAT(val) vxge_vBIT(val, 36, 9)
+#define VXGE_HW_PRC_CFG6_GET_RXD_SPAT(val) vxge_bVALn(val, 36, 9)
/*0x00a78*/ u64 prc_cfg7;
#define VXGE_HW_PRC_CFG7_SCATTER_MODE(val) vxge_vBIT(val, 6, 2)
#define VXGE_HW_PRC_CFG7_SMART_SCAT_EN vxge_mBIT(11)
--
1.7.0.4
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Powered by blists - more mailing lists