| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1377259735-20337-5-git-send-email-zonque@gmail.com>
Date: Fri, 23 Aug 2013 14:08:54 +0200
From: Daniel Mack <zonque@...il.com>
To: netdev@...r.kernel.org
Cc: bcousson@...libre.com, nsekhar@...com,
sergei.shtylyov@...entembedded.com, davem@...emloft.net,
ujhelyi.m@...il.com, mugunthanvnm@...com, vaibhav.bedia@...com,
d-gerlach@...com, linux-arm-kernel@...ts.infradead.org,
linux-omap@...r.kernel.org, devicetree@...r.kernel.org,
Daniel Mack <zonque@...il.com>
Subject: [PATCH v3 4/5] net: ethernet: cpsw: add support for hardware interface mode config
The cpsw currently lacks code to properly set up the hardware interface
mode on AM33xx. Other platforms might be equally affected.
Usually, the bootloader will configure the control module register, so
probably that's why such support wasn't needed in the past. In suspend
mode though, this register is modified, and so it needs reprogramming
after resume.
This patch adds code that makes use of the previously added and optional
support for passing the control mode register, and configures the
correct register bits when the slave is opened.
The AM33xx also has a bit for each slave to configure the RMII reference
clock direction. Setting it is now supported by a per-slave DT property.
This code path introducted by this patch is currently exclusive for
am33xx.
Signed-off-by: Daniel Mack <zonque@...il.com>
---
Documentation/devicetree/bindings/net/cpsw.txt | 2 +
drivers/net/ethernet/ti/cpsw.c | 61 ++++++++++++++++++++++++++
drivers/net/ethernet/ti/cpsw.h | 1 +
3 files changed, 64 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/cpsw.txt b/Documentation/devicetree/bindings/net/cpsw.txt
index b717458..0895a51 100644
--- a/Documentation/devicetree/bindings/net/cpsw.txt
+++ b/Documentation/devicetree/bindings/net/cpsw.txt
@@ -34,6 +34,8 @@ Required properties:
- phy_id : Specifies slave phy id
- phy-mode : The interface between the SoC and the PHY (a string
that of_get_phy_mode() can understand)
+- ti,rmii-clock-ext : If present, the driver will configure the RMII
+ interface to external clock usage
- mac-address : Specifies slave MAC address
Optional properties:
diff --git a/drivers/net/ethernet/ti/cpsw.c b/drivers/net/ethernet/ti/cpsw.c
index b194529..b839501 100644
--- a/drivers/net/ethernet/ti/cpsw.c
+++ b/drivers/net/ethernet/ti/cpsw.c
@@ -138,6 +138,13 @@ do { \
#define CPSW_CMINTMAX_INTVL (1000 / CPSW_CMINTMIN_CNT)
#define CPSW_CMINTMIN_INTVL ((1000 / CPSW_CMINTMAX_CNT) + 1)
+#define AM33XX_GMII_SEL_MODE_MII (0)
+#define AM33XX_GMII_SEL_MODE_RMII (1)
+#define AM33XX_GMII_SEL_MODE_RGMII (2)
+
+#define AM33XX_GMII_SEL_RMII2_IO_CLK_EN BIT(7)
+#define AM33XX_GMII_SEL_RMII1_IO_CLK_EN BIT(6)
+
#define cpsw_enable_irq(priv) \
do { \
u32 i; \
@@ -980,6 +987,56 @@ static inline void cpsw_add_dual_emac_def_ale_entries(
priv->host_port, ALE_VLAN, slave->port_vlan);
}
+static void cpsw_set_phy_interface_mode(struct cpsw_slave *slave,
+ struct cpsw_priv *priv)
+{
+ u32 reg, mask, mode = 0;
+
+ switch (priv->data.hw_type) {
+ case CPSW_TYPE_AM33XX:
+ if (!priv->gmii_sel_reg)
+ break;
+
+ reg = readl(priv->gmii_sel_reg);
+
+ if (slave->phy) {
+ switch (slave->phy->interface) {
+ case PHY_INTERFACE_MODE_MII:
+ default:
+ mode = AM33XX_GMII_SEL_MODE_MII;
+ break;
+ case PHY_INTERFACE_MODE_RMII:
+ mode = AM33XX_GMII_SEL_MODE_RMII;
+ break;
+ case PHY_INTERFACE_MODE_RGMII:
+ mode = AM33XX_GMII_SEL_MODE_RGMII;
+ break;
+ };
+ }
+
+ mask = 0x3 << (slave->slave_num * 2) |
+ BIT(slave->slave_num + 6);
+ mode <<= slave->slave_num * 2;
+
+ if (slave->data->rmii_clock_external) {
+ if (slave->slave_num == 0)
+ mode |= AM33XX_GMII_SEL_RMII1_IO_CLK_EN;
+ else
+ mode |= AM33XX_GMII_SEL_RMII2_IO_CLK_EN;
+ }
+
+ reg &= ~mask;
+ reg |= mode;
+
+ writel(reg, priv->gmii_sel_reg);
+ break;
+
+ default:
+ break;
+
+ }
+}
+
static void cpsw_slave_open(struct cpsw_slave *slave, struct cpsw_priv *priv)
{
char name[32];
@@ -1028,6 +1085,8 @@ static void cpsw_slave_open(struct cpsw_slave *slave, struct cpsw_priv *priv)
slave->phy->phy_id);
phy_start(slave->phy);
}
+
+ cpsw_set_phy_interface_mode(slave, priv);
}
static inline void cpsw_add_default_vlan(struct cpsw_priv *priv)
@@ -1823,6 +1882,8 @@ static int cpsw_probe_dt(struct cpsw_platform_data *data,
memcpy(slave_data->mac_addr, mac_addr, ETH_ALEN);
slave_data->phy_if = of_get_phy_mode(slave_node);
+ if (of_find_property(slave_node, "ti,rmii-clock-ext", NULL))
+ slave_data->rmii_clock_external = true;
if (data->dual_emac) {
if (of_property_read_u32(slave_node, "dual_emac_res_vlan",
diff --git a/drivers/net/ethernet/ti/cpsw.h b/drivers/net/ethernet/ti/cpsw.h
index 96c374a..3baa2350 100644
--- a/drivers/net/ethernet/ti/cpsw.h
+++ b/drivers/net/ethernet/ti/cpsw.h
@@ -19,6 +19,7 @@
struct cpsw_slave_data {
char phy_id[MII_BUS_ID_SIZE];
int phy_if;
+ bool rmii_clock_external;
u8 mac_addr[ETH_ALEN];
u16 dual_emac_res_vlan; /* Reserved VLAN for DualEMAC */
};
--
1.8.3.1
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Powered by blists - more mailing lists