| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1421851557-12084-1-git-send-email-ogerlitz@mellanox.com> Date: Wed, 21 Jan 2015 16:45:48 +0200 From: Or Gerlitz <ogerlitz@...lanox.com> To: "David S. Miller" <davem@...emloft.net> Cc: netdev@...r.kernel.org, Matan Barak <matanb@...lanox.com>, Amir Vadai <amirv@...lanox.com>, Tal Alon <talal@...lanox.com>, Roland Dreier <roland@...nel.org>, Or Gerlitz <ogerlitz@...lanox.com> Subject: [PATCH net-next 0/9] mlx4: Fix and enhance the device reset flow Hi Dave, This series from Yishai Hadas fixes the device reset flow and adds SRIOV support. Reset flows are required whenever a device experiences errors, is unresponsive, or is not in a deterministic state. In such cases, the driver is expected to reset the HW and continue operation. When SRIOV is enabled, these requirements apply both to PF and VF devices. Currently, the mlx4 reset flow doesn't work properly: when a fatal error is detected on the FW internal buffer the chip is not reset and stays in its bad state. There are cases that assumed to be fatal such as non-responsive FW, errors via closing commands but are not handled today. The AER mechanism should also be fixed: - It should use mlx4_load_one instead of __mlx4_init_one which is done upon HCA probing. - It must be aligned with concurrent catas flow, mark device to be in an error state, reset chip, etc. - Port types should be restored to their original values before error occurred. In addition, there the SRIOV use-case isn't supported. In above cases when the device state becomes fatal we must act as follows: 1) Reset the chip and mark the HW device state as in fatal error. 2) Wake up any pending commands, preventing new ones to come in. 3) Restart the software stack. We also address the SRIOV mode as follows: In case the PF detects a fatal error, it lets VFs know about that, then both itself and VFs are restarted asynchronously. However, in case only the VF encountered a fatal case or forced to be reset, they reset the VF stuff and then restart software. Yishai, Matan and Or. Yishai Hadas (9): net/mlx4_core: Maintain a persistent memory for mlx4 device net/mlx4_core: Set device configuration data to be persistent across reset net/mlx4_core: Refactor the catas flow to work per device net/mlx4_core: Enhance the catas flow to support device reset net/mlx4_core: Activate reset flow upon fatal command cases net/mlx4_core: Manage interface state for Reset flow cases net/mlx4_core: Handle AER flow properly net/mlx4_core: Enable device recovery flow with SRIOV net/mlx4_core: Reset flow activation upon SRIOV fatal command cases drivers/infiniband/hw/mlx4/alias_GUID.c | 2 +- drivers/infiniband/hw/mlx4/mad.c | 3 +- drivers/infiniband/hw/mlx4/main.c | 17 +- drivers/infiniband/hw/mlx4/mr.c | 6 +- drivers/infiniband/hw/mlx4/sysfs.c | 6 +- drivers/net/ethernet/mellanox/mlx4/alloc.c | 15 +- drivers/net/ethernet/mellanox/mlx4/catas.c | 294 +++++++++++---- drivers/net/ethernet/mellanox/mlx4/cmd.c | 405 +++++++++++++++----- drivers/net/ethernet/mellanox/mlx4/en_cq.c | 4 +- drivers/net/ethernet/mellanox/mlx4/en_ethtool.c | 2 +- drivers/net/ethernet/mellanox/mlx4/en_main.c | 4 +- drivers/net/ethernet/mellanox/mlx4/en_netdev.c | 2 +- drivers/net/ethernet/mellanox/mlx4/en_rx.c | 4 +- drivers/net/ethernet/mellanox/mlx4/en_tx.c | 4 +- drivers/net/ethernet/mellanox/mlx4/eq.c | 52 ++- drivers/net/ethernet/mellanox/mlx4/icm.c | 11 +- drivers/net/ethernet/mellanox/mlx4/intf.c | 8 +- drivers/net/ethernet/mellanox/mlx4/main.c | 387 +++++++++++++++---- drivers/net/ethernet/mellanox/mlx4/mcg.c | 6 + drivers/net/ethernet/mellanox/mlx4/mlx4.h | 27 +- drivers/net/ethernet/mellanox/mlx4/mr.c | 8 +- drivers/net/ethernet/mellanox/mlx4/pd.c | 6 +- drivers/net/ethernet/mellanox/mlx4/port.c | 17 +- drivers/net/ethernet/mellanox/mlx4/reset.c | 23 +- .../net/ethernet/mellanox/mlx4/resource_tracker.c | 36 ++- include/linux/mlx4/cmd.h | 3 + include/linux/mlx4/device.h | 34 ++- 27 files changed, 1042 insertions(+), 344 deletions(-) -- To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majordomo@...r.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
Powered by blists - more mailing lists