[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-Id: <1513869437-20059-1-git-send-email-eswierk@skyportsystems.com>
Date: Thu, 21 Dec 2017 07:17:17 -0800
From: Ed Swierk <eswierk@...portsystems.com>
To: ovs-dev@...nvswitch.org, netdev@...r.kernel.org,
Pravin Shelar <pshelar@...ira.com>
Cc: Ed Swierk <eswierk@...portsystems.com>,
Benjamin Warren <ben@...portsystems.com>,
Keith Holleman <holleman@...portsystems.com>
Subject: [PATCH v2] openvswitch: Trim off padding before L3+ netfilter processing
IPv4 and IPv6 packets may arrive with lower-layer padding that is not
included in the L3 length. For example, a short IPv4 packet may have
up to 6 bytes of padding following the IP payload when received on an
Ethernet device. In the normal IPv4 receive path, ip_rcv() trims the
packet to ip_hdr->tot_len before invoking netfilter hooks (including
conntrack and nat).
In the IPv6 receive path, ip6_rcv() does the same using
ipv6_hdr->payload_len. Similarly in the br_netfilter receive path,
br_validate_ipv4() and br_validate_ipv6() trim the packet to the L3
length before invoking NF_INET_PRE_ROUTING hooks.
In the OVS conntrack receive path, ovs_ct_execute() pulls the skb to
the L3 header but does not trim it to the L3 length before calling
nf_conntrack_in(NF_INET_PRE_ROUTING). When nf_conntrack_proto_tcp
encounters a packet with lower-layer padding, nf_checksum() fails and
logs "nf_ct_tcp: bad TCP checksum". While extra zero bytes don't
affect the checksum, the length in the IP pseudoheader does. That
length is based on skb->len, and without trimming, it doesn't match
the length the sender used when computing the checksum.
The assumption throughout nf_conntrack and nf_nat is that skb->len
reflects the length of the L3 header and payload, so there is no need
to refer back to ip_hdr->tot_len or ipv6_hdr->payload_len.
This change brings OVS into line with other netfilter users, trimming
IPv4 and IPv6 packets prior to L3+ netfilter processing.
Signed-off-by: Ed Swierk <eswierk@...portsystems.com>
---
v2:
- Trim packet in nat receive path as well as conntrack
- Free skb on error
---
net/openvswitch/conntrack.c | 34 ++++++++++++++++++++++++++++++++++
1 file changed, 34 insertions(+)
diff --git a/net/openvswitch/conntrack.c b/net/openvswitch/conntrack.c
index b27c5c6..1bdc78f 100644
--- a/net/openvswitch/conntrack.c
+++ b/net/openvswitch/conntrack.c
@@ -703,6 +703,33 @@ static bool skb_nfct_cached(struct net *net,
return ct_executed;
}
+/* Trim the skb to the L3 length. Assumes the skb is already pulled to
+ * the L3 header. The skb is freed on error.
+ */
+static int skb_trim_l3(struct sk_buff *skb)
+{
+ unsigned int nh_len;
+ int err;
+
+ switch (skb->protocol) {
+ case htons(ETH_P_IP):
+ nh_len = ntohs(ip_hdr(skb)->tot_len);
+ break;
+ case htons(ETH_P_IPV6):
+ nh_len = ntohs(ipv6_hdr(skb)->payload_len)
+ + sizeof(struct ipv6hdr);
+ break;
+ default:
+ nh_len = skb->len;
+ }
+
+ err = pskb_trim_rcsum(skb, nh_len);
+ if (err)
+ kfree_skb(skb);
+
+ return err;
+}
+
#ifdef CONFIG_NF_NAT_NEEDED
/* Modelled after nf_nat_ipv[46]_fn().
* range is only used for new, uninitialized NAT state.
@@ -715,8 +742,12 @@ static int ovs_ct_nat_execute(struct sk_buff *skb, struct nf_conn *ct,
{
int hooknum, nh_off, err = NF_ACCEPT;
+ /* The nat module expects to be working at L3. */
nh_off = skb_network_offset(skb);
skb_pull_rcsum(skb, nh_off);
+ err = skb_trim_l3(skb);
+ if (err)
+ return err;
/* See HOOK2MANIP(). */
if (maniptype == NF_NAT_MANIP_SRC)
@@ -1111,6 +1142,9 @@ int ovs_ct_execute(struct net *net, struct sk_buff *skb,
/* The conntrack module expects to be working at L3. */
nh_ofs = skb_network_offset(skb);
skb_pull_rcsum(skb, nh_ofs);
+ err = skb_trim_l3(skb);
+ if (err)
+ return err;
if (key->ip.frag != OVS_FRAG_TYPE_NONE) {
err = handle_fragments(net, key, info->zone.id, skb);
--
1.9.1
Powered by blists - more mailing lists