lists.openwall.net   lists  /  announce  owl-users  owl-dev  john-users  john-dev  passwdqc-users  yescrypt  popa3d-users  /  oss-security  kernel-hardening  musl  sabotage  tlsify  passwords  /  crypt-dev  xvendor  /  Bugtraq  Full-Disclosure  linux-kernel  linux-netdev  linux-ext4  linux-hardening  linux-cve-announce  PHC 
Open Source and information security mailing list archives
 
Hash Suite: Windows password security audit tool. GUI, reports in PDF.
[<prev] [next>] [<thread-prev] [day] [month] [year] [list]
Message-ID: <CANEJEGtfQtcsmGkhNBKHV3Uxaxxy3PjjUU7TLnRhh9UsP79cHA@mail.gmail.com>
Date:	Fri, 6 Jan 2012 13:19:30 -0800
From:	Grant Grundler <grundler@...omium.org>
To:	netdev@...r.kernel.org
Cc:	linux-usb@...r.kernel.org
Subject: Re: 3.0.8 kernel : NULL ptr deref in skb_queue_purge()

On Wed, Dec 7, 2011 at 2:40 PM, Grant Grundler <grundler@...omium.org> wrote:
> Hi,
> I'm testing asix (USB 100BT ethernet adapter with AX88772) driver
> initialization (and shut down) paths and reproduced a
> "skb_queue_purge" panic 3 times after a few hundred/thousand
> iterations of rmmod/modprobe. I'm inclined to believe
> skb_queue_purge() is a victim and not a culprit here.

FYI - Follow up:
I'm not able to reproduce this problem in 10000 iterations of
unload/USB off/USB on/load asix cycles. I've closed the original bug
report (http://crosbug.com/17349).

Our kernel moved forward to 3.0.13 since then (was 3.0.8 based) but
I'm skeptical this 'fixed' the problem. So I think there is something
else going on (memory corruption? don't know).

cheers,
grant

>
>  I don't know if all 3 "spontaneous reboots" I've seen have the same
> stack trace as the one I have a record for:
>
> ...
> <6>[57776.637311] asix 1-4:1.0: eth0: link up, 100Mbps, full-duplex, lpa 0xCDE1
> <6>[57777.224552] usbcore: deregistering interface driver asix
> <6>[57777.224859] asix 1-4:1.0: eth0: unregister 'asix'
> usb-0000:00:1d.7-4, ASIX AX88772 USB 2.0 Ethernet
> <1>[57777.224918] BUG: unable to handle kernel NULL pointer
> dereference at 00000002
> <1>[57777.224934] IP: [<00000002>] 0x1
> <5>[57777.224952] *pdpt = 0000000061d70001 *pde = 0000000000000000
> <0>[57777.224967] Oops: 0010 [#1] SMP
> <5>[57777.224980] Modules linked in: asix(-) i2c_dev tsl2583(C)
> industrialio(C) snd_hda_codec_realtek i2c_i801 nm10_gpio snd_hda_intel
> snd_hda_codec snd_hwdep snd_pcm snd_timer snd_page_alloc gobi rtc_cmos
> fuse nf_conntrack_ipv6 nf_defrag_ipv6 ip6table_filter xt_mark ath9k
> ip6_tables mac80211 ath9k_common ath9k_hw ath cfg80211 uvcvideo
> videodev usbnet qcserial usb_wwan [last unloaded: asix]
> <5>[57777.225109]
> <5>[57777.225121] Pid: 30292, comm: rmmod Tainted: G         C  3.0.8
> #2 SAMSUNG ELECTRONICS CO., LTD. Alex/G100
> <5>[57777.225141] EIP: 0060:[<00000002>] EFLAGS: 00010286 CPU: 1
> <5>[57777.225153] EIP is at 0x2
> <5>[57777.225162] EAX: 00000001 EBX: 00000100 ECX: 00000000 EDX: 00000100
> <5>[57777.225172] ESI: f6bad5a8 EDI: f6bad59c EBP: e44e7e20 ESP: e44e7e14
> <5>[57777.225183]  DS: 007b ES: 007b FS: 00d8 GS: 00e0 SS: 0068
> <0>[57777.225194] Process rmmod (pid: 30292, ti=e44e6000 task=f0c2e040
> task.ti=e44e6000)
> <0>[57777.225203] Stack:
> <5>[57777.225209]  f58fdb70 f6bad000 f8c63a34 e44e7e2c 812d2a98
> f6bad480 e44e7e40 f87e820e
> <5>[57777.225242]  e44e7e88 f6bad000 e44e7e88 e44e7e50 812d79cd
> e44e7e88 f6bad000 e44e7e6c
> <5>[57777.225273]  812d7a82 e44e7e58 e44e7e58 e44e7e88 f6bad000
> e44e7e88 e44e7e80 812d7b60
> <0>[57777.225305] Call Trace:
> <5>[57777.225325]  [<812d2a98>] skb_queue_purge+0x19/0x20
> <5>[57777.225345]  [<f87e820e>] usbnet_stop+0xb5/0xf9 [usbnet]
> <5>[57777.225361]  [<812d79cd>] __dev_close_many+0x85/0xa2
> <5>[57777.225375]  [<812d7a82>] dev_close_many+0x61/0xb1
> <5>[57777.225390]  [<812d7b60>] rollback_registered_many+0x8e/0x1ec
> <5>[57777.225405]  [<812d9224>] unregister_netdevice_queue+0x6e/0x9f
> <5>[57777.225419]  [<812d9270>] unregister_netdev+0x1b/0x22
> <5>[57777.225437]  [<f87e76be>] usbnet_disconnect+0x71/0xb9 [usbnet]
> <5>[57777.225454]  [<81273a03>] usb_unbind_interface+0x44/0xf8
> <5>[57777.225471]  [<81237d25>] __device_release_driver+0x80/0xb8
> <5>[57777.225484]  [<812381e2>] driver_detach+0x6c/0x8a
> <5>[57777.225499]  [<81237c41>] bus_remove_driver+0x6e/0x8d
> <5>[57777.225513]  [<81238721>] driver_unregister+0x51/0x58
> <5>[57777.225526]  [<812730c2>] usb_deregister+0x92/0x9f
> <5>[57777.225541]  [<f8c62885>] cleanup_module+0xd/0x788 [asix]
> <5>[57777.225556]  [<810573ed>] sys_delete_module+0x19d/0x1fa
> <5>[57777.225573]  [<8109a059>] ? do_munmap+0x1f2/0x20a
> <5>[57777.225590]  [<8137e677>] sysenter_do_call+0x12/0x26
> <0>[57777.225599] Code:  Bad EIP value.
> <0>[57777.225614] EIP: [<00000002>] 0x2 SS:ESP 0068:e44e7e14
> <0>[57777.225631] CR2: 0000000000000002
> <1>[57777.225035] BUG: unable to handle kernel NULL pointer
> dereference at   (null)
> <1>[57777.225035] IP: [<  (null)>]   (null)
> <5>[57777.225035] *pdpt = 000000006ff81001 *pde = 0000000000000000
> <4>[57777.225684] ---[ end trace
>
>
> On my workstation, I run the following to push/run multiple iterations
> on the target system:
> T=root@....xx.xx.xx
> scp ~/reload_asix $T:/tmp
> for i in `seq 10000`; do printf " %3d: " $i; ssh $T ".
> /tmp/reload_asix" && ssh $T "tail -30 /var/log/messages | fgrep
> leased" ; done | tee reload_asix-loop.out
>
>
> "/tmp/reload_asix" script has the following contents:
> #!/bin/bash -x
>
> # redirect all output to a file. SSH might drop.
> exec > /tmp/`date  --rfc-3339=date`-reload-$$.out 2>&1
>
> date
> rmmod asix
>
> # side effect of auth/deauth is a USB reset on reconnect. :)
> echo 0 > /sys/devices/pci0000:00/0000:00:1d.7/usb1/1-4/authorized
> sleep 1
> echo 1 > /sys/devices/pci0000:00/0000:00:1d.7/usb1/1-4/authorized
> sleep 1
>
> time modprobe asix
>
> for i in `seq 5` ; do
>        l="$(cat /sys/class/net/eth0/speed) $(cat /sys/class/net/eth0/duplex)"
>        printf "%3d: %s %s\n" $i $(cat /sys/class/net/eth0/address) "$l"
>        if [ "$l" = "100 full" ] ; then
>                break
>        fi
>        sleep 1
> done
>
> # at this point we have negotiated link..but not DHCP yet. :/
> return 0
>
>
> Reproduced this panic on two different x86 laptops (Asus AGB and
> Samsung Series 5).
>
> At first glance, this doesn't look like an asix driver bug (though it might be).
> I'm hoping the bug will be obvious to someone who understands usbnet
> and skb_queue calls.
> Open to any debugging advice folks have.
>
> thanks in advance,
> grant
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Powered by blists - more mailing lists

Powered by Openwall GNU/*/Linux Powered by OpenVZ