netdev - [PATCH net-next v2 0/2] tcp: fix high tail latencies in DCTCP

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [thread-next>] [day] [month] [year] [list]

Message-ID: <20180702213908.1246455-1-brakmo@fb.com>
Date:   Mon, 2 Jul 2018 14:39:06 -0700
From:   Lawrence Brakmo <brakmo@...com>
To:     netdev <netdev@...r.kernel.org>
CC:     Kernel Team <kernel-team@...com>, Blake Matheny <bmatheny@...com>,
        Alexei Starovoitov <ast@...com>,
        Neal Cardwell <ncardwell@...gle.com>,
        Yuchung Cheng <ycheng@...gle.com>,
        Steve Ibanez <sibanez@...nford.edu>,
        Eric Dumazet <eric.dumazet@...il.com>
Subject: [PATCH net-next v2 0/2] tcp: fix high tail latencies in DCTCP

When have observed high tail latencies when using DCTCP for RPCs as
compared to using Cubic. For example, in one setup there are 2 hosts
sending to a 3rd one, with each sender having 3 flows (1 stream,
1 1MB back-to-back RPCs and 1 10KB back-to-back RPCs). The following
table shows the 99% and 99.9% latencies for both Cubic and dctcp:

           Cubic 99%  Cubic 99.9%   dctcp 99%    dctcp 99.9%
 1MB RPCs    2.6ms       5.5ms         43ms          208ms
10KB RPCs    1.1ms       1.3ms         53ms          212ms

Looking at tcpdump traces showed that there are two causes for the
latency.  

  1) RTOs caused by the receiver sending a dup ACK and not ACKing
     the last (and only) packet sent.
  2) Delaying ACKs when the sender has a cwnd of 1, so everything
     pauses for the duration of the delayed ACK.

The first patch fixes the cause of the dup ACKs, not updating DCTCP
state when an ACK that was initially delayed has been sent with a
data packet.

The second patch insures that an ACK is sent immediately when a
CWR marked packet arrives.

With the patches the latencies for DCTCP now look like:

           dctcp 99%  dctcp 99.9%
 1MB RPCs    5.8ms       6.9ms
10KB RPCs    146us       203us

Note that while the 1MB RPCs tail latencies are higher than Cubic's,
the 10KB latencies are much smaller than Cubic's. These patches fix
issues on the receiver, but tcpdump traces indicate there is an
opportunity to also fix an issue at the sender that adds about 3ms
to the tail latencies.

The following trace shows the issue that tiggers an RTO (fixed by these patches):

   Host A sends the last packets of the request
   Host B receives them, and the last packet is marked with congestion (CE)
   Host B sends ACKs for packets not marked with congestion
   Host B sends data packet with reply and ACK for packet marked with
          congestion (TCP flag ECE)
   Host A receives ACKs with no ECE flag
   Host A receives data packet with ACK for the last packet of request
          and which has TCP ECE bit set
   Host A sends 1st data packet of the next request with TCP flag CWR
   Host B receives the packet (as seen in tcpdump at B), no CE flag
   Host B sends a dup ACK that also has the TCP ECE flag
   Host A RTO timer fires!
   Host A to send the next packet
   Host A receives an ACK for everything it has sent (i.e. Host B
          did receive 1st packet of request)
   Host A send more packets…

[PATCH net-next v2 1/2] tcp: notify when a delayed ack is sent
[PATCH net-next v2 2/2] tcp: ack immediately when a cwr packet

 net/ipv4/tcp_input.c  | 16 +++++++++++-----
 net/ipv4/tcp_output.c |  4 ++--
 2 files changed, 13 insertions(+), 7 deletions(-)