[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <20151006230350.GA13024@gwshan>
Date: Wed, 7 Oct 2015 10:03:50 +1100
From: Gavin Shan <gwshan@...ux.vnet.ibm.com>
To: Gavin Shan <gwshan@...ux.vnet.ibm.com>
Cc: netdev@...r.kernel.org, benh@...nel.crashing.org,
davem@...emloft.net
Subject: Re: [PATCH RFC v1 0/7] NCSI Support
On Tue, Oct 06, 2015 at 02:09:42PM +1100, Gavin Shan wrote:
>This patchset is prototype requesting for comments.
>
>This series of patches intends to support NCSI stack, which is specified by
>DSP0222. One NCSI enabled interface potentially connects to multiple packages
>and channels, but there is one active channel at once when hardware arbitration
>is disabled. No hardware arbitration isn't supported by this patchset:
>
> * NIC driver registers NCSI device when the network device is registered. The
> NCSI device should be started when bringing up the interface so that the
> active channel can be choosed from the available channels and starts to provide
> service.
> * When NCSI AEN packet is received from currently active channel for sake of
> failure, another active channel is tried to choosed to accomplish the failover.
> * Reserved netlink interface for NCSI is supported so that userland can retrieve
> NCSI information or configure from/to NCSI channels.
> * The first user of NCSI stack is faraday driver (ftgmac100.c).
>
I received the suggestion to add short description about NCSI and put the link to
the spec after the patches were sent. I'm fixing it as below:
http://www.dmtf.org/sites/default/files/standards/documents/DSP0222_1.0.0.pdf
The NCSI spec (DSP0222) defines the functionality and behavior of the Network Controller
Sideband Interface (NCSI) responsible for connecting the network controller on host side
to the network controller on BMC (Base Management Controller) from below aspects:
* behavior of the interface, which include its operational states as well as the states
of the associated components
* the electrical characteristics of the interface
* the payloads and commands of the communicati on protocol supported over the interface
>Gavin Shan (7):
> net/ncsi: Resource management
> net/ncsi: Packet handler
> net/ncsi: Manage NCSI device
> net/ncsi: Netlink support
> net/faraday: Replace use_nc_si with use_ncsi
> net/faraday: Enable NCSI interface
> net/faraday: Enable offload checksum according to device-tree
>
> drivers/net/ethernet/faraday/ftgmac100.c | 109 ++-
> include/net/ncsi.h | 59 ++
> include/uapi/linux/if_ether.h | 1 +
> include/uapi/linux/ncsi.h | 200 +++++
> include/uapi/linux/netlink.h | 1 +
> net/Kconfig | 1 +
> net/Makefile | 1 +
> net/ncsi/Kconfig | 10 +
> net/ncsi/Makefile | 5 +
> net/ncsi/internal.h | 165 +++++
> net/ncsi/ncsi-aen.c | 197 +++++
> net/ncsi/ncsi-cmd.c | 380 ++++++++++
> net/ncsi/ncsi-manage.c | 914 +++++++++++++++++++++++
> net/ncsi/ncsi-netlink.c | 1042 ++++++++++++++++++++++++++
> net/ncsi/ncsi-pkt.h | 391 ++++++++++
> net/ncsi/ncsi-rsp.c | 1167 ++++++++++++++++++++++++++++++
> net/ncsi/ncsi.c | 49 ++
> 17 files changed, 4661 insertions(+), 31 deletions(-)
> create mode 100644 include/net/ncsi.h
> create mode 100644 include/uapi/linux/ncsi.h
> create mode 100644 net/ncsi/Kconfig
> create mode 100644 net/ncsi/Makefile
> create mode 100644 net/ncsi/internal.h
> create mode 100644 net/ncsi/ncsi-aen.c
> create mode 100644 net/ncsi/ncsi-cmd.c
> create mode 100644 net/ncsi/ncsi-manage.c
> create mode 100644 net/ncsi/ncsi-netlink.c
> create mode 100644 net/ncsi/ncsi-pkt.h
> create mode 100644 net/ncsi/ncsi-rsp.c
> create mode 100644 net/ncsi/ncsi.c
>
Thanks,
Gavin
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Powered by blists - more mailing lists