lists.openwall.net   lists  /  announce  owl-users  owl-dev  john-users  john-dev  passwdqc-users  yescrypt  popa3d-users  /  oss-security  kernel-hardening  musl  sabotage  tlsify  passwords  /  crypt-dev  xvendor  /  Bugtraq  Full-Disclosure  linux-kernel  linux-netdev  linux-ext4  linux-hardening  linux-cve-announce  PHC 
Open Source and information security mailing list archives
 
Hash Suite: Windows password security audit tool. GUI, reports in PDF.
[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-Id: <20171202220650.23391-2-martin.blumenstingl@googlemail.com>
Date:   Sat,  2 Dec 2017 23:06:48 +0100
From:   Martin Blumenstingl <martin.blumenstingl@...glemail.com>
To:     netdev@...r.kernel.org
Cc:     f.fainelli@...il.com, andrew@...n.ch,
        linux-amlogic@...ts.infradead.org, hkallweit1@...il.com,
        Shengzhou.Liu@...escale.com, jaswinder.singh@...aro.org,
        Martin Blumenstingl <martin.blumenstingl@...glemail.com>
Subject: [RfC net-next 1/3] net: phy: realtek: add support for configuring the RX delay on RTL8211F

On RTL8211F the RX delay can also be enabled/disabled.
The overall behavior of the RX delay is similar to the behavior of the
TX delay, which was already supported by the driver.

The RX delay (similar to the TX delay) may be enabled using hardware pin
strapping. If the MAC already configures the RX delay (if required) then
the RX delay generated by the RTL8211F PHY has to be turned off.

While here, update the comment regarding the TX delay why it has to be
enabled or disabled within the driver.
Also avoid code-duplication by extracting the code to mask/unmask bits
in a paged register into a new rtl8211x_page_mask_bits helper function.

Signed-off-by: Martin Blumenstingl <martin.blumenstingl@...glemail.com>
---
 drivers/net/phy/realtek.c | 55 ++++++++++++++++++++++++++++++++++++++---------
 1 file changed, 45 insertions(+), 10 deletions(-)

diff --git a/drivers/net/phy/realtek.c b/drivers/net/phy/realtek.c
index 5416ec5af042..d4e7f249a4bc 100644
--- a/drivers/net/phy/realtek.c
+++ b/drivers/net/phy/realtek.c
@@ -32,7 +32,10 @@
 
 #define RTL8211F_INSR				0x1d
 
-#define RTL8211F_TX_DELAY			BIT(8)
+#define RTL8211F_RX_DELAY_REG			0x15
+#define RTL8211F_RX_DELAY_EN			BIT(3)
+#define RTL8211F_TX_DELAY_REG			0x11
+#define RTL8211F_TX_DELAY_EN			BIT(8)
 
 #define RTL8201F_ISR				0x1e
 #define RTL8201F_IER				0x13
@@ -74,6 +77,23 @@ static int rtl8211x_page_write(struct phy_device *phydev, u16 page,
 	return ret;
 }
 
+static int rtl8211x_page_mask_bits(struct phy_device *phydev, u16 page,
+				   u16 address, u16 mask, u16 set)
+{
+	int ret;
+	u16 val;
+
+	ret = rtl8211x_page_read(phydev, page, address);
+	if (ret < 0)
+		return ret;
+
+	val = ret & 0xffff;
+	val &= ~mask;
+	val |= (set & mask);
+
+	return rtl8211x_page_write(phydev, page, address, val);
+}
+
 static int rtl8201_ack_interrupt(struct phy_device *phydev)
 {
 	int err;
@@ -160,20 +180,35 @@ static int rtl8211f_config_init(struct phy_device *phydev)
 	if (ret < 0)
 		return ret;
 
-	ret = rtl8211x_page_read(phydev, 0xd08, 0x11);
-	if (ret < 0)
-		return ret;
+	/*
+	 * enable TX-delay for rgmii-id and rgmii-txid, otherwise disable it.
+	 * this is needed because it can be enabled by pin strapping and
+	 * conflict with the TX-delay configured by the MAC.
+	 */
+	if (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
+	    phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID)
+		val = RTL8211F_TX_DELAY_EN;
+	else
+		val = 0;
 
-	val = ret & 0xffff;
+	ret = rtl8211x_page_mask_bits(phydev, 0xd08, RTL8211F_TX_DELAY_REG,
+				      RTL8211F_TX_DELAY_EN, val);
+	if (ret)
+		return ret;
 
-	/* enable TX-delay for rgmii-id and rgmii-txid, otherwise disable it */
+	/*
+	 * enable RX-delay for rgmii-id and rgmii-rxid, otherwise disable it.
+	 * this is needed because it can be enabled by pin strapping and
+	 * conflict with the RX-delay configured by the MAC.
+	 */
 	if (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
-	    phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID)
-		val |= RTL8211F_TX_DELAY;
+	    phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID)
+		val = RTL8211F_RX_DELAY_EN;
 	else
-		val &= ~RTL8211F_TX_DELAY;
+		val = 0;
 
-	ret = rtl8211x_page_write(phydev, 0xd08, 0x11, val);
+	ret = rtl8211x_page_mask_bits(phydev, 0xd08, RTL8211F_RX_DELAY_REG,
+				      RTL8211F_RX_DELAY_EN, val);
 	if (ret)
 		return ret;
 
-- 
2.15.1

Powered by blists - more mailing lists

Powered by Openwall GNU/*/Linux Powered by OpenVZ