[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-ID: <C3C28FB10418274EB7FD7C2B85C796A44124623F@CHN-SV-EXMX02.mchp-main.com>
Date: Wed, 19 Apr 2017 00:29:45 +0000
From: <David.Cai@...rochip.com>
To: <netdev@...r.kernel.org>, <davem@...emloft.net>
CC: <UNGLinuxDriver@...rochip.com>, <steve.glendinning@...well.net>,
<Ravi.Hegde@...rochip.com>, <Woojung.Huh@...rochip.com>
Subject: [PATCH net-next]smsc911x: Adding support for Micochip LAN9250
Ethernet controller
Attached is a patch which adding support for Microchip LAN9250 Ethernet controller.
Thanks,
=====================
David Cai
Principle Software Engineer
Microchip Technology Inc.
=====================
Signed-off-by: David Cai <david.cai@...rochip.com>
---
drivers/net/ethernet/smsc/smsc911x.c | 32 +++++++++++++++++++++++++++-----
drivers/net/ethernet/smsc/smsc911x.h | 3 +++
2 files changed, 30 insertions(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/smsc/smsc911x.c b/drivers/net/ethernet/smsc/smsc911x.c
index fa5ca09..22b1951 100644
--- a/drivers/net/ethernet/smsc/smsc911x.c
+++ b/drivers/net/ethernet/smsc/smsc911x.c
@@ -25,7 +25,7 @@
* LAN9215, LAN9216, LAN9217, LAN9218
* LAN9210, LAN9211
* LAN9220, LAN9221
- * LAN89218
+ * LAN89218,LAN9250
*
*/
@@ -104,6 +104,9 @@ struct smsc911x_data {
/* used to decide which workarounds apply */
unsigned int generation;
+ /* used to decide which sub generation product work arounds to apply */
+ unsigned int sub_generation;
+
/* device configuration (copied from platform_data during probe) */
struct smsc911x_platform_config config;
@@ -1450,6 +1453,8 @@ static int smsc911x_soft_reset(struct smsc911x_data *pdata)
unsigned int timeout;
unsigned int temp;
int ret;
+ unsigned int reset_offset = HW_CFG;
+ unsigned int reset_mask = HW_CFG_SRST_;
/*
* Make sure to power-up the PHY chip before doing a reset, otherwise
@@ -1476,15 +1481,23 @@ static int smsc911x_soft_reset(struct smsc911x_data *pdata)
}
}
+ if (pdata->sub_generation) {
+ /* special reset for LAN9250 */
+ reset_offset = RESET_CTL;
+ reset_mask = RESET_CTL_DIGITAL_RST_;
+ }
+
/* Reset the LAN911x */
- smsc911x_reg_write(pdata, HW_CFG, HW_CFG_SRST_);
+ smsc911x_reg_write(pdata, reset_offset, reset_mask);
+
+ /* verify reset bit is cleared */
timeout = 10;
do {
udelay(10);
- temp = smsc911x_reg_read(pdata, HW_CFG);
- } while ((--timeout) && (temp & HW_CFG_SRST_));
+ temp = smsc911x_reg_read(pdata, reset_offset);
+ } while ((--timeout) && (temp & reset_mask));
- if (unlikely(temp & HW_CFG_SRST_)) {
+ if (unlikely(temp & reset_mask)) {
SMSC_WARN(pdata, drv, "Failed to complete reset");
return -EIO;
}
@@ -2251,6 +2264,9 @@ static int smsc911x_init(struct net_device *dev)
/* Default generation to zero (all workarounds apply) */
pdata->generation = 0;
+ /* Default sub_generation to zero */
+ pdata->sub_generation = 0;
+
pdata->idrev = smsc911x_reg_read(pdata, ID_REV);
switch (pdata->idrev & 0xFFFF0000) {
case 0x01180000:
@@ -2278,6 +2294,12 @@ static int smsc911x_init(struct net_device *dev)
pdata->generation = 4;
break;
+ case 0x92500000:
+ /* LAN9250 */
+ pdata->generation = 4;
+ pdata->sub_generation = 1;
+ break;
+
default:
SMSC_WARN(pdata, probe, "LAN911x not identified, idrev: 0x%08X",
pdata->idrev);
diff --git a/drivers/net/ethernet/smsc/smsc911x.h b/drivers/net/ethernet/smsc/smsc911x.h
index 54d6489..6b2d479 100644
--- a/drivers/net/ethernet/smsc/smsc911x.h
+++ b/drivers/net/ethernet/smsc/smsc911x.h
@@ -303,6 +303,9 @@
#define E2P_DATA_EEPROM_DATA_ 0x000000FF
#define LAN_REGISTER_EXTENT 0x00000100
+#define RESET_CTL 0x1F8
+#define RESET_CTL_DIGITAL_RST_ 0x00000001
+
/*
* MAC Control and Status Register (Indirect Address)
* Offset (through the MAC_CSR CMD and DATA port)
--
2.7.4
Powered by blists - more mailing lists