| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <1455741436-25728-2-git-send-email-andrew@lunn.ch>
Date: Wed, 17 Feb 2016 21:37:15 +0100
From: Andrew Lunn <andrew@...n.ch>
To: Ben Hutchings <ben@...adent.org.uk>
Cc: Florian Fainelli <f.fainelli@...il.com>,
netdev <netdev@...r.kernel.org>, Andrew Lunn <andrew@...n.ch>
Subject: [PATCH 1/2] ethtool-copy.h: sync with net
Additional, add MAX_INT to internal.h, which is now required by
ethtool-copy.h.
Signed-off-by: Andrew Lunn <andrew@...n.ch>
---
ethtool-copy.h | 119 ++++++++++++++++++++++++++++++++++++++++++++++++++++-----
internal.h | 3 ++
2 files changed, 113 insertions(+), 9 deletions(-)
diff --git a/ethtool-copy.h b/ethtool-copy.h
index 57fa390..bce6c95 100644
--- a/ethtool-copy.h
+++ b/ethtool-copy.h
@@ -31,7 +31,7 @@
* physical connectors and other link features that are
* advertised through autonegotiation or enabled for
* auto-detection.
- * @speed: Low bits of the speed
+ * @speed: Low bits of the speed, 1Mb units, 0 to INT_MAX or SPEED_UNKNOWN
* @duplex: Duplex mode; one of %DUPLEX_*
* @port: Physical connector type; one of %PORT_*
* @phy_address: MDIO address of PHY (transceiver); 0 or 255 if not
@@ -47,7 +47,7 @@
* obsoleted by &struct ethtool_coalesce. Read-only; deprecated.
* @maxrxpkt: Historically used to report RX IRQ coalescing; now
* obsoleted by &struct ethtool_coalesce. Read-only; deprecated.
- * @speed_hi: High bits of the speed
+ * @speed_hi: High bits of the speed, 1Mb units, 0 to INT_MAX or SPEED_UNKNOWN
* @eth_tp_mdix: Ethernet twisted-pair MDI(-X) status; one of
* %ETH_TP_MDI_*. If the status is unknown or not applicable, the
* value will be %ETH_TP_MDI_INVALID. Read-only.
@@ -748,6 +748,56 @@ struct ethtool_usrip4_spec {
__u8 proto;
};
+/**
+ * struct ethtool_tcpip6_spec - flow specification for TCP/IPv6 etc.
+ * @ip6src: Source host
+ * @ip6dst: Destination host
+ * @psrc: Source port
+ * @pdst: Destination port
+ * @tclass: Traffic Class
+ *
+ * This can be used to specify a TCP/IPv6, UDP/IPv6 or SCTP/IPv6 flow.
+ */
+struct ethtool_tcpip6_spec {
+ __be32 ip6src[4];
+ __be32 ip6dst[4];
+ __be16 psrc;
+ __be16 pdst;
+ __u8 tclass;
+};
+
+/**
+ * struct ethtool_ah_espip6_spec - flow specification for IPsec/IPv6
+ * @ip6src: Source host
+ * @ip6dst: Destination host
+ * @spi: Security parameters index
+ * @tclass: Traffic Class
+ *
+ * This can be used to specify an IPsec transport or tunnel over IPv6.
+ */
+struct ethtool_ah_espip6_spec {
+ __be32 ip6src[4];
+ __be32 ip6dst[4];
+ __be32 spi;
+ __u8 tclass;
+};
+
+/**
+ * struct ethtool_usrip6_spec - general flow specification for IPv6
+ * @ip6src: Source host
+ * @ip6dst: Destination host
+ * @l4_4_bytes: First 4 bytes of transport (layer 4) header
+ * @tclass: Traffic Class
+ * @l4_proto: Transport protocol number (nexthdr after any Extension Headers)
+ */
+struct ethtool_usrip6_spec {
+ __be32 ip6src[4];
+ __be32 ip6dst[4];
+ __be32 l4_4_bytes;
+ __u8 tclass;
+ __u8 l4_proto;
+};
+
union ethtool_flow_union {
struct ethtool_tcpip4_spec tcp_ip4_spec;
struct ethtool_tcpip4_spec udp_ip4_spec;
@@ -755,6 +805,12 @@ union ethtool_flow_union {
struct ethtool_ah_espip4_spec ah_ip4_spec;
struct ethtool_ah_espip4_spec esp_ip4_spec;
struct ethtool_usrip4_spec usr_ip4_spec;
+ struct ethtool_tcpip6_spec tcp_ip6_spec;
+ struct ethtool_tcpip6_spec udp_ip6_spec;
+ struct ethtool_tcpip6_spec sctp_ip6_spec;
+ struct ethtool_ah_espip6_spec ah_ip6_spec;
+ struct ethtool_ah_espip6_spec esp_ip6_spec;
+ struct ethtool_usrip6_spec usr_ip6_spec;
struct ethhdr ether_spec;
__u8 hdata[52];
};
@@ -1111,6 +1167,31 @@ struct ethtool_ts_info {
__u32 rx_reserved[3];
};
+enum ethtool_phy_pkg_gen_flags {
+ ETH_PKT_RANDOM = (1 << 0),
+ ETH_PKT_ERROR = (1 << 1),
+};
+
+/**
+ * struct ethtool_phy_pkt_get - command to request the phy to generate packets.
+ * @cmd: command number = %ETHTOOL_PHY_PKT_GEN
+ * @count: number of packets to generate
+ * @len: length of generated packets
+ * @ipg: inter packet gap in bytes.
+ * @flags: a bitmask of flags from &enum ethtool_phy_pkg_gen_flags
+ *
+ * PHY drivers may not support all of these parameters. If the
+ * requested parameter value cannot be supported an error should be
+ * returned.
+ */
+struct ethtool_phy_pkt_gen {
+ __u32 cmd;
+ __u32 count;
+ __u32 len;
+ __u32 ipg;
+ __u32 flags;
+};
+
/*
* %ETHTOOL_SFEATURES changes features present in features[].valid to the
* values of corresponding bits in features[].requested. Bits in .requested
@@ -1228,6 +1309,7 @@ enum ethtool_sfeatures_retval_bits {
#define ETHTOOL_GTUNABLE 0x00000048 /* Get tunable configuration */
#define ETHTOOL_STUNABLE 0x00000049 /* Set tunable configuration */
#define ETHTOOL_GPHYSTATS 0x0000004a /* get PHY-specific statistics */
+#define ETHTOOL_PHY_PKT_GEN 0x0000004b /* Gnerate packets in the PHY */
/* compatibility with older code */
#define SPARC_ETH_GSET ETHTOOL_GSET
@@ -1303,7 +1385,7 @@ enum ethtool_sfeatures_retval_bits {
* it was forced up into this mode or autonegotiated.
*/
-/* The forced speed, 10Mb, 100Mb, gigabit, [2.5|5|10|20|25|40|50|56|100]GbE. */
+/* The forced speed, in units of 1Mb. All values 0 to INT_MAX are legal. */
#define SPEED_10 10
#define SPEED_100 100
#define SPEED_1000 1000
@@ -1319,11 +1401,28 @@ enum ethtool_sfeatures_retval_bits {
#define SPEED_UNKNOWN -1
+static inline int ethtool_validate_speed(__u32 speed)
+{
+ return speed <= INT_MAX || speed == SPEED_UNKNOWN;
+}
+
/* Duplex, half or full. */
#define DUPLEX_HALF 0x00
#define DUPLEX_FULL 0x01
#define DUPLEX_UNKNOWN 0xff
+static inline int ethtool_validate_duplex(__u8 duplex)
+{
+ switch (duplex) {
+ case DUPLEX_HALF:
+ case DUPLEX_FULL:
+ case DUPLEX_UNKNOWN:
+ return 1;
+ }
+
+ return 0;
+}
+
/* Which connector port. */
#define PORT_TP 0x00
#define PORT_AUI 0x01
@@ -1367,15 +1466,17 @@ enum ethtool_sfeatures_retval_bits {
#define UDP_V4_FLOW 0x02 /* hash or spec (udp_ip4_spec) */
#define SCTP_V4_FLOW 0x03 /* hash or spec (sctp_ip4_spec) */
#define AH_ESP_V4_FLOW 0x04 /* hash only */
-#define TCP_V6_FLOW 0x05 /* hash only */
-#define UDP_V6_FLOW 0x06 /* hash only */
-#define SCTP_V6_FLOW 0x07 /* hash only */
+#define TCP_V6_FLOW 0x05 /* hash or spec (tcp_ip6_spec; nfc only) */
+#define UDP_V6_FLOW 0x06 /* hash or spec (udp_ip6_spec; nfc only) */
+#define SCTP_V6_FLOW 0x07 /* hash or spec (sctp_ip6_spec; nfc only) */
#define AH_ESP_V6_FLOW 0x08 /* hash only */
#define AH_V4_FLOW 0x09 /* hash or spec (ah_ip4_spec) */
#define ESP_V4_FLOW 0x0a /* hash or spec (esp_ip4_spec) */
-#define AH_V6_FLOW 0x0b /* hash only */
-#define ESP_V6_FLOW 0x0c /* hash only */
-#define IP_USER_FLOW 0x0d /* spec only (usr_ip4_spec) */
+#define AH_V6_FLOW 0x0b /* hash or spec (ah_ip6_spec; nfc only) */
+#define ESP_V6_FLOW 0x0c /* hash or spec (esp_ip6_spec; nfc only) */
+#define IPV4_USER_FLOW 0x0d /* spec only (usr_ip4_spec) */
+#define IP_USER_FLOW IPV4_USER_FLOW
+#define IPV6_USER_FLOW 0x0e /* spec only (usr_ip6_spec; nfc only) */
#define IPV4_FLOW 0x10 /* hash only */
#define IPV6_FLOW 0x11 /* hash only */
#define ETHER_FLOW 0x12 /* spec only (ether_spec) */
diff --git a/internal.h b/internal.h
index b5ef646..ce137fe 100644
--- a/internal.h
+++ b/internal.h
@@ -29,6 +29,9 @@ typedef uint16_t u16;
typedef uint8_t u8;
typedef int32_t s32;
+/* and from <linux/kernel.h> */
+#define INT_MAX ((int)(~0U>>1))
+
#include "ethtool-copy.h"
#include "net_tstamp-copy.h"
--
2.1.4
Powered by blists - more mailing lists